Analysis of factors governing direct electron transfer-type bioelectrocatalysis of bilirubin oxidase at modified electrodes

Enzyme-Modified Microelectrode for Simultaneous Local Measurements of O2 and pH

The use of miniaturized probes opens a new dimension in the analysis of (bio)chemical processes, enabling the possibility to perform measurements with local resolution. In addition, multiparametric measurements are highly valuable for a holistic understanding of the investigated process. Therefore, different strategies have been suggested for simultaneous local measurements of various parameters. Electroanalytical methods are a powerful strategy in this direction. However, they have been mainly restricted to coupling concurrent independent measurements with different miniaturized probes. Here, we present an enzymatic microbiosensor for the simultaneous detection of O2 and pH. The sensing strategy is based on the pH-dependent bioelectrocatalytic process associated with O2 reduction at a gold microelectrode modified with a multicopper oxidase. After initial investigations of the bioelectrocatalytic reaction over gold macroelectrodes, the fabrication and characterization of micrometer-sized probes are presented. The microbioelectrode exhibits a linear current increase with O2 concentration extending to 17.2 mg L-1, with a sensitivity of (5.56 ± 0.13) nA L mg-1 and a limit of detection of (0.5 ± 0.3) mg L-1. Moreover, a linear response allowing pH detection is obtained between pH 5.2 and 7.5 with a slope of -(47 ± 8) mV per pH unit. In addition, two proof-of-concept analytical examples are shown, demonstrating the capability of the developed sensing system for simultaneous local measurements of O2 and pH. Compared with other miniaturized probes reported before for simultaneous detection, our strategy stands out as the two investigated parameters are acquired from the very same measurement. This strategy greatly simplifies the analytical setup and for the first time provides truly simultaneous local detection in the micrometer scale.

Influence of distal glycan mimics on direct electron transfer performance for bilirubin oxidase bioelectrocatalysts

Bilirubin oxidase (BOD) is a bioelectrocatalyst that reduces dioxygen (O₂) to water and is capable of direct electron transfer (DET)-type bioelectrocatalysis via its electrode-active site (T1 Cu). BOD from Myrothecium verrucaria (mBOD) has been widely studied and has strong DET activity. mBOD contains two N-linked glycans (N-glycans) with N472 and N482 binding sites distal to T1 Cu. We previously reported that different N-glycan compositions affect the enzymatic orientation on the electrode by using recombinant BOD expressed in Pichia pastoris and the deglycosylation method. However, the individual function of the two N-glycans and the effects of N-glycan composition (size, structure, and non-reducing termini) on DET-type reactions are still unclear. In this study, we utilize maleimide-functionalized polyethylene glycol (MAL-PEG) as an N-glycan mimic to evaluate the aforementioned effects. Site-specific enzyme-PEG crosslinking was carried out by specific binding of maleimide to Cys residues. Recombinant BOD expressed in Escherichia coli (eBOD), which does not have a glycosylation system, was used as a benchmark to evaluate the effect. Site-directed mutagenesis of Asn residue (N472 or N482) into Cys residue is utilized to realize site-specific glycan mimic modification to the original binding site.

Effects of N-linked glycans of bilirubin oxidase on direct electron transfer-type bioelectrocatalysis

Bilirubin oxidase from Myrothecium verrucaria (mBOD) is a promising enzyme for catalyzing the four-electron reduction of dioxygen into water and realizes direct electron transfer (DET)-type bioelectrocatalysis. It has two N-linked glycans (N-glycans), and N472 and N482 are known as binding sites. Both binding sites located on opposite side of the type I (T1) Cu, which is the electrode-active site of BOD. We investigated the effect of N-glycans on DET-type bioelectrocatalysis by performing electrochemical measurements using electrodes with controlled surface charges. Two types of BODs with different N-glycans, mBOD and recombinant BOD overexpressed in Pichia pastoris (pBOD), and their deglycosylated forms (dg-mBOD and dg-pBOD) were used in this study. Kinetic analysis of the steady-state catalytic waves revealed that both size and composition of N-glycans affected the orientation of adsorbed BODs on the electrodes. Interestingly, the most favorable orientation was achieved with pBOD, which has the largest N-glycans. Furthermore, the effect of the orientation control by the N-glycans is cooperative with electrostatic interaction.

Cyanide sensitivity in direct electron transfer-type bioelectrocatalysis by membrane-bound alcohol dehydrogenase from Gluconobacter oxydans

An overexpression system of membrane-bound alcohol dehydrogenase (ADH) from Gluconobacter oxydans was constructed to examine its bioelectrocatalytic characteristics. The effects of cyanide (CN-) addition on the kinetics of direct electron transfer (DET)-type bioelectrocatalysis by ADH were analyzed. CN- enhanced the bioelectrocatalytic activity, while the catalytic activity in the solution remained unchanged, even in the presence of CN-. Electrochemical methods and electron spin resonance spectroscopy showed the detailed electron transfer pathway in the DET-type bioelectrocatalysis by ADH. Briefly, ADH is suggested to communicate with an electrode via a CN--insensitive and H+-sensitive heme c in DET. These characteristics of ADH with respect to CN- suggest the involvement of ADH in CN--insensitive respiration in G. oxydans.

Direct electron transfer-type bioelectrocatalysis of FAD-dependent glucose dehydrogenase using porous gold electrodes and enzymatically implanted platinum nanoclusters

The direct electron transfer (DET)-type bioelectrocatalysis of flavin adenine dinucleotide (FAD)-dependent glucose dehydrogenase (GDH) from Aspergillus terreus (AtGDH) was carried out using porous gold (Au) electrodes and enzymatically implanted platinum nanoclusters (PtNCs). The porous Au electrodes were prepared by anodization of planar Au electrodes in a phosphate buffer containing glucose as a reductant. Moreover, PtNCs were generated into AtGDH by an enzymatic reduction of hexachloroplatinate (IV) ion. The modification was confirmed by native polyacrylamide gel electrophoresis and sodium dodecyl sulfate polyacrylamide gel electrophoresis analyses. The AtGDH-adsorbed porous Au electrode showed a DET-type bioelectrocatalytic wave both in the presence and absence of PtNCs; however, the current density with PtNCs (~1 mA cm^-2 at 0 V vs. Ag|AgCl|sat. KCl) was considerably higher than that without PtNCs. The kinetic and thermodynamic analysis of the steady-state catalytic wave indicated that inner PtNCs shortened the distance between the catalytic center of AtGDH (=FAD) and the conductive material, and improved the heterogeneous electron transfer kinetics between them.

Nanostructured Porous Electrodes by the Anodization of Gold for an Application as Scaffolds in Direct-electron-transfer-type Bioelectrocatalysis

In this study, nanostructured porous gold electrodes were prepared by the anodization of gold in the presence of oxalic acid or glucose as a reductant, and applied as scaffolds for direct electron transfer (DET)-type bioelectrocatalysis. Gold cations generated in the anodization seem to be reduced by the reductant to construct a porous gold structure. The DET-type performance of the electrode was examined using two DET-type model enzymes, bilirubin oxidase (BOD) and peroxidase (POD), for the four-electron reduction of dioxygen and the two-electron reduction of peroxide, respectively. BOD and POD on the anodized porous gold electrodes exhibited well-defined sigmoidal steady-state waves corresponding to DET-type bioelectrocatalysis. Scanning electron microscopy images revealed sponge-like pores on the electrodes. The anodized porous gold electrodes demonstrate promise as scaffolds for DET-type bioelectrocatalysis.

Switchable aerobic/anaerobic multi-substrate biofuel cell operating on anodic and cathodic enzymatic cascade assemblies

Enzymatic fuel cells may become more accessible for applications powering portable electronic devices by broadening the range of potentially usable fuels and oxidizers. In this work we demonstrate the operation of an integrated, yet versatile multi-substrate biofuel cell utilizing either glucose, fructose, sucrose or combinations of thereof as biofuels, and molecular oxygen originating from solution phase and/or an internal chemical source, as the oxidizer. In order to achieve this goal we designed an enzymatic cascade-functionalized anode consisting of invertase (INV), mutarotase (MUT), glucose oxidase (GOX), and fructose dehydrogenase (FDH), deposited on top of a mesoporous carbon nanoparticle matrix, in which electron relay molecules had been entrapped. The anode was then conjugated to a compatible enzymatic cathode that employs a cascade of catalase (CAT) and bilirubin oxidase (BOD), allowing the cell to operate in an aerobic environment and/or to utilize, under anaerobic conditions for instance, hydrogen peroxide as a source for the oxygen oxidizer. While operated in the presence of the sugar mixture and hydrogen peroxide, the power output of the dually cascaded biofuel cell reaches a peak power density of 0.25 mW cm^-2 and demonstrates an open circuit potential of 0.65 V. To our knowledge this is the first reported biofuel cell that discharges with both anodic and cathodic enzymatic cascade architectures and the first biofuel cell that is repeatedly switched between aerobic and anaerobic conditions without any significant decrease in the discharge performance.