Quickly Alternating Green and Red Laser Source for Real-time Multispectral Photoacoustic Microscopy

Efficient label-free in vivo photoacoustic imaging of melanoma cells using a condensed NIR-I spectral window

In this paper, we propose an efficient label-free in vivo photoacoustic (PA) imaging of melanoma using a condensed near infrared-I (NIR-I) supercontinuum light source. Although NIR-II spectral window is advantageous such as longer penetration depth compared to the NIR-I region, supercontinuum light sources emitting both NIR-I and NIR-II region could lower the efficiency to target melanoma because of low optical power density in the melanoma's absorption spectra. To exploit efficient in vivo PA imaging of melanoma, we demonstrated the light source emitting from visible (532-600 nm) to NIR-I (600-1000 nm) by optimizing stimulated Raman scattering induced supercontinuum generation. The melanoma's structure is successfully differentiated from blood vessels at a high pulse energy of 2.5 µJ and a flexible pulse repetition rate (PRR) of 5-50 kHz. The proposed light source with the microjoules energies and tens of kHz of PRR can potentially accelerate clinical trials such as early diagnosis of melanoma.

Two-step proximal gradient descent algorithm for photoacoustic signal unmixing

Photoacoustic microscopy uses multiple wavelengths to measure concentrations of different absorbers. The speed of sound limits the shortest wavelength switching time to sub-microseconds, which is a bottleneck for high-speed broad-spectrum imaging. Via computational separation of overlapped signals, we can break the sound-speed limit on the wavelength switching time. This paper presents a new signal unmixing algorithm named two-step proximal gradient descent. It is advantageous in separating multiple wavelengths with long overlapping and high noise. In the simulation, we can unmix up to nine overlapped signals and successfully separate three overlapped signals with 12-ns delay and 15.9-dB signal-to-noise ratio. We apply this technique to separate three-wavelength photoacoustic images in microvessels. In vivo results show that the algorithm can successfully unmix overlapped multi-wavelength photoacoustic signals, and the unmixed data can improve accuracy in oxygen saturation imaging.

Spectroscopic photoacoustic microscopic imaging during single spatial scan using broadband excitation light pulses with wavelength-dependent time delay

In most multispectral optical-resolution photoacoustic microscopy (OR-PAM), spatial scanning is repeated for each excitation wavelength, which decreases throughput and causes motion artifacts during spectral processing. This study proposes a new spectroscopic OR-PAM technique to acquire information on the photoacoustic signal intensity and excitation wavelength from single spatial scans. The technique involves irradiating an imaging target with two broadband optical pulses with and without wavelength-dependent time delays. The excitation wavelength of the sample is then calculated by measuring the time delay between the photoacoustic signals generated by the two optical pulses. This technique is validated by measuring the excitation wavelengths of dyes in tubes. Furthermore, we demonstrate the three-dimensional spectroscopic OR-PAM of cells stained with suitable dyes. Although the tradeoff between excitation efficiency and excitation bandwidth must be adjusted based on the application, combining the proposed technique with fast spatial scanning methods can significantly contribute to recent OR-PAM applications, such as monitoring quick biological events and microscale tracking of moving materials.

High-speed photoacoustic microscopy: A review dedicated on light sources

In recent years, many methods have been investigated to improve imaging speed in photoacoustic microscopy (PAM). These methods mainly focused upon three critical factors contributing to fast PAM: laser pulse repetition rate, scanning speed, and computing power of the microprocessors. A high laser repetition rate is fundamentally the most crucial factor to increase the PAM speed. In this paper, we review methods adopted for fast PAM systems in detail, specifically with respect to light sources. To the best of our knowledge, ours is the first review article analyzing the fundamental requirements for developing high-speed PAM and their limitations from the perspective of light sources.

Functional photoacoustic remote sensing microscopy using a stabilized temperature-regulated stimulated Raman scattering light source

Stimulated Raman scattering (SRS) has been widely used in functional photoacoustic microscopy to generate multiwavelength light and target multiple chromophores inside tissues. Despite offering a simple, cost-effective technique with a high pulse repetition rate; it suffers from pulse-to-pulse intensity fluctuations and power drift that can affect image quality. Here, we propose a new technique to improve the temporal stability of the pulsed SRS multiwavelength source. We achieve this by lowering the temperature of the SRS medium. The results suggest that a decrease in temperature causes an improvement of temporal stability of the output, considerable rise in the intensity of the SRS peaks, and significant increase of SRS cross section. The application of the method is shown for in vivo functional imaging of capillary networks in a chicken embryo chorioallantois membrane using photoacoustic remote sensing microscopy.

High-resolution functional photoacoustic monitoring of vascular dynamics in human fingers

Functional imaging of microvascular dynamics in extremities delivers intuitive information for early detection, diagnosis, and prognosis of vascular diseases. High-resolution and high-speed photoacoustic microscopy (PAM) visualizes and measures multiparametric information of microvessel networks in vivo such as morphology, flow, oxygen saturation, and metabolic rate. Here, we demonstrate high-resolution photoacoustic monitoring of vascular dynamics in human fingers. We photoacoustically monitored the position displacement of blood vessels associated with arterial pulsation in human fingers. Then, during and after arterial occlusion, we photoacoustically quantified oxygen consumption and blood perfusion in the fingertips. The results demonstrate that high-resolution functional PAM could be a vital tool in peripheral vascular examination for measuring heart rate, oxygen consumption, and/or blood perfusion.

Functional and structural ophthalmic imaging using noncontact multimodal photoacoustic remote sensing microscopy and optical coherence tomography

Early diagnosis of ocular diseases improves the understanding of pathophysiology and aids in accurate monitoring and effective treatment. Advanced, multimodal ocular imaging platforms play a crucial role in visualization of ocular components and provide clinicians with a valuable tool for evaluating various eye diseases. Here, for the first time we present a non-contact, multiwavelength photoacoustic remote sensing (PARS) microscopy and swept-source optical coherence tomography (SS-OCT) for in-vivo functional and structural imaging of the eye. The system provides complementary imaging contrasts of optical absorption and optical scattering, and is used for simultaneous, non-contact, in-vivo imaging of murine eye. Results of vasculature and structural imaging as well as melanin content in the retinal pigment epithelium layer are presented. Multiwavelength PARS microscopy using Stimulated Raman scattering is applied to enable in-vivo, non-contact oxygen saturation estimation in the ocular tissue. The reported work may be a major step towards clinical translation of ophthalmic technologies and has the potential to advance the diagnosis and treatment of ocular diseases.