Facile fabrication of novel ZnO/CoMoO 4 nanocomposites: Highly efficient visible-light-responsive photocatalysts in degradations of different contaminants

The Intrinsic Relationship between Photoluminescence and Photocatalysis of MMoO4/MWO4 (M = Mg, Ca, Sr and Ba) Heterojunctions: Heterojunction Construction, Mechanism Insight and Development Tendency

The migration behavior of electron and hole pairs determines both photoluminescence and photocatalytic activity, which are two distinct properties of semiconductor materials. The photoluminescence and photocatalytic activity of semiconductor materials also exhibit strong method-dependent behavior under the influence of synthesis methods. In this review, the synthesis methods of MMoO4, MWO4 and MMoO4/MWO4 (M = Mg, Ca, Sr and Ba) heterojunction composites and their photoluminescence and photocatalytic activities are reviewed for the first time. The effects of different M ions on the photoluminescence and photocatalytic activity of MMoO4/MWO4 heterojunction composites are also reviewed. There is also a discussion about the intrinsic correlation mechanism between photoluminescence and photocatalytic activity. Different M ions result in different coordination environments in MMoO4/MWO4 heterojunction composites, which leads to different photoluminescence and photocatalytic mechanisms of different MMoO4/MWO4 heterojunction composites. This review provides theoretical reference and technical guidance for future research on MMoO4/MWO4 heterojunction composites.

Preparation of mixed matrix self-cleaning membrane incorporated by Z-scheme heterostructure via robust engineering in terms of dimension for decreasing cake fouling in a cross-flow reactor

Reducing irreversible fouling in polymer membranes by integrating photocatalytic and membrane processes as the self-cleaning photocatalytic membrane is a promising candidate for improving membrane filtration performance. In this study, mixed matrix photocatalytic membranes were prepared from the combination of different morphologies ZnO-g-C3N4 heterostructure in the polymer matrix by the phase-separation method. To investigate the self-cleaning and performance properties of mixed matrix photocatalytic membranes prepared from different morphologies heterostructures, the photocatalytic membrane reactor with a visible-light source was applied. Nanoflower/nanosheet (NF/NS) ZnO-g-C3N4 photocatalytic membrane showed good self-cleaning performance owing to the high photocatalytic performance of NF/NS ZnO-g-C3N4 heterostructure by the reduction of irreversible membrane fouling, thus improving the antifouling and filtration performance of the membrane. Also, the morphology and the uniform distribution of the NF/NS ZnO-g-C3N4 heterostructure in the membrane matrix caused good hydrophilic properties, high porosity, and a more symmetrical structure in the (NF/NS) ZnO-g-C3N4 photocatalytic membrane (F4). For the F4 membrane, the permeability and rejection values increased from 40.35 L m-2 h-1 and 90.9% in the dark environment to 84.37 L m-2 h-1 and 97.4% under visible-light for dye pollutants. Accordingly, F4 had the best filtration and self-cleaning performance, which can be used as a promising visible-light photocatalytic membrane in wastewater treatment processes.

CoMoO4-modified hematite with oxygen vacancies for high-efficiency solar water splitting

Hematite is a potential photoelectrode for photoelectrochemical (PEC) water splitting. Nevertheless, its water oxidation efficiency is highly limited by its significant photogenerated carrier recombination, poor conductivity and slow water oxidation kinetics. Herein, under low-vacuum (LV) conditions, we fabricated a CoMoO₄ layer on oxygen-vacancy-modified hematite (CoMo-Fe₂O₃ (LV)) for the first time for efficient solar water splitting. The existence of oxygen vacancies can significantly facilitate the electrical conductivity, while the large onset potential along with oxygen vacancies can be lowered by the CoMoO₄ with accelerated water oxidation kinetics. Therefore, a high photocurrent density of 3.53 mA cm^-2 at 1.23 V_RHE was obtained for the CoMo-Fe₂O₃ (LV) photoanode. Moreover, it can be further coupled with the FeNiOOH co-catalyst to reach a benchmark photocurrent of 4.18 mA cm^-2 at 1.23 V_RHE, which is increased around 4-fold compared with bare hematite (0.90 mA cm^-2). The combination of CoMoO₄, FeNiOOH, and oxygen vacancies may be used as a reasonable strategy for developing high-efficiency hematite-based photoelectrodes for solar water oxidation.

Recent advances in the removal of emerging contaminants from water by novel molecularly imprinted materials in advanced oxidation processes-A review

Recently, there has been a global focus on effectively treating emerging contaminants (ECs) in water bodies. Advanced oxidation processes (AOPs) are the primary technology used for ECs removal. However, the low concentrations of ECs make it difficult to overcome the interference of background substances in complex water quality, which limits the practical application of AOPs. To address this limitation, many researchers are developing new catalysts with preferential adsorption. Molecular imprinting technology (MIT) combined with conventional catalysts has been found to effectively enhance the selectivity of catalysts for the targeted catalytic degradation of pollutants. This review presents a comprehensive summary of the progress made in research on molecularly imprinted polymers (MIPs) in the selective oxidation of ECs in water. The preparation methods, principles, and control points of novel MIP catalysts are discussed. Furthermore, the performance and mechanism of the catalysts in photocatalytic oxidation, electrocatalytic oxidation, and persulfate activation are analyzed with examples. The possible ecotoxicological risks of MIP catalysts are also discussed. Finally, the challenges and prospects of applying MIP catalysts in AOP are presented along with proposed solutions. This review provides a better understanding of using MIP catalysts in AOPs to target the degradation of ECs.

Renewable and eco-friendly ZnO immobilized onto dead sea sponge floating materials with dual practical aspects for enhanced photocatalysis and disinfection applications

In this study, we have investigated the role of natural dead sea sponge (DSS, Porifera) as a three-dimensional (3D) porous host substrate for the immobilization of nanostructured ZnO material towards the development of ZnO based floating photocatalysts for efficient removal of methylene blue (MB) dye under the illumination of sunlight. After photodegradation, the treated water after dye degradation contains several pathogens, different disinfectants or chemical reagents that are essentially used. This is not the case for DSS as it can naturally kill any pathogens during the wastewater treatment process. To explore these functions, ZnO nanosheets were incorporated onto DSS via hydrothermal protocol and the as prepared ZnO/DSS hybrid material exhibited approximately ∼100% degradation efficiency for the removal of MB. Importantly, the degradation kinetics associated with the fabricated ZnO/DSS was remarkably accelerated as evidenced by the high values of degradation reaction rate constants (3.35 × 10^-2min^-1). The outperformance of ZnO/DSS could be attributed to the adsorption caused by its 3D porous structure together with the high rapid oxidation of MB. Furthermore, the high charge separation of electron-hole pairs, natural porosity, and abundant catalytic sites offered by the hybrid ZnO/DSS floating photocatalyst have enabled quantitative (∼100%) degradation efficiency for MB. Finally, the excellent reusability results confirm the feasibility of using natural ZnO/DSS-based photocatalyst for practical solution of wastewater treatment and other environmental problems.

Preparation of Hierarchical Structure Au/ZnO Composite for Enhanced Photocatalytic Performance: Characterization, Effects of Reaction Parameters, and Oxidizing Agent Investigations

Zinc oxide (ZnO) has been shown as a potential photocatalyst under ultraviolet (UV) light but its catalytic activity has a limitation under visible (Vis) light due to the wide bandgap energy and the rapid recombination of electrons and holes. Thus, hierarchical structure Au/ZnO composites were fabricated by the hydrothermal method and chemical reduction method for enhanced photocatalytic performance under visible light. As-prepared composites were characterized by UV-vis diffuse reflectance spectra (DR/UV-Vis), field emission scanning electron microscope (FESEM), energy-dispersive X-ray spectroscopy (EDS), transmission electron microscopy (TEM), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR), and electron paramagnetic resonance (EPR). The Au/ZnO-5 composite showed the highest adsorption among as-prepared samples in the range of 250-550 nm, having bandgap energy of 0.13 eV. Au nanoparticles of about 3-5 nm were well dispersed on hierarchical flower ZnO with approximately 10-15 μm. The EPR signal at $g=1.965$ on both ZnO and Au/ZnO samples was attributed to oxygen vacancy Vo•, but the presence of Au led to a decrease in signal strength of Au/ZnO composite, showing the degradation efficiency (DE) and reaction rate of 99.2% and 0.109 min-1, respectively; these were larger than those of other samples. The effects of reaction parameters and oxidizing agents on photocatalytic performance were investigated and showed that the presence of H2O2 and O2 could improve the reaction of composite. In addition, the kinetic and photocatalytic mechanism of tartrazine (TA) on catalysts were studied by the first-order kinetic model and characterized analyses.

Low-cost nano-TiO2 composites for remediation of textile dyes: Appraisal on the effect of solar and ultraviolet irradiations

The study evaluates the azo dye degradation potential of nano-TiO₂ ; its composites with low-cost substrates in the form of powder and encapsulated bead for two widely used azo dyes, methyl orange (MO) and congo red (CR) under solar and ultraviolet (UV) irradiation. Degradation potential varied according to the dye concentration, chemistry of dye, light source, and the formulation of the photocatalyst. Both the dyes were completely decolorized at 100 mg/L concentration and to some extent at 1,000 mg/L concentration. The activated charcoal-titanium dioxide (AC-TiO₂ ) nanocomposite in the presence of solar radiations proved to be an economic and efficient substrate for degradation of the test dyes exhibiting combined action of adsorption and photocatalytic phenomena.

Hydrothermal Synthesis of the CuWO4/ZnO Composites with Enhanced Photocatalytic Performance

Photocatalytic technology aiming to eliminate organic pollutants in water has been rapidly developed. In this work, we successfully synthesized CuWO₄/ZnO photocatalysts with different weight ratios of CuWO₄ through facile hydrothermal treatment. Crystal structures, forms, and optical properties of these as-prepared materials were investigated and analyzed. 3% CuWO₄/ZnO showed the optimum photodegradation efficiency toward methylene blue under the irradiation of simulated sunlight for 120 min, the degradation rate of which was 98.9%. The pseudo-first-order rate constant of 3% CuWO₄/ZnO was ∼11.3 and ∼3.5 times bigger than that of pristine CuWO₄ and ZnO, respectively. Furthermore, the material exhibited high stability and reusability after five consecutive photocatalytic tests. In addition, free radical capture experiments were conducted and the possible mechanism proposed explained that the synergistic effect between CuWO₄ and ZnO accelerates the photodegradation reaction. This work provides a feasible technical background for the efficient and sustainable utilization of photocatalysts in wastewater control.

Multi-dimensional zinc oxide (ZnO) nanoarchitectures as efficient photocatalysts: What is the fundamental factor that determines photoactivity in ZnO?

While bulk zinc oxide (ZnO) is of non-toxic in nature, ZnO nanoarchitectures could potentially induce the macroscopic characteristics of oxidative, lethality and toxicity in the water environment. Here we report a systematic study through state-of-the-art controllable synthesis of multi-dimensional ZnO nanoarchitectures (i.e. 0D-nanoparticle, 1D-nanorod, 2D-nanosheet, and 3D-nanoflowers), and subsequent in-depth understanding on the fundamental factor that determines their photoactivities. The photoactivities of resultant ZnO nanoarchitectures were interpreted in terms of the photodegradation of salicylic acid as well as inactivation of Bacillus subtilis and Escherichia coli under UV-A irradiation. Photodegradation results showed that 1D-ZnO nanorods demonstrated the highest salicylic acid photodegradation efficiency (99.4%) with a rate constant of 0.0364 min^-1. 1D-ZnO nanorods also exhibited the highest log reductions of B. subtilis and E. coli of 3.5 and 4.2, respectively. Through physicochemical properties standardisation, an intermittent higher k value for pore diameter (0.00097 min^-1 per mm), the highest k values for crystallite size (0.00171 min^-1 per nm) and specific surface area (0.00339 min^-1 per m²/g) contributed to the exceptional photodegradation performance of nanorods. Whereas, the average normalised log reduction against the physicochemical properties of nanorods (i.e. low crystallite size, high specific surface area and pore diameter) caused the strongest bactericidal effect.

Facile synthesis of Fe2O3 nanoparticles from Egyptian insecticide cans for efficient photocatalytic degradation of methylene blue and crystal violet dyes

In this study, Fe₂O₃ (hematite) nanoparticles with different crystallite sizes (40-59 nm) were synthesized from Egyptian insecticide cans using the combustion method. The organic fuels were urea, glycine, L-alanine, and L-valine. Fe₂O₃ nanoparticles were characterized utilizing different devices such as BET, PL, FT-IR, XRD, HR-TEM, FE-SEM, UV-Vis, and DTG. Crystal violet (CV) and methylene blue (MB) dyes were efficiently removed from aqueous solution by photocatalytic degradation under UV irradiation in the presence of Fe₂O₃ and H₂O₂. The % degradation of 50 mL crystal violet or methylene blue dye (20 mg/L) using 0.1 g Fe₂O₃ in the presence of H₂O₂ was 100% after 30 or 40 min, respectively. Also, the degradation processes are fitted well with the first order model. Besides, the photocatalytic activity of Fe₂O₃ unaltered even after it was reused three times. Hence, the synthesized Fe₂O₃ nanoparticles can be considered a promising and efficient photocatalyst for the degradation of crystal violet and methylene blue dyes.

pH-Controlled photocatalytic abatement of RhB by an FeWO4/BiPO4 p–n heterojunction under visible light irradiation

The novel FeWO₄/BiPO₄ heterojunction generates an inner electric field to promote electron–hole separation efficiency and is a proficient photocatalyst.