A comparison of different concentration methods for the detection of viruses present in bottled waters and those adsorbed to water bottle surfaces

Evaluation of three different filters and two methods for recovering viruses from drinking water

Among the enteric viruses implicated in waterborne outbreaks, human norovirus and hepatitis A virus (HAV) are a serious public health issue. Most foodborne viruses are difficult or currently unlikely to cultivate. Because of the lack of a cell culture method, real-time reverse transcriptase PCR is commonly used for the detection of norovirus in foodstuffs and environmental samples. Due to low infectious doses in humans and low virus concentration in water sample, filter adsorption methods were used for concentrating viruses from water. The ISO (Anonymous, ISO 15216-1, 2017) describes standardized molecular methods for detecting HAV and norovirus in bottled water. This method includes a two-step procedure: concentrating the virus using a microporous electropositive filter (47 mm diameter, 0.45 μm pore size) then molecular detection. The Zetapor filter, which had a charged membrane with a pore size of 0.45 μm, was commonly used in the past to concentrate viruses from water or from salad leaves following virus elution. But, unfortunately, the Zetapor filter is no longer marketed and it is therefore necessary to assess an alternative filter. The aim of this study was to compare the ability of two electropositive filters with a pore size of 0.45 μm or 0.22 μm and one uncharged filter (0.45 μm) to recover norovirus and HAV from two different types of drinking water (bottled water and tap water) with the adsorption-elution method proposed by ISO (Anonymous, ISO 15216-1, 2017) (method A) and with direct viral extraction using filters (method B). The mean extraction yields for norovirus and HAV calculated with RNA extracts ranged from 0.2 % - 4.81 % with method A and from 5.05 % - 53.58 % with method B, and did not differ significantly between the two types of drinking water tested. For method B, the mean extraction yields for HAV and norovirus were evaluated according to results from the three filters used. The recovery rate of HAV and norovirus ranged between 3.47 % and 62.41 % with the 0.45 μm electropositive filter and were higher than the other filters. The 0.45 μm electropositive filter could be used to concentrate viruses for routine viral monitoring of drinking water for researchers who want to adopt the method in their lab routine.

Concentration of MS2 phage in river water by a combined ferric colloid adsorption and foam separation-based method, with MS2 phage leaching from ferric colloid

The concentration of MS2 phage as a model RNA virus in river water using a combined ferric colloid adsorption and foam separation-based method was examined. The MS2 phage concentrations were determined by the plaque-forming unit (PFU) method and reverse transcription quantitative PCR (RT-qPCR) analysis. When ferric colloid adsorption was performed prior to foam separation, MS2 phage was effectively removed from river water and concentrated in the generated foam within 7 min. The removal efficiency was >99% at the optimum iron and casein concentrations of 5 mg-Fe/L and 10 mg/L, respectively. Furthermore, based on the analysis of the collected ferric colloid dissolved using deferoxamine, the MS2 concentration in the colloid-dissolved solution was 190-fold higher than that found in raw water according to RT-qPCR analysis. This is a novel method for concentrating RNA viruses to facilitate their detection in river water using coagulation and foam separation combined with chelate dissolution of ferric flocs.

Development of a virus concentration method using lanthanum-based chemical flocculation coupled with modified membrane filtration procedures

Direct membrane filtration is often used to concentrate viruses in water but it may suffer from severe membrane fouling and clogging. Here, a lanthanum-based flocculation method coupled with modified membrane filtration procedures was developed and evaluated to detect viruses in large volume (40 L) water samples. The lanthanum-based flocculation method could easily reduce the water sample volume by a factor of 40. Additional volume reduction was achieved by a two-step membrane filtration approach. First, selected membrane filters (including 1MDS electropositive filters and nitrocellulose electronegative filters-Millipore HATF filters) were used to reduce water sample volume further and compare their efficiencies in virus recovery. The Mg²⁺-modified HATF membrane performed better on MS2 retention with an average virus recovery of 83.4% (±4.5% [standard deviation]). After HATF membrane filtration and elution, centrifugal ultrafiltration through a 30 kDa cut-off membrane resulted in an overall concentration factor of 20,000. Results from the infectivity assay showed that the MS2 recovery efficiencies from the NanoCeram- and 1MDS-based direct filtration and the lanthanum-based concentration coupled with the modified filtration procedure were 10.1% (±1.0%), 3.3% (±0.1%), and 17.5% (±1.1%), respectively. Results from the PCR analysis showed that the virus recoveries of the lanthanum-based method were 20.6% (±2.9%) and 19.5% (±3.4%) for MS2 and adenovirus, respectively, while no adenovirus could be detected through the NanoCeram- and 1MDS-based direct filtration. The lanthanum-based concentration method coupled with modified membrane filtration procedures is therefore a promising method for detecting waterborne viruses.

The role of surface functionalization of colloidal alumina particles on their controlled interactions with viruses

Materials that interact in a controlled manner with viruses attract increasing interest in biotechnology, medicine, and environmental technology. Here, we show that virus-material interactions can be guided by intrinsic material surface chemistries, introduced by tailored surface functionalizations. For this purpose, colloidal alumina particles are surface functionalized with amino, carboxyl, phosphate, chloropropyl, and sulfonate groups in different surface concentrations and characterized in terms of elemental composition, electrokinetic, hydrophobic properties, and morphology. The interaction of the functionalized particles with hepatitis A virus and phages MS2 and PhiX174 is assessed by virus titer reduction after incubation with particles, activity of viruses conjugated to particles, and imaged by electron microscopy. Type and surface density of particle functional groups control the virus titer reduction between 0 and 99.999% (5 log values). For instance, high sulfonate surface concentrations (4.7 groups/nm(2)) inhibit attractive virus-material interactions and lead to complete virus recovery. Low sulfonate surface concentrations (1.2 groups/nm(2)), native alumina, and chloropropyl-functionalized particles induce strong virus-particle adsorption. The virus conformation and capsid amino acid composition further influence the virus-material interaction. Fundamental interrelations between material properties, virus properties, and the complex virus-material interaction are discussed and a versatile pool of surface functionalization strategies controlling virus-material interactions is presented.