Induction of genetic instability by transfer of a UV-A-irradiated chromosome

Ultraviolet attenuates centromere-mediated meiotic genome stability and alters gametophytic ploidy consistency in flowering plants

Ultraviolet (UV) radiation influences development and genome stability in organisms; however, its impact on meiosis, a special cell division essential for the delivery of genetic information across generations in eukaryotes, has not yet been elucidated. In this study, by performing cytogenetic studies, we reported that UV radiation does not damage meiotic chromosome integrity but attenuates centromere-mediated chromosome stability and induces unreduced gametes in Arabidopsis thaliana. We showed that functional centromere-specific histone 3 (CENH3) is required for obligate crossover formation and plays a role in the protection of sister chromatid cohesion under UV stress. Moreover, we found that UV specifically alters the orientation and organization of spindles and phragmoplasts at meiosis II, resulting in meiotic restitution and unreduced gametes. We determined that UV-induced meiotic restitution does not rely on the UV Resistance Locus8-mediated UV perception and the Tapetal Development and Function1- and Aborted Microspores-dependent tapetum development, but possibly occurs via altered JASON function and downregulated Parallel Spindle1. This study provides evidence that UV radiation influences meiotic genome stability and gametophytic ploidy consistency in flowering plants.

Powdered Cross-Linked Gelatin Methacryloyl as an Injectable Hydrogel for Adipose Tissue Engineering

The tissue engineering field is currently advancing towards minimally invasive procedures to reconstruct soft tissue defects. In this regard, injectable hydrogels are viewed as excellent scaffold candidates to support and promote the growth of encapsulated cells. Cross-linked gelatin methacryloyl (GelMA) gels have received substantial attention due to their extracellular matrix-mimicking properties. In particular, GelMA microgels were recently identified as interesting scaffold materials since the pores in between the microgel particles allow good cell movement and nutrient diffusion. The current work reports on a novel microgel preparation procedure in which a bulk GelMA hydrogel is ground into powder particles. These particles can be easily transformed into a microgel by swelling them in a suitable solvent. The rheological properties of the microgel are independent of the particle size and remain stable at body temperature, with only a minor reversible reduction in elastic modulus correlated to the unfolding of physical cross-links at elevated temperatures. Salts reduce the elastic modulus of the microgel network due to a deswelling of the particles, in addition to triple helix denaturation. The microgels are suited for clinical use, as proven by their excellent cytocompatibility. The latter is confirmed by the superior proliferation of encapsulated adipose tissue-derived stem cells in the microgel compared to the bulk hydrogel. Moreover, microgels made from the smallest particles are easily injected through a 20G needle, allowing a minimally invasive delivery. Hence, the current work reveals that powdered cross-linked GelMA is an excellent candidate to serve as an injectable hydrogel for adipose tissue engineering.

Bioprinting the future using light: A review on photocrosslinking reactions, photoreactive groups, and photoinitiators

Light-based bioprinting is a type of additive manufacturing technologies that uses light to control the formation of biomaterials, tissues, and organs. It has the potential to revolutionize the adopted approach in tissue engineering and regenerative medicine by allowing the creation of functional tissues and organs with high precision and control. The main chemical components of light-based bioprinting are activated polymers and photoinitiators. The general photocrosslinking mechanisms of biomaterials are described, along with the selection of polymers, functional group modifications, and photoinitiators. For activated polymers, acrylate polymers are ubiquitous but are made of cytotoxic reagents. A milder option that exists is based on norbornyl groups which are biocompatible and can be used in self-polymerization or with thiol reagents for more precision. Polyethylene-glycol and gelatin activated with both methods can have high cell viability rates. Photoinitiators can be divided into types I and II. The best performances for type I photoinitiators are produced under ultraviolet light. Most alternatives for visible-light-driven photoinitiators were of type II, and changing the co-initiator along the main reagent can fine-tune the process. This field is still underexplored and a vast room for improvements still exist, which can open the way for cheaper complexes to be developed. The progress, advantages, and shortcomings of light-based bioprinting are highlighted in this review, with special emphasis on developments and future trends of activated polymers and photoinitiators.

Effect of Photoinitiator on Precursory Stability and Curing Depth of Thiol-Ene Clickable Gelatin

Recent advances highlight the potential of photopolymerizable allylated gelatin (GelAGE) as a versatile hydrogel with highly tailorable properties. It is, however, unknown how different photoinitiating system affects the stability, gelation kinetics and curing depth of GelAGE. In this study, sol fraction, mass swelling ratio, mechanical properties, rheological properties, and curing depth were evaluated as a function of time with three photo-initiating systems: Irgacure 2959 (Ig2959; 320–500 nm), lithium phenyl-2,4,6-trimethylbenzoylphosphinate (LAP; 320–500 nm), and ruthenium/sodium persulfate (Ru/SPS; 400–500 nm). Results demonstrated that GelAGE precursory solutions mixed with either Ig2959 or LAP remained stable over time while the Ru/SPS system enabled the onset of controllable redox polymerization without irradiation during pre-incubation. Photo-polymerization using the Ru/SPS system was significantly faster (<5 s) compared to both Ig2959 (70 s) and LAP (50 s). Plus, The Ru/SPS system was capable of polymerizing a thick construct (8.88 ± 0.94 mm), while Ig2959 (1.62 ± 0.49 mm) initiated hydrogels displayed poor penetration depth with LAP (7.38 ± 2.13 mm) in between. These results thus support the use of the visible light based Ru/SPS photo-initiator for constructs requiring rapid gelation and a good curing depth while Ig2959 or LAP can be applied for photo-polymerization of GelAGE materials requiring long-term incubation prior to application if UV is not a concern.

Effect of Smartphone Light Fluxes on Cornea: A Biophysical Study

OBJECTIVE

Biophysical study to investigate (a) the effects of smartphone light fluxes (SPLF) on isolated mammalian cornea and model protein (insulin), (b) to predict the possible visual interference of SPLF.

MATERIALS AND METHODS

Fresh goat cornea and insulin protein were used as an experimental model system. The energy of absorbed SPLF was measured using chemical dosimeter. The effect of SPLF on the aggregation of model protein was studied using fluorescence spectroscopy and dynamic light scattering (DLS). Fluorescence microscopy, scanning electron microscopy (SEM), DLS, were used for cornea imaging.

RESULTS

The spectral emission peak of SPLF was observed at 380 nm and 420 nm. Absorbed radiation of SPLF was found to be 2.82 mWm-2 and 1.92 mWm-2 for collimated (focussed) and noncollimated (nonfocussed) condition, respectively. Secondary structural changes of insulin were observed by fluorescence and zeta potential after SPLF exposure. SEM study revealed the disorganization of the epithelial cell surface, increase in intercellular space, disorganization of primary epithelium layer, and exposure of the second layer is seen in depth. Differential Interference Microscopy showed an optical gradient in images that appears to be changed in specimen structure. Fluorescence microscopy showed disorganization in epithelial cell pattern. A significant difference in bio-molecular permeation was observed in the exposed cornea. Ultraviolet UV-visible spectroscopy study indicated a reduction in light transmission through the cornea.

CONCLUSIONS

The obtained results indicate changes in physicochemical and morphological modifications in the cornea and insulin modifications after exposed to SPLF.

Visible Light Cross-Linking of Gelatin Hydrogels Offers an Enhanced Cell Microenvironment with Improved Light Penetration Depth

In this study, the cyto-compatibility and cellular functionality of cell-laden gelatin-methacryloyl (Gel-MA) hydrogels fabricated using a set of photo-initiators which absorb in 400-450 nm of the visible light range are investigated. Gel-MA hydrogels cross-linked using ruthenium (Ru) and sodium persulfate (SPS), are characterized to have comparable physico-mechanical properties as Gel-MA gels photo-polymerized using more conventionally adopted photo-initiators, such as 1-[4-(2-hydroxyethoxy)-phenyl]-2-hydroxy-2-methyl-1-propan-1-one (Irgacure 2959) and lithium phenyl(2,4,6-trimethylbenzoyl) phosphinate (LAP). It is demonstrated that the Ru/SPS system has a less adverse effect on the viability and metabolic activity of human articular chondrocytes encapsulated in Gel-MA hydrogels for up to 35 days. Furthermore, cell-laden constructs cross-linked using the Ru/SPS system have significantly higher glycosaminoglycan content and re-differentiation capacity as compared to cells encapsulated using I2959 and LAP. Moreover, the Ru/SPS system offers significantly greater light penetration depth as compared to the I2959 system, allowing thick (10 mm) Gel-MA hydrogels to be fabricated with homogenous cross-linking density throughout the construct. These results demonstrate the considerable advantages of the Ru/SPS system over traditional UV polymerizing systems in terms of clinical relevance and practicability for applications such as cell encapsulation, biofabrication, and in situ cross-linking of injectable hydrogels.

Genotoxic changes in peripheral lymphocytes after therapeutic exposure to crude coal tar and ultraviolet radiation

AIMS

Goeckerman therapy is based on combined exposure to UV radiation (UVA, UVB) and crude coal tar (PAHs). Some indicators suggest a genotoxic hazard, however, the level of genotoxic risk of the therapy has not yet been investigated sufficiently. This study aims to assesss the genotoxic risk.

METHODS

The studied group consisted of patients with chronic stable plaque psoriasis treated by Goeckerman therapy (n = 29). Heparin-treated peripheral blood samples were collected one day before the first treatment and immediately after the last procedure. The lymphocytes were isolated from the blood. The level of genotoxicity was evaluated using an alkaline version of the Comet assay which detects DNA single strand breaks (DNA-SSBs), a neutral version of the Comet assay which detects DNA double strand breaks (DNA-DSBs), and using chromosomal aberrations.

RESULTS

The level of DNA-SSBs increased insignificantly (median; Q1-Q3): 1.4 (0.4; 0.1-1.4) vs. 2.5 (0.6; 0.3-2.7) %tDNA (P = 0.11) and the level of DNA-DSBs increased significantly: 7.8 (6.5; 3.4-10.5) vs. 20.7 (19.3; 14.2-24.6) % DNA (P < 0.001). The total number of aberrated cells (P < 0.001) and structurally aberrated cells (P < 0.001) increased significantly.

CONCLUSION

The elevated levels of the DNA-DSBs and the chromosomal aberrations in the peripheral lymphocytes indicated a genotoxic hazard. However, the elevated level of the chromosomal abnormalities was below the upper level of the reference range for healthy Czech adults. While, the genotoxic risk appears to be low, Goeckerman treatment represents a further contribution to the lifetime load of genotoxic factors.