Evaluation of solid state form of troglitazone by solid state NMR spectroscopy

Polymorphism and solvatomorphism 2005

Papers and patents that deal with polymorphism (crystal systems for which a substance can exist in structures characterized by different unit cells, but where each of the forms consists of exactly the same elemental composition) and solvatomorphism (systems where the crystal structures of the substance are defined by different unit cells, but where these unit cells differ in their elemental composition through the inclusion of one or molecules of solvent) have been summarized in an annual review. The works cited in this review were published during 2005, and were drawn primarily from the major physical, crystallographic, and pharmaceutical journals. The review is divided into sections that cover articles of general interest, computational and theoretical studies, preparative and isolation methods, structural characterization and properties of polymorphic and solvatomorphic systems, studies of phase transformations, effects associated with secondary processing, and United States patents issued during 2005.

Quantitation of Crystalline Material within a Liquid Vehicle using 1H/19F CP/MAS NMR

A method to detect and quantify a small amount crystalline material within a liquid solution of solubilized material is described. 19F CP-MAS ssNMR was investigated as a technique to detect low levels (0.2 mg/g) of crystalline sodium (2R)-7-{3-[2-chloro-4-(2,2,2-trifluoroethoxy)phenoxy]propoxy}-2-methyl-3,4-dihydro-2H-chromane-2-carboxylate (I) within a solid mixture (with microcrystalline cellulose) and a slurry with a liquid vehicle (capric and caprylic acid triglycerides). The results demonstrate that the area of the 19F CP/MAS signal obtained in 25 min at 25 degrees C is linearly dependent (R2=0.997) on the mass of I within the ssNMR rotor. Slopes of CP-MAS peak area versus mass of I in the rotor were nearly identical for the solid mixture and slurry suspension. Signal-to-noise ratio for the low potency slurry suggest detection and quantitation of 0.1 mg of crystalline I in the rotor, corresponding to 2 mg/g of crystalline material within the slurry suspension.