In-situ investigation of wetting patterns in polymeric multibore membranes via magnetic resonance imaging

Monitoring residual fouling after cleaning of multi-fiber membrane modules fiber-by-fiber using non-invasive MRI monitoring

In this study non-invasive low field magnetic resonance imaging (MRI) technology was used to monitor fouling induced changes in fiber-by-fiber hydrodynamics inside a multi-fiber hollow fiber membrane module containing 401 fibers. Using structural and velocity images the fouling evolution of these membrane modules were shown to exhibit distinct trends in fiber-by-fiber volumetric flow, with increasing fouling causing a decrease in the number of flow active fibers. This study shows that the fouling rate is not evenly distributed over the parallel fibers, which results in a broadening of the fiber to fiber flowrate distribution. During cleaning, this distribution is initially broadened further, as relatively clean fibers are cleaned more rapidly compared to clogged fibers. By tracking the volumetric flow rate of individual fibers inside the modules during the fouling-cleaning cycle it was possible to observe a fouling memory-like effect with residual fouling occurring preferentially at the outer edge of the fiber bundle during repeated fouling-cleaning cycle. These results demonstrate the ability of MRI velocity imaging to quantitatively monitor these effects which are important when testing the effectiveness of cleaning protocols due to the long term effect that residual fouling and memory-like effect may have on the operation of membrane modules.

MRI on a new polymeric multichannel membrane for ultrafiltration

Membrane ultrafiltration in new polymeric multi-channel membranes designed for in-out filtration was investigated to get insights into structure, flow and filtration properties. The apparent novelty of the membrane concerns the geometry and configuration of the feed channels. In-situ magnetic resonance imaging (MRI) allows non-invasive and non-destructive investigations with adequate spatial and time resolution. The structure of the new polymeric membrane was measured with an in-plane spatial resolution of 35 µm/pixel revealing first the polymer density distribution over the 19-channel membrane and second the wettability of the fiber and its cavities of different dimensions. MRI was also used to answer questions about flow and consequently feed distribution in the channels. Finally, in-situ filtration of an aqueous solution of sodium alginate was observed which led to deposit formation at the channel’s inner surfaces. The kinetics of this deposit formation was quantified. Backwashing and flushing gave insight into the cleanability of the channels.