Solvent-free synthesis of sheet-like carbon coated MnO with three-dimensional porous structure for simultaneous detection of dopamine and uric acid

Study on Electrochemical Performance of MnO@rGO/Carbon Fabric-Based Wearable Supercapacitors

In this work, we reported the electrochemical performance of a type of carbon fabric-based supercapacitor by coating MnOx@rGO nanohybrids on carbon fabric with a simple one-step hydrothermal method. We studied the mass ratio of MnOx to rGO on the electrochemical properties of the carbon fabric-based supercapacitors. We found that as the mass ratio is 0.8:1 for MnO@rGO, the supercapacitor with a loading of 5.40 mg cm^-2 of MnO@rGO nanohybrids on carbon fabric exhibits a specific capacitance of 831.25 mF cm^-2 at 0.1 mA cm^-2 current density. It also shows long-term cycling capacitance retention of 97.2% after 10,000 charge-discharge cycles at a current density of 0.4 mA cm^-2. We speculate that the high electrochemical performance results from the strong interfacial bonding between the hierarchical architecture of MnO@rGO nanohybrids and carbon fabric.

Vein-Like Ni-BTC@Ni3S4 with Sulfur Vacancy and Ni3+ Fabricated In Situ Etching Vulcanization Strategy for an Electrochemical Sensor of Dopamine

In this study, a novel Ni-BTC@Ni₃S₄ composite was fabricated by solvothermal reaction using an in situ etching vulcanization strategy and characterized by X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), electron paramagnetic resonance (EPR), and Brunauer-Emmett-Teller (BET) analyses. The existence of a sulfur vacancy and Ni³⁺ in the as-prepared vein-like Ni-BTC@Ni₃S₄ greatly promoted the electrochemical sensing activity of the materials. Herein, a simple electrochemical sensor (Ni-BTC@Ni₃S₄/CPE) has been fabricated and used for the detection of dopamine (DA). The current signal of the Ni-BTC@Ni₃S₄/CPE-modified electrode was linear with the concentration of DA in the range of 0.05-750 μM (R² = 0.9995) with a sensitivity of 560.27 μA·mM^-1·cm^-2 and a detection limit of 0.016 μM. At the same time, the sensor has good stability and anti-interference ability. This study could provide a new idea and strategy for the structural regulation of composite electrode-modified materials and sensitive sensing detection of small biological molecules.

Effect of graphite oxide and exfoliated graphite oxide as a modifier for the voltametric determination of dopamine in presence of uric acid and folic acid

In the present work, exfoliated graphite oxide (E-GO) was prepared by sonicating graphite oxide (GO) (prepared by modified Hummer's and Offemam methods). Prepared GO and E-GO were characterized using infrared absorption spectroscopy, X-ray diffraction, and scanning electron microscopy. The electrocatalytic properties of GO and E-GO towards detection of dopamine (DA), uric acid (UA), and folic acid (FA) were investigated using cyclic voltammetry and differential pulse voltammetry. Our results revealed that E-GO has a slighter advantage over the GO as an electrode modifier for detection DA, UA, and FA, which might be ascribed to the good conductivity of E-GO when compared to the GO.

Platelet-structured strontium titanate perovskite decorated on graphene oxide as a nanocatalyst for electrochemical determination of neurotransmitter dopamine

In this work, we synthesized strontium titanate (SrTiO₃) by a simple co-precipitation technique and decorated it with graphene oxide (SrTiO₃/GO) for the effective determination of neurotransmitter agent dopamine (DA).