Evaluation of platelet activation in patients supported by the Jarvik 2000* high-rotational speed impeller ventricular assist device

Evolutionary Improvements in the Jarvik 2000 Left Ventricular Assist Device

Mechanical circulatory support devices experience a wide range of operating conditions during patient use. Since its first implant in June 2000, the Jarvik 2000 left ventricular assist device has witnessed systematic stepwise modifications to reduce the risk of serious adverse events and improve patient outcomes. Over time, clinical experience revealed a number of low-incidence failure modes that presented opportunities for improvement. Design changes have included, but are not limited to, a Y cable to permit battery changes without pump stoppage, increased pull strength of external cables from 35 to 200 lbs, an intermittent low-speed controller to improve aortic root washout, sintered titanium microsphere surface on the pump housing to prevent apical thrombus, and novel cone bearings to reduce thrombus formation. In summary, real world conditions challenge devices in ways that laboratory or animal experiments do not. Thorough case reviews have led to many improvements as the Jarvik 2000 continues through its second decade of implants.

Antithrombotic Strategies and Device Thrombosis

Despite improvements in left ventricular assist device (LVAD) technology, bleeding and thrombotic complications are major concerns that adversely influence morbidity and mortality. Current antithrombotic therapy recommendations for LVAD thrombosis prophylaxis are largely derived from clinical device trials that implement a one-size-fits-all strategy. Objective serial laboratory-based assessment of thrombogenicity is needed to balance the risk of bleeding and thrombotic complications. Finally, the newest-generation device, the HeartMate 3, has been associated with lower levels of shear and reduced hemolysis that may mitigate thrombotic event occurrences.

Bleeding and thrombosis in chronic ventricular assist device therapy: focus on platelets

PURPOSE OF REVIEW

Left ventricular assist devices (LVADs) have markedly improved the survival for patients with advanced heart failure but are plagued with significant morbidity, including pump thrombosis and bleeding. Better understanding of the platelet, and its role in the balance of bleeding and thrombosis, stands to impact the frequency and treatment of these significant complications.

RECENT FINDINGS

In patients with LVADs, there is little consistency linking traditional biomarkers of platelet activation and clinical events. A number of innovative methods of assessing platelet functionality, including shedding of platelet receptors and formation of microparticle complexes as well as measuring mitochondrial membrane potentials, exist and appear to be clinically relevant. Acquired von Willebrand syndrome, while not explaining all bleeding events, is a central feature of mechanical support and offers a target for innovative therapies.

SUMMARY

Although the platelet is only one component of impacting thrombosis and bleeding in patients supported with LVADs, it plays a central role in mediating these two opposing forces. Innovations in understanding platelet physiology as well as manipulating genomic and receptor interactions for an individual patient will be critical if we are to decrease these serious adverse events in the future.

Microfluidic approaches for the assessment of blood cell trauma: a focus on thrombotic risk in mechanical circulatory support devices

INTRODUCTION

Mechanical circulatory support devices (MCSDs) are emerging as a valuable therapeutic option for the management of end-stage heart failure. However, although recipients are routinely administered with anti-thrombotic (AT) drugs, thrombosis persists as a severe post-implant complication. Conventional clinical assays and coagulation markers demonstrate partial ability in preventing the onset of thrombosis. Through years, different laboratory techniques have been proposed as potential tools for the evaluation of platelets' hemostatic response in MCSD recipients. Most rely on platelet aggregation tests; they are performed in static or low shear conditions, neglecting the prominent contribution of MCSD shear-induced mechanical load in enhancing platelet activation (PA). On the other hand, those tests able to account for shear-induced PA have limited possibility of effective clinical translation.

AIMS AND METHODS

Advances on this side have been addressed by microfluidic technology. Microfluidic devices have been developed for AT drug monitoring under flow, able to replicate physiological and/or constant shear flow conditions in vitro. In this paper, we present a newly developed microfluidic platform able to expose platelets to MCSD-specific dynamic shear stress patterns. We performed in vitro tests circulating human platelets in the microfluidic platform and quantifying the dynamics of PA by means of the Platelet Activity State (PAS) assay.

RESULTS

Our results prove the feasibility of using microfluidics for the diagnosis of MCSD-related thrombotic risk. This study paves the way for the development of a miniaturized point-of-care device for monitoring AT drug regimen. Such a system may have significant impact on limiting the incidence of thrombosis in MCSD recipients.

Comparative efficacy of in vitro and in vivo metabolized aspirin in the DeBakey ventricular assist device

Ventricular assist devices (VADs) are implanted in patients with end-stage heart failure to provide both short- and long-term hemodynamic support. Unfortunately, bleeding and thromboembolic complications due to the severely disturbed, dynamic flow conditions generated within these devices require complex, long-term antiplatelet and anticoagulant therapy. While several studies have examined the effectiveness of one such agent, aspirin, under flow conditions, data comparing the efficacy of in vitro and in vivo metabolized aspirin is lacking. Two sets of studies were conducted in vitro with purified human platelets circulating for 30 min in a flow loop containing the DeBakey VAD (MicroMed Cardiovascular, Houston, TX, USA): (a) 20 μM aspirin was added exogenously in vitro to platelets isolated from aspirin-free subjects, and (b) platelets were obtained from donors 2 h (n = 14) and 20 h (n = 13) after ingestion of 1,000 mg aspirin. Near real-time platelet activation state (PAS) was measured with a modified prothrombinase-based assay. Platelets exposed to aspirin in vitro and in vivo (metabolized) showed 28.2 and 25.3 % reduction in platelet activation rate, respectively, compared to untreated controls. Our results demonstrate that in vitro treatment with antiplatelet drugs such as aspirin is as effective as in vivo metabolized aspirin in testing the effect of reducing shear-induced platelet activation in the VAD. Using the PAS assay provides a practical in vitro alternative to in vivo testing of antiplatelet efficacy, as well as for testing the thrombogenic performance of devices during their research and development.

A quantitative comparison of mechanical blood damage parameters in rotary ventricular assist devices: shear stress, exposure time and hemolysis index

Ventricular assist devices (VADs) have already helped many patients with heart failure but have the potential to assist more patients if current problems with blood damage (hemolysis, platelet activation, thrombosis and emboli, and destruction of the von Willebrand factor (vWf)) can be eliminated. A step towards this goal is better understanding of the relationships between shear stress, exposure time, and blood damage and, from there, the development of numerical models for the different types of blood damage to enable the design of improved VADs. In this study, computational fluid dynamics (CFD) was used to calculate the hemodynamics in three clinical VADs and two investigational VADs and the shear stress, residence time, and hemolysis were investigated. A new scalar transport model for hemolysis was developed. The results were compared with in vitro measurements of the pressure head in each VAD and the hemolysis index in two VADs. A comparative analysis of the blood damage related fluid dynamic parameters and hemolysis index was performed among the VADs. Compared to the centrifugal VADs, the axial VADs had: higher mean scalar shear stress (sss); a wider range of sss, with larger maxima and larger percentage volumes at both low and high sss; and longer residence times at very high sss. The hemolysis predictions were in agreement with the experiments and showed that the axial VADs had a higher hemolysis index. The increased hemolysis in axial VADs compared to centrifugal VADs is a direct result of their higher shear stresses and longer residence times. Since platelet activation and destruction of the vWf also require high shear stresses, the flow conditions inside axial VADs are likely to result in more of these types of blood damage compared with centrifugal VADs.

Platelet activation in heart failure patients supported by the HeartMate II ventricular assist device

OBJECTIVE

Thromboembolic events have been observed in heart failure (HF) patients supported by long-term mechanical circulatory support (MCS) devices. It has been hypothesized that these adverse events may be the result of platelet activation associated with high rotational speeds common to axial flow pumps. In this study, markers of platelet activation were investigated in HF patients supported by a HeartMate II left ventricular assist device (LVAD).

METHODS

The study group consisted of 34 HF patients supported by a HeartMate II axial flow LVAD implanted for destination therapy (DT). This patient population was 94% male (31 M, 3 F), supported by LVAD for 30 to 723 days (average 268 days), and with an anticoagulation regimen of Coumadin (0-8 mg daily dose) and aspirin (0-325 mg daily dose). Platelet adhesion markers (soluble P-selectin and solube CD40 ligand), platelet count (PC), hematocrit (Hct), and creatinine (Cr) were measured.

RESULTS

The soluble P-selectin marker was within normal platelet activity limits for all end points. The soluble CD40 ligand marker indicated platelet inactivity for all end points. Despite high shear stresses associated with a high-speed axial flow pump, the HeartMate II had no discernable effect on platelet activation. Current clinical doses of aspirin also appear to have little effect on platelet activation. Platelet count, hematocrit, and creatinine were normal in these patients over duration of support.

CONCLUSIONS

There were no discernable changes in platelet activation markers soluble P-selectin and soluble CD40 ligand in HF patients support by HeartMate II LVAD independently of length of support, anti-platelet, and anti-coagulation regimens.