Geochemical conditions influence vanadium, nickel, and molybdenum release from oil sands fluid petroleum coke

The metal release and transformation mechanisms of V-Ti magnetite tailings: Role of the alternate flooding and drying cycles and organic acids

V-Ti magnetite tailings (VTMTs) contain various heavy metals, such as Fe, Mn, V, Co, and Ni. The groundwater pollution caused by the tailing metal release has become a local environmental concern. Although studies have demonstrated the influence of alternate flooding and drying cycles (FDCs) on metal form and mobility in minerals, little was known about whether FDCs affect the metal release of VTMTs and the transformation of released metals. This study investigated the metal release kinetics of VTMTs and the metal transformation under FDCs in the absence and presence of acid rain (sulfuric and nitric acids) and bio-secreted organic acids (acetic, oxalic, and citric acids). The results showed that FDCs promoted metal release whether or not acids were present. The maximum released concentrations of V, Mn, Fe, Co, and Ni were as high as 78.63 mg L-1,1.47 mg L-1, 67.96 μg L-1, 1.34 mg L-1, and 0.80 mg L-1, respectively, under FDCs and citric acids. FDCs enhanced the tailing metal release by increasing the metal labile fraction proportion. However, the concentrations of released Fe, Mn, V, Co, and Ni all gradually decreased due to their (co-)precipitation. These precipitates conversely inhibited the subsequent mineral dissolution by covering the tailing surface. FDCs also enhanced the tailings' porosities by 2.94%-9.94%. The mineral dissolution, expansion and shrinkage, and changes in tension destroyed the tailing microstructure during FDCs. This study demonstrated the low metal pollution risk of VTMTs under FDCs, either in acid rain or bio-secreted organic acids. However, the increase in tailing porosity should be seriously considered as it would affect the tailing pond safety.

Spatial variation and chemical reactivity of dusts from open-pit bitumen mining using trace elements in snow

The chemical reactivity of trace elements (TEs) in dusts from bitumen mining, upgrading and related industrial activities in the Athabasca Bituminous Sands region (ABS), Alberta, Canada, was evaluated using the acid-soluble fraction of snow. Samples were collected at 14 sites along the Athabasca River (AR) and its tributaries, and at 3 remote locations. Following metal-free, ultra-clean procedures for processing and analysis, samples were leached with nitric acid (pH < 1), filtered (<0.45 μm), and analyzed using ICP-MS. Insoluble particles (>0.45 μm) were examined using SEM-EDS. Along the river, acid-soluble concentrations of TEs varied by 6 orders of magnitude, from 1 mg/L (Al) to less than 1 ng/L (Tl). Conservative (Al, Y, La, Th) and mobile (Li, Be, Cs, Sr) lithophile elements, those enriched in bitumen (V, Ni, Mo), and potentially toxic chalcophile elements (As, Cd, Pb, Sb, Tl) showed considerable spatial variation. Normalizing the concentrations of TEs in samples collected near industry to the corresponding concentrations in snow from the reference site (UTK), resulted in enrichments of V and most of the lithophile elements. Dust reactivity, quantified as the ratio of acid-soluble to total concentrations, was less than 50% suggesting limited bioaccessibility. The large differences in behaviour between Cd and Pb versus Ni and V could be due to the occurrence of the former pair in carbonate or sulfide minerals, versus acid-insoluble petcoke particles for the latter couple. Spatial variations in the reactivity of TEs most likely reflect the range in diversity and chemical stability of dust particles, and variations in their abundance in primary source areas. The leaching conditions employed here are extreme (pH < 1) and intended to identify an upper limit of chemical reactivity, with far less dust dissolution expected when these dusts encounter natural waters of the area which range in pH from 4 to 8.