Diffusive gradients in thin films (DGT) probe for effectively sampling of per- and polyfluoroalkyl substances in waters and sediments

On-site evaluation of DGT passive sampling for quantitatively measuring per- and polyfluoroalkyl substances in a river-estuary-sea water system

The passive sampling technique of diffusive gradients in thin-films (DGT) is promising for monitoring emerging contaminants such as per- and polyfluoroalkyl substances (PFAS). It is urgent to evaluate the impacts of salinity and exposure time on DGT sampling before it can be set as a standard method. Herein, DGT sampler based on the binding gel of weak anion exchanger (WAX) resin was deployed in a representative water system of the Xiaoqing river-estuary-sea for representative sampling windows (<1 day to 28 days) with high pH (8.18 ± 0.04 to 8.51 ± 0.17) and wide ranges of salinity (0.95 ± 0.07‰ to 14.37 ± 3.92‰), total dissolved solids (1.20 ± 0.09 g/L to 15.29 ± 3.91 g/L) and dissolved organic matter (2.8-32 mg/L). The results showed that the WAX-DGT sampler exhibited good performance for most target PFAS except for short-chain perfluorocarboxylates (C ≤ 5) in 14 days. When the exposure time was over 14 days, biofouling of the sampler may deflect the mass accumulation of the PFAS in the sampler. Salinity played an important role in the mass binding of PFAS by DGT. The shorter the carbon chain of the compound, the greater the influence of the salinity. PFAS with carboxyl groups had greater affinities for the biofouled membrane filter than those with sulfonic groups. In the river-estuary-sea system, where PFAS concentrations changed dynamically, the temporal resolution of the monitoring strategy has been demonstrated to be more important than spatial resolution. DGT provided a better integral of PFAS exposure than grab sampling in the dynamic water system and offered equivalent sensitivity of grab sampling with exposure time <10 d and greater sensitivity with exposure time ≥10 d. Thus, DGT has the advantage of providing high temporal resolution monitoring. This study provided support for the standardization of the DGT technique.

Breaking barriers in passive sampling: The potential of PTFE membranes in the monitoring of hydrophilic micropollutants

Passive samplers are key tools to sample hydrophilic micropollutants in water. Two main approaches address the influence of hydrodynamics: (1) determining site-specific sampling rate (RS) by characterizing kw, the mass transfer coefficient of the water-boundary layer (WBL), and (2) reducing WBL impact using a diffusive material to control the uptake. The first requires calibration data and the second has only been achieved using fragile diffusive material. This study assesses the transfer of hydrophilic contaminants through polytetrafluoroethylene (PTFE; 30 µm thick), a new membrane material with lower sorption than commonly used polyethersulfone (PES). Combined for the first time in a Chemcatcher-like configuration, we calibrated the modified samplers for 44 micropollutants to provide RS - kw relationships for in-situ RS determination (approach 1). Micropollutants accumulated over 2000 times more on the sorbent than on PTFE. PTFE-based RS (0.027 to 0.300 L day-1) were 2.5 higher than previously reported with PES. Membrane property measurements (porosity, tortuosity) indicated that accumulation is primarily controlled by the membrane. Extrapolation indicated that using thicker PTFE membranes (≥ 100 µm) would shift uptake control entirely to the membrane in river conditions (approach 2). This finding could enable RS prediction based on contaminants properties, thus representing a significant advancement in passive sampling.

Intense Turbulent Bursts Promote the Release of Perfluoroalkyl Acids from Sediments at High Flow Velocity

Despite frequent detection of high levels of perfluoroalkyl acids (PFAAs) in sediments, research on the environmental fate of PFAAs in sediments, particularly under hydrodynamic conditions, is rather limited, challenging effective management of PFAA loadings. Therefore, this study investigated the release and transport of 15 PFAAs in sediments under environmentally relevant flow velocities using recirculating flumes and revealed the underlying release mechanisms by identifying related momentum transfer. An increased velocity enhanced the release magnitude of total PFAAs by a factor of 3.09. The release capacity of short-chain PFAAs was notably higher than that of long-chain PFAAs, and this pattern was further amplified by flow velocity. Pore-water drainage was the major pathway for PFAA release, with the release amount predominantly determined by flow velocity-induced release intensity and depth, as well as affected by the perfluorocarbon chain length and sediment size. The weak anion exchanger-diffusion gradients in the thin-film technique confirmed that the release depth of PFAAs increased with flow velocity. Quadrant analysis revealed that the rise in the frequency and intensity of turbulent bursts driven by sweeps and ejections at high flow velocity was the underlying cause of the increased release magnitude and depth of PFAAs.

Development and validation of an in situ high-resolution technique for measuring antibiotics in sediments

Important biogeochemical processes occur in sediments at fine scales. Sampling techniques capable of yielding information with high resolution are therefore needed to investigate chemical distributions and fluxes and to elucidate key processes affecting chemical fates. In this study, a high-resolution diffusive gradients in thin-films (DGT) technique was systematically developed and tested in a controlled sediment system to measure organic contaminants, antibiotics, for the first time. The DGT probe was used to resolve compound distributions at the mm scale. It also reflected the fluxes from the sediment pore-water and remobilization from the solid phase, providing more dynamic information. Through the fine scale detection, a reduction of re-supply was observed over time, which was concentration and location dependent. Compared to the Rhizon sampling method, antibiotic concentrations obtained by DGT probes were less than the pore-water concentrations, as DGT measures the labile fraction of the compounds. The DGT probe was also tested on an intact sediment core sampled from a lake in China and used to measure the distribution of labile antibiotics with depth in the core at the mm scale. ENVIRONMENTAL IMPLICATION: The abuse of antibiotics and widespread of their residues influences the ecosystem, induces the generation of super-bacteria, and finally poses threat to human health. Sediments adsorbs pollutants from the aquatic environment, while may also release them back to the environment. We systematically developed DGT probe approach for measuring antibiotics in sediment in situ in high resolving power, it provides information at fine scale to help us investigate biogeochemical processes take place in sediment and sediment-water interface.

Measurement of perfluoroalkyl substances in drinking water sources by DGT sampler with a novel fluorinated graphite binding gel

Extensive use of per- and polyfluoroalkyl substances (PFASs) has resulted in their widespread presence in natural waters. Concern for public health requires reliable measurement methods for determining their distribution and risks. Here, a sampling method based on diffusive gradients in thin films (DGT) was developed for measuring PFASs in drinking water sources. Fluorinated graphite (FG) particles were used to prepare the DGT binding gel for selective enrichment of trace PFASs in an aqueous environment. The FG-DGT method did not show sensitivity to relevant environmental parameters including pH (5.0-9.0), ionic strength (0.001-0.5 M), or DOM concentration (0-30 mg/L). The FG-DGT had enough capacity for deployment of up to four months. Six traditional and emerging PFASs including PFOS, PFOA, PFHpA, PFHxS, PFNA, and 6:2 FTSA at the ng/L level were detected in two major reservoirs serving as public drinking water sources by FG-DGT method coupled with liquid chromatography tandem mass spectrometry (LC-MS/MS). PFOA appeared at the highest observed concentrations in the drinking water sources. The research demonstrates that FG-DGT is an effective and efficient tool for monitoring PFASs in drinking water.

Analysis of a Passive Sampling Device to Assess the Behavior of Per- and Polyfluoroalkyl Substances in Sediments

Per- and polyfluoroalkyl substances (PFAS) are an emerging class of compounds that cause health and environmental problems worldwide. In aquatic environments, PFAS may bioaccumulate in sediment organisms, which can affect the health of organisms and ecosystems. As such, it is important to develop tools to understand their bioaccumulation potential. In the present study, the uptake of perfluorooctanoic acid (PFOA) and perfluorobutane sulfonic acid (PFBS) from sediments and water was assessed using a modified polar organic chemical integrative sampler (POCIS) as a passive sampler. While POCIS has previously been used to measure time-weighted concentrations of PFAS and other compounds in water, in our study, the design was adapted for analyzing contaminant uptake and porewater concentrations in sediments. The samplers were deployed into seven different tanks containing PFAS-spiked conditions and monitored over 28 days. One tank contained only water with PFOA and PFBS, three tanks contained soil with 4% organic matter, and three tanks contained soil combusted at 550 °C to minimize the influence of labile organic carbon. The uptake of PFAS from the water was consistent with previous research using a sampling rate model or simple linear uptake. For the samplers placed in the sediment, the uptake process was explained well using a mass transport based on the external resistance from the sediment layer. Uptake of PFOS in the samplers occurred faster than that of PFOA and was more rapid in the tanks containing the combusted soil. A small degree of competition was observed between the two compounds for the resin, although these effects are unlikely to be significant at environmentally relevant concentrations. The external mass transport model provides a mechanism to extend the POCIS design for measuring porewater concentrations and sampling releases from sediments. This approach may be useful for environmental regulators and stakeholders involved in PFAS remediation. Environ Toxicol Chem 2023;42:2171-2183. © 2023 SETAC.

In Situ Insight into the Availability and Desorption Kinetics of Per- and Polyfluoroalkyl Substances in Soils with Diffusive Gradients in Thin Films

The physicochemical exchange dynamics between the solid and solution phases of per- and polyfluoroalkyl substances (PFAS) in soils needs to be better understood. This study employed an in situ tool, diffusive gradients in thin films (DGT), to understand the distribution and exchange kinetics of five typical PFAS in four soils. Results show a nonlinear relationship between the PFAS masses in DGT and time, implying that PFAS were partially supplied by the solid phase in all of the soils. A dynamic model DGT-induced fluxes in soils/sediments (DIFS) was used to interpret the results and derive the distribution coefficients for the labile fraction (K_dl), response time (t_c), and adsorption/desorption rates (k₁ and k_-1). The larger labile pool size (indicated by K_dl) for the longer chain PFAS implies their higher potential availability. The shorter chain PFAS tend to have a larger t_c and relatively smaller k_-1, implying that the release of these PFAS in soils might be kinetically limited but not for more hydrophobic compounds, such as perfluorooctanesulfonic acid (PFOS), although soil properties might play an important role. K_dl ultimately controls the PFAS availability in soils, while the PFAS release from soils might be kinetically constrained (which may also hold for biota uptake), particularly for more hydrophilic PFAS.

Appraisal on the role of passive sampling for more integrative frameworks on the environmental risk assessment of contaminants

Over time multiple lines of research have been integrated as important components of evidence for assessing the ecological quality status of water bodies within the framework of Environmental Risk Assessment (ERA) approaches. One of the most used integrative approaches is the triad which combines, based on the weight-of-evidence, three lines of research, the chemical (to identify what is causing the effect), the ecological (to identify the effects at the ecosystem level) and the ecotoxicological (to ascertain the causes of ecological damage), with the agreement between the different lines of risk evidence increasing the confidence in the management decisions. Although the triad approach has proven greatly strategic in ERA processes, new assessment (and monitoring) integrative and effective tools are most welcome. In this regard, the present study is an appraisal on the boost that passive sampling, by allowing to increase information reliability, can give within each of the triad lines of evidence, for more integrative ERA frameworks. In parallel to this appraisal, examples of works that used passive samplers within the triad are presented providing support for the use of these devices in a complementary form to generate holistic information for ERA and ease the process of decision-making.

Performance evaluation of a diffusive hydrogel-based passive sampler for monitoring of polar organic compounds in wastewater

An upscaled passive sampler variant (diffusive hydrogel-based passive sampler; HPS) based on diffusive gradients in thin films for polar organic compounds (o-DGT) with seven times higher surface area (22.7 cm²) than a typical o-DGT sampler (3.14 cm²) was tested in several field studies. HPS performance was tested in situ within a calibration study in the treated effluent of a municipal wastewater treatment plant and in a verification study in the raw municipal wastewater influent. HPS sampled integratively for up to 14 days in the effluent, and 8 days in the influent. Sampling rates (R_s) were derived for 44 pharmaceuticals and personal care products, 3 perfluoroalkyl substances, 2 anticorrosives, and 21 pesticides and metabolites, ranging from 6 to 132 mL d^-1. Robustness and repeatability of HPS deteriorated after exposures longer than 14 days due to microbial and physical damage of the diffusive agarose layer. In situ R_s values for the HPS can be applied to estimate the aqueous concentration of the calibrated polar organic compounds in wastewater within an uncertainty factor of four. When accepting this level of accuracy, the HPS can be applied for monitoring trends of organic micropollutants in wastewater.

Occurrence, source apportionment, and pollution assessment of per- and polyfluoroalkyl substances in a river across rural and urban areas

Forty-three novel and legacy per- and polyfluoroalkyl substances (PFASs) in water and sediments from the Chaobai River (Beijing) were quantified. The total PFASs concentrations varied from 0.04 to 31.3 ng/L in water with significant spatial but insignificant seasonal variations, and changed from 0.03 to 4.29 ng/g in sediment with insignificant spatial but significant seasonal variations. The PFASs concentrations in water from the upstream across the rural area reflected the background level due to the extremely low concentration and very few detected PFASs. The consumer products and metal plating/textile were the predominant pollution sources of PFASs in winter and summer, respectively, for both water and sediment samples. Integrating the determined baseline value, the distribution of PFASs concentrations, and the ecological risks of PFASs, three criteria were proposed, which divide the PFASs concentrations in water into four pollution levels, i.e., insignificant, low, medium, and high. According to the suggested criteria, 96.4% of the PFASs levels in upstream was insignificant pollution, which decreased to 50.4% in downstream and 50.8% in reservoirs. The PFASs in China's and world's surface waters demonstrated similar pollution patterns, with PFOA, PFOS, and PFHxA being the top 3 polluted PFASs. This study makes a small step forward the development of water quality standard for PFASs, which is of great importance for pollution control and risk management of PFASs.