Simultaneous separation of antihyperlipidemic drugs by green ultrahigh-performance liquid chromatography–diode array detector method: Improving the health of liquid chromatography

Eco-Friendly Separation of Antihyperlipidemic Combination Using UHPLC Particle-Packed and Monolithic Columns by Applying Green Analytical Chemistry Principles

Efficient separation of pharmaceuticals and metabolites with the adequate resolution is a key factor in choosing the most suitable chromatographic method. For quality control, the analysis time is a key factor, especially in pharmacokinetic studies. High back pressure is considered as one of the most important factors in chromatography’s flow control, especially in UHPLC. The separation of the anti-hyperlipidemic mixtures was carried out using two columns: a column silica-based particle packed UHPLC and a monolithic column. The systematic suitability of the two columns was compared for the separation of Fenofibrate, its active metabolite, Fenofibric acid and Pravastatin using Atorvastatin as an internal standard. Separation on both columns was obtained using ethanol: buffer potassium dihydrogen orthophosphate pH = 3 (adjusted with orthophosphoric acid) (75:25 v/v) as mobile phase and flow rate 0.8 mL/min. The analytes’ peak detection was achieved by using a PDA detector at 287 nm, 214 nm, 236 nm, and 250 nm for Fenofibrate, Fenofibric acid, Pravastatin, and Atorvastatin, respectively. Reduction of back-pressure was achieved with the monolithic column, where the analytes could be completely separated in less than 1.5 min at a flow rate of 5 mL/min. The principles of Green Analytical Chemistry (GAC) were followed throughout the developed method using environmentally safe solvents.

Analysis of a "3-(Naphthalen-1-ylimino) Indoline-2-one" compound and Its Antimicrobial Assessment Using Lipid-based Self-nanoemulsifying Formulations

In recent years, indole derivatives have acquired conspicuous significance due to their wide spectrum of biological activities—antibacterial, antiviral, and anticonvulsant. This compound is derived from naturally grown plants. Therefore, synthesis of a novel “3-(Naphthalen-1-ylimino)indolin-2-one” compound (2) and its analysis using UPLC systems along with antimicrobial assessment was the aim of the current study. Isatin was used as a parent drug for synthesizing compound (2). Liquid Chromatographic analysis was performed using a C18 BEH column (1.7 μm 2.1 × 50 mm) by UPLC systems. Degradation studies were carried out to see whether acid, base, thermal, and oxidizing agents had any impact on the synthesized molecule in stress conditions (100 °C). A lipid-based self-nanoemulsifying formulation was developed and selectivity, specificity, recovery, accuracy, and precision were measured as part of the UPLC system’s validation process. Antimicrobial studies were conducted using gram-positive and gram-negative bacteria. The standard samples were run with a concentration range of 5.0–100.0 μg/mL using the isocratic mobile phase comprising of methanol/water (70/30 %v/v) at 234 nm; good linearity (R² = 0.9998) was found. The lower limits of detection (LOD) and quantitation (LOQ) of the method were found to be 0.81 μg/mL and 2.5 μg/mL, respectively. The coefficients of variation were found to be less than 2%. The antimicrobial study suggests that compound (2) has a substantial growth effect against gram-negative bacteria. It was successfully synthesized and applied to measure the concentrations in lipid-based dosage form, along with potent antimicrobial activities.

A Sensitive Rapid and Environmentally Friendly UHPLC Assay Method for the Determination of Thymoquinone in Plasma Samples and Its Analytical Application

A precise, swift and environmental-friendly reverse phase ultra-high performance liquid chromatographic assay for the determination of thymoquinone (TQ) in plasma samples using thymol (TM) as an internal standard was developed and validated. The method used a high strength silica C18 1.7 μm column (100 × 2.1 mm) with an isocratic mobile phase consisting of a blend of methanol and 20 mM potassium dihydrogen ortho-phosphate (90:10 v/v; pH of 4.2). The selected eluent provided a short run time (≤2 min), better peak symmetry, lower limit of quantification of 10 ng/mL and satisfactory values of other chromatographic parameters including resolution (Rs = 1), capacity factor (k = 21.5 and 14.5 for TQ and TM, respectively), selectivity (α = 1.482) and number of theoretical plates (N = 1653 and 784 for TQ and TM, respectively). The method was efficiently applied to a pharmacokinetic study of TQ following an intraperitoneal administration of 2 mg/kg in mice. The concentrations of TQ in plasma were measurable up to 12 h with Cmax of 404.08 ± 28.91 ng/mL, T1/2 of 2.31 ± 0.10 h and area under plasma concentration-time curve of 1527.00 ± 46.61 ng/mL × h.

Employing natural reagents from turmeric and lime for acetic acid determination in vinegar sample

A simple, rapid and environmentally friendly sequential injection analysis system employing natural extract reagents was developed for the determination of acetic acid following an acid–base reaction in the presence of an indicator. Powdered lime and turmeric were utilized as the natural base and indicator, respectively. Mixing lime and turmeric produced an orange to reddish-brown color solution which absorbed the maximum wavelength at 455 nm, with absorbance decreasing with increasing acetic acid concentration. Influential parameters including lime and turmeric concentrations, reagent and sample aspirated volumes, mixing coil length and dispensing flow rate were investigated and optimized. A standard calibration graph was plotted for 0–5.0 mmol/L acetic acid with r² = 0.9925. Relative standard deviations (RSD) at 2.0 and 4.0 mmol/L acetic acid were less than 3% (n = 7), with limit of detection (LOD) and limit of quantification (LOQ) at 0.12 and 0.24 mmol/L, respectively. The method was successfully applied to assay acetic acid concentration in cooking vinegar samples. Results achieved were not significantly different from those obtained following a batchwise standard AOAC titration method.

A new strategy for choosing "Q-markers" via network pharmacology, application to the quality control of a Chinese medical preparation

Due to its chemical complexity, proper quality control for a Chinese medical preparation (CMP) has been a great challenge. Choosing the appropriate quality markers (Q-markers) for quality control of CMP is an important work. Best of all, the chosen Q-markers are the main chemical compounds from the herbals as well as the active constituents of this CMP. Only in this way the established quality control system can really achieve the purpose of controlling the quality of CMP and ensuring the safely and effectively use of CMP. To achieve the purpose, network pharmacology combined with the contents of chemical compounds in the CMP has been used in this research. We took an anti-arrhythmic CMP, Shenxian-Shengmai oral liquid (SSOL), as an example. Firstly, UPLC-QTOF-MS/MS method was used to analyze the main components of SSOL. A total of 64 compounds were unambiguously or tentatively identified and 32 of them were further validated by reference compounds. Secondly, the network was constructed based on the identified compounds to predict the effective compounds related to cardiac arrhythmias. Based on the existing database and the operation method of topology, a method of double network analysis (DNAA) was proposed, from which 10 important targets in the pathway of arrhythmia were screened out, and 26 compounds had good antiarrhythmic activity. Based on the prediction results of network pharmacology along with the contents of the compounds in this CMP, ten representative compounds were chosen as the Q-markers for the quality control of SSOL. We find that five of these ten compounds, including danshensu, rosmarinic acid, salvianolic acid A, epimedin A and icariin, have antiarrhythmic activity. Then, the UPLC-DAD method was established as the control method for SSOL.