Facile hydrothermal preparation of a ZnFe2O4/TiO2 heterojunction for NOx removal

Hydrothermal synthesis of Zingiber/ZnO for enhanced photodegradation of ofloxacin antibiotic and reactive red azo dye (RR141)

The examination of photocatalyst powders for the total removal of pollutants from aqueous solutions is a vital research subject within the realm of environmental preservation. The objective of this study is to develop a photocatalyst heterojunction consisting of Zingiber/ZnO-H for the degradation of both the reactive red dye (RR 141) and ofloxacin antibiotic in wastewater. The current investigation outlines the process of synthesising a composite material by combining Zingiber montanum extract with zinc oxide (ZnO) by a hydrothermal method. The synthesis was conducted at a temperature of 180°C for a period of 4 hours. Consequently. The photocatalyst with a constructed heterojunction shown a notable enhancement in its photocatalytic activity as a result of the improved efficiency in charge separation at the interface. The application of economically viable solar energy facilitated the complete eradication of harmful pollutants through the process of detoxification. The removal of impurities occurs by a process that follows a first-order kinetics. Among the pollutants, RR141 demonstrates the greatest rate constant at 0.02 min-1, while ofloxacin has a rate constant of 0.01 min-1. The assessment of the stability of the produced photocatalyst was conducted after undergoing five cycles. This study additionally investigated the influence of sunshine on degradation, uncovering degradation rates of 97% for RR141 and 99% for ofloxacin when exposed to UV Lamp, and degradation rates of 97% for RR141 and 95% for ofloxacin when exposed to Solar Light.

One Step Synthesis of Oxygen Defective Bi@Ba2TiO4/BaBi4Ti4O15 Microsheet with Efficient Photocatalytic Activity for NO Removal

Photocatalysis is an effective technology for NO removal even at low concentrations in the ambient atmosphere. However, the low efficiency of this advanced process and the tendency of producing toxic byproducts hinder the practical application of photocatalysis. To overcome these problems, the Bi@Ba2TiO4/BaBi4Ti4O15 photocatalytic composites were successfully prepared by a one-step hydrothermal method. The as-synthesized photocatalysts exhibited an efficient photocatalytic performance and generated low amounts of toxic byproducts. X-ray diffraction studies show that Bi3+ is successfully reduced on the surface of Ba2TiO4/BaBi4Ti4O15 (BT/BBT). After L-Ascorbic acid (AA) modification, the photocatalytic NO removal efficiency of Bi@Ba2TiO4/BaBi4Ti4O15 is increased from 25.55% to 67.88%, while the production of the toxic byproduct NO2 is reduced by 92.02%, where the initial concentration of NO is diluted to ca. 800 ppb by the gas stream and the flow rate is controlled at 301.98 mL·min−1 in a 150 mL cylindrical reactor. Furthermore, ambient humidity has little effect on the photocatalytic performance of theBi@Ba2TiO4/BaBi4Ti4O15, and the photocatalyst exhibits excellent reusability after repeated cleaning with deionized water. The improved photocatalytic effect is attributed to the addition of AA in BT/BBT being able to reduce Bi3+ ions to form Bi nanoparticles giving surface plasmon effect (SPR) and generate oxygen vacancies (OVs) at the same time, thereby improving the separation efficiency of photogenerated carriers, enhancing the light absorption, and increasing the specific surface areas. The present work could provide new insights into the design of high-performance photocatalysts and their potential applications in air purification, especially for NO removal.