Ternary multifunctional catalysts of polymeric carbon nitride coupled with Pt-embedded transition metal oxide to enhance light-driven photothermal catalytic degradation of VOCs

Ti3+/Ti4+ and Co2+/Co3+ redox couples in Ce-doped Co-Ce/TiO2 for enhancing photothermocatalytic toluene oxidation

Cerium and cobalt loaded Co-Ce/TiO2 catalyst prepared by impregnation method was investigated for photothermal catalytic toluene oxidation. Based on catalyst characterizations (XPS, EPR and H2-TPR), redox cycle between Co and TiO2 (Co2+ + Ti4+ ↔ Co3+ + Ti3+) results in the formation of Co3+, Ti3+ and oxygen vacancies, which play important roles in toluene catalytic oxidation reaction. The introduction of Ce brings in the dual redox cycles (Co2+ + Ti4+ ↔ Co3+ + Ti3+, Co2+ + Ce4+ ↔ Co3+ + Ce3+), further promoting the elevation of reaction sites amount. Under full spectrum irradiation with light intensity of 580 mW/cm2, Co-Ce/TiO2 catalyst achieved 96% of toluene conversion and 73% of CO2 yield, obviously higher than Co/P25 and Co/TiO2. Co-Ce/TiO2 efficiently maintains 10-hour stability test under water vapor conditions and exhibits better photothermal catalytic performance than counterparts under different wavelengths illumination. Photothermal catalytic reaction displays improved activities compared with thermal catalysis, which is attributed to the promotional effect of light including photocatalysis and light activation of reactive oxygen species.

A review of functions and mechanisms of clay soil conditioners and catalysts in thermal remediation compared to emerging photo-thermal catalysis

High temperatures and providing sufficient time for the thermal desorption of persistent organic pollutants (POPs) from contaminated clay soils can lead to intensive energy consumption. Therefore, this article provides a critical review of the potential additives which can improve soil texture and increase the volatility of POPs, and then discusses their enhanced mechanisms for contributing to a green economy. Ca-based additives have been used to reduce plasticity of bentonite clay, absorb water and replenish system heat. In contrast, non-Ca-based additives have been used to decrease the plasticity of kaolin clay. The soil structure and soil plasticity can be changed through cation exchange and flocculation processes. The transition metal oxides and alkali metal oxides can be applied to catalyze and oxidize polycyclic aromatic hydrocarbons, petroleum and emerging contaminants. In this system, reactive oxygen species (•O2- and •OH) are generated from thermal excitation without strong chemical oxidants. Moreover, multiple active ingredients in recycled solid wastes can be controlled to reduce soil plasticity and enhance thermal catalysis. Alternatively, the alkali, nano zero-valent iron and nano-TiN can catalyze hydrodechlorination of POPs under reductive conditions. Especially, photo and photo-thermal catalysis are discussed to accelerate replacement of fossil fuels by renewable energy in thermal remediation.

Recent advances in oxidative degradation of plastics

Oxidative degradation is a powerful method to degrade plastics into oligomers and small oxidized products. While thermal energy has been conventionally employed as an external stimulus, recent advances in photochemistry have enabled photocatalytic oxidative degradation of polymers under mild conditions. This tutorial review presents an overview of oxidative degradation, from its earliest examples to emerging strategies. This review briefly discusses the motivation and the development of thermal oxidative degradation of polymers with a focus on underlying mechanisms. Then, we will examine modern studies primarily relevant to catalytic thermal oxidative degradation and photocatalytic oxidative degradation. Lastly, we highlight some unique studies using unconventional approaches for oxidative polymer degradation, such as electrochemistry.

Molecular oxygen activation: Innovative techniques for environmental remediation

Molecular oxygen as a green, non-toxic, and inexpensive oxidant has displayed numerous advantages compared with other oxidants for more sustainable and environmentally benign pollutant degradation. Molecular oxygen activation stands as a groundbreaking approach in advanced oxidation processes, offering efficient environmental remediation with minimal environmental impact with the production of high-oxidation reactive oxygen species (ROS). The adaptability and energy efficiency of molecular oxygen activation significantly contribute to the progression of sustainable water remediation technologies. This review meticulously explores the principles and mechanisms of molecular oxygen activation, shedding light on the diverse ROS production pathways. Subsequently, this review comprehensively details contemporary activation approaches, including photocatalytic activation, electrocatalytic activation, piezoelectric activation, and photothermal activation, explicating their distinct activation mechanisms. Additionally, it delves into the promising applications of molecular oxygen activation in the degradation of water pollutants, primary air pollutants, and volatile organic compounds, providing an in-depth analysis of the associated degradation pathways and mechanisms. Moreover, this review also addresses the imminent challenges and emerging opportunities in environmental remediation. It is envisioned that this comprehensive analysis will spur ongoing exploration and innovation in the use of molecular oxygen activation for environmental remediation and beyond.

Interface engineering of Mn3O4/Co3O4 S-scheme heterojunctions to enhance the photothermal catalytic degradation of toluene

Transition metal oxides have high photothermal conversion capacity and excellent thermal catalytic activity, and their photothermal catalytic ability can be further improved by reasonably inducing the photoelectric effect of semiconductors. Herein, Mn₃O₄/Co₃O₄ composites with S-scheme heterojunctions were fabricated for photothermal catalytic degradation of toluene under ultraviolet-visible (UV-Vis) light irradiation. The distinct hetero-interface of Mn₃O₄/Co₃O₄ effectively increases the specific surface area and promotes the formation of oxygen vacancies, thus facilitating the generation of reactive oxygen species and migration of surface lattice oxygen. Theoretical calculations and photoelectrochemical characterization demonstrate the existence of a built-in electric field and energy band bending at the interface of Mn₃O₄/Co₃O₄, which optimizes the photogenerated carriers' transfer path and retains a higher redox potential. Under UV-Vis light irradiation, the rapid transfer of electrons between interfaces promotes the generation of more reactive radicals, and the Mn₃O₄/Co₃O₄ shows a substantial improvement in the removal efficiency of toluene (74.7%) compared to single metal oxides (53.3% and 47.5%). Moreover, the possible photothermal catalytic reaction pathways of toluene over Mn₃O₄/Co₃O₄ were also investigated by in situ DRIFTS. The present work offers valuable guidance toward the design and fabrication of efficient narrow-band semiconductor heterojunction photothermal catalysts and provides deeper insights into the mechanism of photothermal catalytic degradation of toluene.

Combined effects of Pt nanoparticles and oxygen vacancies to promote photothermal catalytic degradation of toluene

Pt/Mn-TiO₂ photothermal catalysts with abundant oxygen vacancies are prepared by loading Pt onto a composite of MnO_x and TiO₂ using MIL-125 as precursor (abbreviated as Mn-TiO₂) and subsequent hydrogen reduction treatment. Under light irradiation with intensity of 625 mW/cm², the optimal 0.65Pt/Mn-TiO₂ catalyst can achieve toluene conversion of 90.4 % and CO₂ yield of 85.6 %, respectively, and maintain stable activity for at least 30 h in the presence of coke and water. The introduction of Pt nanoparticles improves the utilization of solar spectrum and facilitates the generation of more oxygen vacancies. The comparative experiments of photothermal catalysis and thermal catalysis further verify that light not only acts as a heat source but also enhances catalytic reaction through photocatalysis and photoactivation of lattice oxygen. In the follow-up work, catalytic oxidation under natural sunlight is performed on 0.65Pt/Mn-TiO₂ to reach 75.0 % of toluene conversion, displaying a good practical application potential.

Enhanced toluene oxidation by photothermal synergetic catalysis on manganese oxide embedded with Pt single-atoms

The degradation of volatile organic compounds (VOCs) at low temperature remains a big challenge. Photothermal catalysis coupling the advantages of photocatalysis and thermocatalysis is promising to address this issue. However, there is still a long way to construct highly active catalysts and deeply understand the mechanism of photothermal catalysis. Herein, maganese oxide (MnO₂)catalysts embedded with Pt single-atoms (0.11 wt% Pt) have achieved greatly enhanced toluene conversion of 95%, far surpassing most supported Pt photothermal catalysts. The excellent catalytic activity has been disclosed to derive from the synergetic effect oflight-driven thermocatalysis and photocatalysis. The light-driven thermocatalysis predominates and the strong electron transfer from Pt single-atoms to MnO₂ improves the activity of surface lattice oxygen to boost the generation of benzoic acid and the mineralization of toluene. Meanwhile, in photocatalytic process, Pt single-atoms accelerate the generation of superoxide radicals (O₂^-), which facilitate the ring-opening and deep oxidation of toluene. This understanding on the photothermal synergetic mechanism will inspire the design of highly efficient catalysts for VOCs oxidation.

Strong Metal Support Effect of Pt/g-C3N4 Photocatalysts for Boosting Photothermal Synergistic Degradation of Benzene

Catalysis is the most efficient and economical method for treating volatile organic pollutants (VOCs). Among the many materials that are used in engineering, platinized carbon nitride (Pt/g-C₃N₄) is an efficient and multifunctional catalyst which has strong light absorption and mass transfer capabilities, which enable it to be used in photocatalysis, thermal catalysis and photothermal synergistic catalysis for the degradation of benzene. In this work, Pt/g-C₃N₄ was prepared by four precursors for the photothermal synergistic catalytic degradation of benzene, which show different activities, and many tests were carried out to explore the possible reasons for the discrepancy. Among them, the Pt/g-C₃N₄ prepared from dicyanamide showed the highest activity and could convert benzene (300 ppm, 20 mL·min^-1) completely at 162 °C under solar light and 173 °C under visible light. The reaction temperature was reduced by nearly half compared to the traditional thermal catalytic degradation of benzene at about 300 °C.

Unique insights into photocatalytic VOCs oxidation over WO3/carbon dots nanohybrids assisted by water activation and electron transfer at interfaces

Internal electric field (IEF) at heterojunction interfaces can separate photoexcited charge carriers and promote photocatalytic performance. Here we have modified WO₃ nanoplates with carbon dots (CDs) and constructed an interfacial IEF directing from CDs to WO₃ with assistance of their remarkably different work functions. Such electric field drove photoexcited electrons to transport towards CDs and retained photoexcited holes to stay at WO₃, achieving electron/hole spatial separation. H₂O preferred chemisorption on the five-coordinated W atoms of WO₃ with an elongated H-O bond and bent H-O-H angle, which allowed the activation of H₂O and favorable production of ·OH radicals. The WO₃/CDs (WC1) showed a superior photocatalytic activity for visible-light photooxidation of HCHO and CH₃COCH₃ with CO₂ production rate of 411 and 188 μmol g^-1 h^-1, respectively, outperforming most of WO₃-based photocatalysts. The enhanced photocatalytic performance correlated with the IEF-induced charge separation, favorable ·OH production and VOCs chemisorption. Our work confirms the role of CDs cocatalyst in the photocatalytic oxidation of VOCs, which will inspire enthusiasm to develop more advanced heterojunction photocatalysts involving carbon nanomaterials.

Supported Pt-Cu bimetallic catalysts: preparation and synergic effects in their catalytic oxidative degradation of aniline

Catalytic Fenton oxidation is an effective way to remove organic pollutants in water, and the performance of the catalyst is a key issue for the competiveness of this method. In this work, various supported bimetallic Pt–Cu catalysts were prepared by different impregnation methods and their performances for catalytic Fenton oxidation of aniline in water were investigated. In the different impregnation methods employed, factors including the reduction method of the metal precursor, type of catalytic support, and loading of metal were investigated. The effect of different reduction methods on actual loadings of the active components on the supported Pt–Cu catalysts showed the order of (i) H₂ reduction > (ii) liquid phase methanal reduction. Meanwhile, compared with the monometallic catalysts, the Pt–Cu alloy phase (mainly in the form of PtCu₃) was generated and the specific surface area was significantly reduced for the bimetallic catalysts. In the process of Fenton catalytic oxidation of aniline, it was found that most of the prepared catalysts had a certain catalytic activity for H₂O₂ accompanied with aniline degradation. It was found that Pt_0.5Cu_1.5/AC (where AC denotes activated carbon) exhibited superb catalytic activity compared with all other prepared catalysts. In particular, aniline was almost completely mineralized in a neutral solution (500 mg L⁻¹ aniline, 0.098 mol L⁻¹ H₂O₂) after 60 min at 50 °C using Pt–Cu/AC (Pt: 0.5%, Cu: 1.5%). The characterization results showed that the Pt and Cu components were rather evenly distributed on the AC support for this catalyst. More importantly, there was an obvious synergic effect on the supported bimetallic catalyst between the Pt and Cu components for the catalytic oxidation of aniline.

An AC supported Pt–Cu catalyst prepared with a new methanal reduction method was found to be quite effective for catalytic Fenton oxidation of aniline in water. The Pt and Cu components showed a synergic effect for the catalytic process.