Impact of the number of surface-attached tungsten diselenide layers on cadmium sulfide nanorods on the charge transfer and photocatalytic hydrogen evolution rate

A novel tungsten diselenide nanoparticles for enhanced photocatalytic performance of Cr (VI) reduction and ciprofloxacin (CIP)

Nanoparticles (NPs) fabrication is a significant approach to enhance the visible light response of photocatalysts, to realize inexpensive and more harmful compound removal, at larger scale. The poor electrons and holes separation capability and low light activity of bulk materials can be notably enhanced through developing NPs. From photocatalytic investigation, better performance was received in the tungsten diselenide (WSe2) NPs than that in bare WSe2, exhibiting the action of restrained recombination of charge carriers in the NPs. The photocatalytic Cr(VI) reduction efficiency of WSe2 NPs is 2.7 folds greater than that by bare WSe2. On the other hand, the photocatalytic efficiency follows the order of nano WSe2-3 > nano WSe2-2 > nano WSe2-1 > bare WSe2, nano WSe2-3 is nearly 2.7 folds greater than that of bare WSe2. The results imply the fabrication of WSe2 NPs and it possesses improved visible light utilization. The proposed WSe2 NPs have merged with the three aspects of photocatalytic capability including the visible light activity, the valid separation of photo-response charge carriers and enough surface active sites owing to the nanoscale formed. This research endows conduct on the potential style of NPs for photo-response water environmental remediation.

Charge Transfer and Level Lifetime in Molecular Photon-Absorption upon the Quantum Impedance Lorentz Oscillator

On the strength of the new quantum impedance Lorentz oscillator (QILO) model, a charge-transfer method in molecular photon-absorption is proposed and imaged via the numerical simulations of 1- and 2-photon-absorption (1PA and 2PA) behaviors of the organic compounds LB3 and M4 in this paper. According to the frequencies at the peaks and the full width at half-maximums (FWHMs) of the linear absorptive spectra of the two compounds, we first calculate the effective quantum numbers before and after the electronic transitions. Thus, we obtain the molecular average dipole moments, i.e., 1.8728 × 10^-29 C·m (5.6145 D) for LB3 and 1.9626 × 10^-29 C·m (5.8838 D) for M4 in the ground state in the tetrahydrofuran (THF) solvent. Then, the molecular 2PA cross sections corresponding to wavelength are theoretically inferred and figured out by QILO. As a result, the theoretical cross sections turn out to be in good agreement with the experimental ones. Our results reveal such a charge-transfer image in 1PA near wavelength 425 nm, where an atomic electron of LB3 jumps from the ground-state ellipse orbit with the semimajor axis a_i = 1.2492 × 10^-10m = 1.2492 Å and semiminor axis b_i = 0.4363 Å to the excited-state circle (a_j = b_j = 2.5399 Å). In addition, during its 2PA process, the same transitional electron in the ground state is excited to the elliptic orbit with a_j = 2.5399 Å and b_j =1.3808 Å, in which the molecular dipole moment reaches as high as 3.4109 × 10^-29 C·m (10.2256 D). In addition, we obtain a level-lifetime formula with the microparticle collision idea of thermal motion, which indicates that the level lifetime is proportional (not inverse) to the damping coefficient or FWHM of an absorptive spectrum. The lifetimes of the two compounds at some excited states are calculated and presented. This formula may be used as an experimental method to verify 1PA and 2PA transition selection rules. The QILO model exhibits the advantage of simplifying the calculation complexity and reducing the high cost associated with the first principle in dealing with quantum properties of optoelectronic materials.

Heterojunction Design between WSe2 Nanosheets and TiO2 for Efficient Photocatalytic Hydrogen Generation

Design and fabrication of efficient and stable photocatalysts are critically required for practical applications of solar water splitting. Herein, a series of WSe2/TiO2 nanocomposites were constructed through a facile mechanical grinding method, and all of the nanocomposites exhibited boosted photocatalytic hydrogen evolution. It was discovered that the enhanced photocatalytic performance was attributed to the efficient electron transfer from TiO2 to WSe2 and the abundant active sites provided by WSe2 nanosheets. Moreover, the intimate heterojunction between WSe2 nanosheets and TiO2 favors the interfacial charge separation. As a result, a highest hydrogen evolution rate of 2.28 mmol/g·h, 114 times higher than pristine TiO2, was obtained when the weight ratio of WSe2/(WSe2 + TiO2) was adjusted to be 20%. The designed WSe2/TiO2 heterojunctions can be regarded as a promising photocatalysts for high-throughput hydrogen production.