A new sample preparation method for determination of acidic drugs in sewage sludge applying microwave assisted solvent extraction followed by gas chromatography–mass spectrometry

Assessment of the occurrence of 455 pharmaceutical compounds in sludge according to their physical and chemical properties: A review

Sludge agronomical reuse is of major interest due to the beneficial contribution of nutrients. However, it implies the introduction of unregulated pharmaceuticals into amended-soils and creates a controversial issue about sludge management. To limit their dissemination, it is essential to identify the compounds of interest and understand their attenuation mechanisms through the sludge processes. This paper summarizes the knowledge on 455 investigated pharmaceuticals among 32 therapeutical categories in amendable sludge matrices. It contributes to enlarging the list of commonly quantified compounds to 305 residues including 84 additional compounds compared to previous reviews. It highlights that sorption appears as the main mechanism controlling the occurrence of pharmaceuticals in sludge matrices and shows the considerable residual levels of pharmaceuticals reaching several mg/kg in dry weight. Antibiotics, stimulants, and antidepressants show the highest concentrations up to 232 mg/kg, while diuretics, anti-anxieties or anticoagulants present the lowest concentrations reaching up to 686 µg/kg. Collected data show the increase in investigated compounds as antifungals or antihistamines, and underline emerging categories like antidiabetics, antivirals, or antiarrhythmics. The in-depth analysis of the substantial database guides onto the pharmaceuticals that are the most likely to occur in these amendable matrices to assist future research.

Method Validation and Investigation of the Levels of Pharmaceuticals and Personal Care Products in Sludge of Wastewater Treatment Plants and Soils of Irrigated Golf Course

The validation of a sensitive and reliable analytical procedure for the determination of pharmaceutical and personal care products (PPCPs) in solid environmental samples is reported in this study. Initially, two types of derivatization were used for the identification of the 13 target PPCP standards (acylation and silylation), but silylation proved to be better in sensitivity as it detected all of the analytes under investigation. Samples were extracted using an ultrasonicator, concentrated and re-dissolved in 100 mL water, then cleaned-up using C18 cartridges before silylation that preceded the Gas chromatography-mass Spectrometry detector (GC–MS) analyses. The optimized method provided a linear response over the range of 10–400 ng·g⁻¹ with r² > 0.992 and satisfactory recoveries (>45.6%) for the 13 compounds of interest. In this study, the variation of the sonication temperature, type of organic solvent for extraction, and types of cartridge were used to optimize the extraction procedure. A good repeatability (within day) and reproducibility (between days) with a relative standard deviation (RSD) that was equal or less than 13% for all the PPCPs were achieved with the developed extraction procedures for the irrigated soil and sewage sludge samples. The limits of detection (LODs) of the tested compounds varied from 0.1 ng·g⁻¹ (aspirin) to 1.4 ng·g⁻¹ (doxycycline) and from 0.1 ng·g⁻¹ (codiene) to 1.7 ng·g⁻¹ (doxycycline) for soils and sewage sludge samples, respectively. The method was successfully applied to the sludge of wastewater treatment plants and soils of an irrigated golf course. Among the tested emerging pollutants, paracetamol showed the highest concentration value of 98.9 ng·g⁻¹ in the sludge, and for the irrigated soil (0 to 10 cm), the concentration ranged from 1.16 ng·g⁻¹ (aspirin) to 8.57 ng·g⁻¹ (ibuprofen).

Wastewater micropollutants as tracers of sewage contamination: analysis of combined sewer overflow and stream sediments

A sensitive method was developed to measure the sediment concentration of 10 wastewater micropollutants selected as potential sanitary tracers of sewage contamination and include: nonsteroidal anti-inflammatory drugs (acetaminophen - ACE and diclofenac - DIC), an anti-epileptic drug (carbamazepine - CBZ), a β-blocker (atenolol - ATL), a stimulant (caffeine - CAF), a bronchodilator (theophylline - THEO), steroid hormones (progesterone - PRO and medroxyprogesterone - MedP), an artificial sweetener (aspartame - APM) and personal care products (N,N-diethyl-3-methylbenzamide - DEET). Natural sediments (combined sewer overflow and stream sediments) were extracted by ultrasonic-assisted extraction followed by solid-phase extraction. Analyses were performed using ultra-high-performance liquid chromatography-tandem mass spectrometry (UHPLC-MS/MS) using atmospheric pressure chemical ionisation in positive mode (APCI+) with a total analysis time of 4.5 min. Method detection limits were in the range of 0.01 to 15 ng g(-1) dry weight (dw) for the compounds of interest, with recoveries ranging from 75% to 156%. Matrix effects were observed for some compounds, never exceeding |±18%|. All results displayed a good degree of reproducibility and repeatability, with relative standard deviations (RSD) of less than 23% for all compounds. The method was applied to an investigation of stream and combined sewer overflow sediment samples that differed in organic carbon contents and particle size distributions. Acetaminophen, caffeine and theophylline (as confounded with paraxanthine) were ubiquitously detected at 0.13-22 ng g(-1) dw in stream bed sediment samples and 98-427 ng g(-1) dw in combined sewer overflow sediment samples. Atenolol (80.5 ng g(-1) dw) and carbamazepine (54 ng g(-1) dw) were quantified only in combined sewer overflow sediment samples. The highest concentrations were recorded for DEET (14 ng g(-1) dw) and progesterone (11.5 ng g(-1) dw) in stream bed and combined sewer overflow sediment samples, respectively. The ratio of concentration to its limit of detection (C : LOD) in sediments for a subset of compounds were compared to their C : LOD in water. In waters with a large capacity for dilution relative to fecal sources, the C : LOD ranges in sediments were greater than in water. Thus monitoring programs for fecal source tracking using wastewater micropollutants should consider sediment sampling, particularly for waters with highly diluted sources of fecal contamination.

Determination of 136 pharmaceuticals and hormones in sewage sludge using quick, easy, cheap, effective, rugged and safe extraction followed by analysis with liquid chromatography-time-of-flight-mass spectrometry

The aim of this study was to develop an analytical method for the analysis of a wide range of hormonal steroids and pharmaceutical compounds in sewage sludge. Thus, 136 substances were selected, including 119 pharmaceuticals and 17 hormonal steroids. An innovative sample preparation procedure based on the quick, easy, cheap, effective, rugged and safe (QuEChERS) method was developed. The analysis was then performed using liquid chromatography coupled with time-of-flight mass spectrometry. This analytical procedure was validated by evaluating the specificity, quadratic curve fitting, recovery, reproducibility and limits of detection and quantification. The method allows the analysis of the majority of the target compounds with limits of detection ranging from 1 ng/g to 2500 ng/g, depending on the nature of the substance. The protocol was then successfully applied to various types of sludge (limed, digested, dried, liquid and composted) collected in several sewage works in France. Among the target compounds, 34 were quantified at levels up to 6000 ng/g. Among the most commonly detected pharmaceuticals were the antiemetic domperidone (mean concentration 769 ng/g) and the antiepileptic lamotrigine (mean concentration 31 ng/g) whose presence had, to our knowledge, never been shown in sludge.

Simultaneous analysis of non-steroidal anti-inflammatory drugs and estrogenic hormones in water and wastewater samples using gas chromatography-mass spectrometry and gas chromatography with electron capture detection

Non-steroidal anti-inflammatory drugs are the group of pharmaceuticals that is most often found in the environment, whereas estrogenic hormones are considered to be potent endocrine disruptors. However, the fate and persistence of these compounds in the environment are still unclear. In this study we propose two approaches for determining these compounds in environmental water samples: GC-MS using time windows and operating in selected ion-monitoring mode (SIM) and, for the first time, gas chromatography with electron capture detection (GC-ECD). The identification criteria of both methods fulfilled the requirements of Directive 2002/657/EC. The use of time windows improved the sensitivity of GC-MS measurements. In GC-MS analysis the pharmaceuticals were determined as trimethylsilyl, in GC-ECD as pentafluoropropionyl derivatives. The influence of such parameters as the type of reagent, type of solvent, reaction time, reaction temperature and microwave irradiation in a household microwave oven on the efficacy of silylation was investigated. Derivatization using N,O-bis(trimethylsilyl)trifluoroacetamide (BSTFA) and 1% trimethylchlorosilane (TMCS) in pyridine (1:1, v/v) for 30 min in 60 °C was found to be optimal. Optimization of the solid phase extraction procedure (SPE) confirmed that the application of Oasis HLB cartridges, the acidification of loading samples to pH2 and the use of methanol as eluent gave the best absolute recoveries (ARs) of the target compounds. The following ARs of all the compounds were achieved: 58.2-106.8% in influent wastewater, 77.8-103.4% in effluent wastewater and 81.2-101.9% in surface water samples. Validation of the SPE-GC-MS method enables 13 pharmaceuticals to be determined with MDLs between 3.3 and 343.6 ng/L, depending on the analytes and matrices. GC-ECD analysis enables the determination of 6 pharmaceuticals in surface water samples with MDLs between 0.7 and 5.4 ng/L. The proposed methods were successfully used for analyzing selected pharmaceuticals in wastewaters and river waters in Poland.

Comparison of two extraction methods for the determination of selective serotonin reuptake inhibitors in sewage sludge by hollow fiber liquid-phase microextraction

This paper presents two procedures for the determination of four selective serotonin reuptake inhibitors (citalopram, paroxetine, fluoxetine, and sertraline) and one metabolite (norfluoxetine) in sewage sludge utilizing three-phase hollow fiber liquid-phase microextraction (HF-LPME). First, direct HF-LPME was used for extraction, clean-up, and preconcentration. The pharmaceuticals were extracted from slurry samples into an organic phase and then back-extracted into an aqueous phase in the lumen of the hollow fiber. Second, a procedure combining pressurized hot water extraction and HF-LPME for clean-up and preconcentration was developed for the same analytes and matrix. The extracts were subsequently analyzed by liquid chromatography-mass spectrometry. For direct HF-LPME, limits of detection were between 1 and 12 ng g(-1) (dry weight) and the relative standard deviation (RSD) values were 3-12%. For the second method, limits of detection were approximately 6 ng g(-1) for all the compounds and RSD values were 8-12%. The methods were validated by comparison of results for the same samples. Sewage sludge from a Swedish wastewater treatment plant was analyzed by both methods; average concentrations were similar for citalopram, paroxetine, and fluoxetine with values of approximately 530, 40, and 200 ng g(-1) , respectively.

Analysis of emerging organic contaminants in environmental solid samples

Spreading sewage sludge on agricultural lands has been actively promoted by national authorities as an economic way of recycling. However, as by-product of wastewater treatment, sewage sludge may contain toxic substances, which could be incorporated into agricultural products or be distributed in the environment. Moreover, sediments can be contaminated by the discharge of wastewater effluents into rivers. This article reviews the determination of emerging contaminants (surfactants, flame retardants, pharmaceuticals and personal care products) in environmental solid samples (sludge, soil and sediment). Sample preparation, including extraction and clean-up, as well as the subsequent instrumental determination of contaminants are discussed. Recent applications of extraction techniques, such as Soxhlet extraction, ultrasound assisted extraction, pressurised liquid extraction, microwave assisted extraction and matrix solid-phase dispersion to the analysis of emerging contaminants in environmental solid samples are reviewed. Determination of these contaminants, generally carried out by gas chromatography and liquid chromatography coupled with different detectors, especially mass spectrometry for the identification and quantification of residues, is also summarised and discussed.

Biofilm controlled sorption of selected acidic drugs on river sediments characterized by different organic carbon content

The sorption process of selected non-steroidal anti-inflammatory drugs (ibuprofen, naproxen, ketoprofen, diclofenac) on biofilm covered river sediments were investigated in laboratory. In the course of the experiments, the effect of pH of aqueous phase, the effect of TOC (total organic carbon) content of biofilm on the sorption processes were studied. The determination of concentration of drugs was performed by gas chromatography mass spectrometry (GC-MS) both in liquid and solid phases. The pseudo-first-order rate constant of the sorption was found to be 83 min(-1). The effect of pH on the sorption of diclofenac was significantly lower than the obtained values in case of the other three drugs. The calculated K(d) (sorption coefficient) values increased in the sequence of ibuprofen, naproxen, ketoprofen and diclofenac and varied between 0.1-0.4; 0.2-0.7; 0.2-1.2; 0.2-1.4 kg L(-1) respectively, depending on the characteristics of the sediments. The value of K(d)×f(oc) showed a straight line as function of f(oc) (fraction of organic carbon) therefore, instead of the widely distributed normalization process (K(d)/f(oc)), an empirical equation (K(d)=A/f(oc)+B) was suggested for estimation of the K(d) values in case of different TOC content sediments.

Combined microwave-assisted extraction and continuous solid-phase extraction prior to gas chromatography-mass spectrometry determination of pharmaceuticals, personal care products and hormones in soils, sediments and sludge

This paper reports a sensitive analytical method based on microwave-assisted extraction and continuous solid-phase extraction (SPE), followed by gas chromatography-mass spectrometry (GC-MS), for the simultaneous determination of residues of 18 pharmaceuticals (analgesics, antibacterials, anti-epileptics, β-blockers, lipid regulators and non-steroidal anti-inflammatories), one personal care product and 3 hormones in soils, sediments and sludge. The analytes are extracted with 3:2 methanol/water under the action of microwave energy and the resulting extract is passed through a SPE column to clean up the sample matrix and preconcentrate the analytes. Then, the analytes, trapped on Oasis-HLB sorbent, are eluted with ethyl acetate, silylated and determined by GC-MS. The proposed method provides a linear response over the concentration range 2.5-20,000 ng/kg with correlation coefficients higher than 0.994 in all cases. Also, it features low limits of detection (0.8-5.1 ng/kg), good precision (within- and between-day relative standard deviation less than 7%) and recoveries ranging from 91 to 101%. The method was successfully applied to agricultural soils, river and pond sediments, and sewage sludge. All samples contained some target analyte and sludge contained most -some at considerably high concentrations.