Visible-light driven photocatalytic performance of eco-friendly cobalt-doped ZnO nanoarrays: Influence of morphology, cobalt doping, and photocatalytic efficiency

Efficient rhodamine B dye photocatalytic degradation in aqueous media using novel ZnO nanomaterials co-doped with Ce and Dy

Water pollution caused by dyes and industrial wastewater poses a significant threat to ecosystems. The purification of such pollutants presents a major challenge. Photocatalysis based on semiconductor materials is a potential wastewater treatment process due to its safety and cost-effectiveness. In the present work, Zn1-2xCexDyxO (x = 0.01-0.05) semiconductors were prepared by the sol-gel auto-ignition method. The samples are denoted CDZO1, CDZO3, and CDZO5 for x  = 0.01-0.05, respectively. The X-ray diffraction and Raman spectroscopy results revealed the formation of ZnO hexagonal phase wurtzite structure for all synthesized compositions. Different structural properties were determined. It was found that the lattice parameters and the unit cell volume increased, while the crystallite size diminished as x varied from 0.01 to 0.05. Transmission electron microscopy observations confirmed the formation of nanoparticles with the desired chemical compositions. The specific surface area (SSA) values are found to be 39.95 m2/g, 48.62 m2/g, and 51.36 m2/g for CDZO1, CDZO5, and CDZO5 samples, respectively. The reflectance spectra were recorded to examine the optical properties of the different nanoparticles. The values of the optical band gap were 3.221, 3.225, and 3.239 eV for CDZO1, CDZO3, and CDZO5 samples, respectively. In addition, the photocatalytic performance towards RhB dye degradation for the different samples was assessed. It was established that the CDZO3 sample with a moderate SSA value exhibited the superior photocatalytic performance among the other as-prepared samples wherein the percentage of degradation efficiency, and kinetic constant rate attained their maximum values of 98.22 % and 0.0521 min-1, respectively within 75 min. As per the obtained findings, it is evident that the Zn1-2xCexDyxO photocatalyst has prominent potential for use in the degradation of dyes and offers a useful route for impeding the recombination of electron-hole pairs of zinc oxide material.

Hydrothermal fabrication, characterization and RSM optimization of cobalt-doped zinc oxide nanoparticles for antibiotic photodegradation under visible light

Photodegradation is considered a significant method engaged for the elimination of organic pollutants from water. In this work, hydrothermal cobalt-doped zinc oxide nanoparticles (Hy-Co-ZnO NPs) loaded with 5, 10, and 15% cobalt were prepared in a hydrothermal way and were investigated as a photocatalyst for the Ciprofloxacin (CIPF) degradation under visible irradiation using LED-light. Characterization approaches such as FTIR, XRD, XPS, DRS UV-vis spectroscopy, SEM, TEM, BET, EDX and TGA were used for the investigation of the fabricated Hy-Co-ZnO NPs. The studies indicated that 10% Hy-Co-ZnO NPs was the most efficient catalyst for the CIPF photolysis compared to ZnO NPs and other Hy-Co-ZnO NPs with 5 and 15% cobalt content. Higher photocatalytic activity (> 98%) of 20 mg/L of CIPF solution was attained within 60 min. The reaction kinetics showed that the first-order model is suitable for displaying the rate of reaction and amount of CIPF elimination with R2 = 0.9883. Moreover, Central composite design (CCD) optimization of the 10% Hy-Co-ZnO NPs was also studied.

Effect of Co Doping on the Physical Properties and Organic Pollutant Photodegradation Efficiency of ZnO Nanoparticles for Environmental Applications

This paper presents a comprehensive investigation of the synthesis and characterization of Zn1-xCoxO (0 ≤ x ≤ 0.05) nanopowders using a chemical co-precipitation approach. The structural, morphological, and vibrational properties of the resulting ZnO nanostructures were assessed through X-ray diffraction, scanning electronic microscopy, and Raman spectroscopy to examine the influence of cobalt doping. Remarkably, a notable congruence between the experimental results and the density functional theory (DFT) calculations for the Co-doped ZnO system was achieved. Structural analysis revealed well-crystallized hexagonal wurtzite structures across all samples. The SEM images demonstrated the formation of spherical nanoparticles in all the samples. The vibrational properties confirmed the formation of a hexagonal wurtzite structure, with an additional Raman peak corresponding to the F2g vibrational mode characteristic of the secondary phase of ZnCo2O4 observed at a 5% cobalt doping concentration. Furthermore, a theoretical examination of cobalt doping's impact on the elastic properties of ZnO demonstrated enhanced mechanical behavior, which improves stability, recyclability, and photocatalytic activity. The photocatalytic study of the synthesized compositions for methylene blue (MB) dye degradation over 100 min of UV light irradiation demonstrated that Co doping significantly improves photocatalytic degradation. The material's prolonged lifetime, reduced rate of photogenerated charge carrier recombination, and increased surface area were identified as pivotal factors accelerating the degradation process. Notably, the photocatalyst with a Zn0.99Co0.01O composition exhibited exceptional efficiency compared to that reported in the literature. It demonstrated high removal activity, achieving an efficiency of about 97% in a shorter degradation time. This study underscores the structural and photocatalytic advancements in the ZnO system, particularly at lower cobalt doping concentrations (1%). The developed photocatalyst exhibits promise for environmental applications owing to its superior photocatalytic performance.

Cube-shaped Cobalt-doped zinc oxide nanoparticles with increased visible-light-driven photocatalytic activity achieved by green co-precipitation synthesis

From the perspective of environmental protection, the highly efficient degradation of antibiotics and organic dyes in wastewater needs to be tackled as soon as possible. In this study, an ecofriendly and green cube-shaped cobalt-doped zinc oxide nanoparticles (Co-ZnO NPs) photocatalyst using Pterocladia Capillacea (P. Capillacea) water extract loaded with 5, 10, and 15% cobalt ions were formed via co-precipitation process to degrade antibiotics. The prepared Co-ZnO NPs were tested as a photocatalyst for the photodegradation of ciprofloxacin (CIPF) in the presence of a visible LED-light source. Co-ZnO NPs have been obtained through the co-precipitation method in the presence of P. Capillacea extract as a green capping agent and reducing agent, for the first time. Several characterization techniques including FTIR, XRD, BET, XPS, TEM, EDX, SEM, TGA and DRS UV-Vis spectroscopy were applied to study the prepared Co-ZnO NPs. XRD results suggested that the average size of these NPs ranged between 42.82 and 46.02 nm with a hexagonal wurtzite structure. Tauc plot shows that the optical energy bandgap of ZnO NPs (3.19 eV) gradually decreases to 2.92 eV by Co doping. Examinations showed that 5% Co-ZnO NPs was the highest efficient catalyst for the CIPF photodegradation when compared with ZnO NPs and other 10 and 15% Co-ZnO NPs. A 10 mg/L solution of CIPF was photo-degraded (100%) within the first 15 min irradiation. The kinetics showed that the first-order model is suitable for displaying the rate of reaction and amount of CIPF elimination with R2 = 0.952. Moreover, central composite design optimization of the 5% Co-doped ZnO NPs was also investigated.

Suppression of Visible Emission in Low-Temperature Synthesized Cobalt-Doped ZnO Nanoparticles and Their Photosensing Applications

Cobalt (Co)-doped ZnO nanoparticles have been synthesized at 100 °C using a simple chemical technique, without post-deposition annealing. These nanoparticles are of excellent crystallinity and show a significant reduction in defect density upon Co-doping. By varying the Co solution concentration, it is observed that oxygen-vacancy-related defects are suppressed at lower Co-doping, while the defect density shows an increasing trend at higher doping densities. This suggests that mild doping can significantly suppress the defects in ZnO for electronic and optoelectronic applications. The effect of Co-doping is studied using X-ray photoelectron spectroscopy (XPS), photoluminescence (PL), electrical conductivity, and Mott-Schottky plots. Photodetectors fabricated using pure and Co-doped ZnO nanoparticles show a noticeable reduction in the response time upon Co-doping, which again affirms the reduction in the defect density after Co-doping.

Synergistic Contribution of Oligo(ethylene glycol) and Fluorine Substitution of Conjugated Polymer Photocatalysts toward Solar Driven Sacrificial Hydrogen Evolution

To separately explore the importance of hydrophilicity and backbone planarity of polymer photocatalyst, a series of benzothiadiazole-based donor-acceptor alternating copolymers incorporating alkoxy, linear oligo(ethylene glycol) (OEG) side chain, and backbone fluorine substituents is presented. The OEG side chains in the polymer backbone increase the surface energy of the polymer nanoparticles, thereby improving the interaction with water and facilitating electron transfer to water. Moreover, the OEG-attached copolymers exhibit enhanced intermolecular packing compared to polymers with alkoxy side chains, which is possibly attributed to the self-assembly properties of the side chains. Fluorine substituents on the polymer backbone produce highly ordered lamellar stacks with distinct π-π stacking features; subsequently, the long-lived polarons toward hydrogen evolution are observed by transient absorption spectroscopy. In addition, a new nanoparticle synthesis strategy using a methanol/water mixed solvent is first adopted, thereby avoiding the screening effect of surfactants between the nanoparticles and water. Finally, hydrogen evolution rate of 26 000 µmol g^-1  h^-1 is obtained for the copolymer incorporated with both OEG side chains and fluorine substituents under visible-light irradiation (λ > 420 nm). This study demonstrates how the glycol side chain strategy can be further optimized for polymer photocatalysts by controlling the backbone planarity.

Synergistic effect of modified pore and heterojunction of MOF-derived α-Fe2O3/ZnO for superior photocatalytic degradation of methylene blue

Mesoporous heterojunction MOF-derived α-Fe₂O₃/ZnO composites were prepared by a simple calcination of α-Fe₂O₃/ZIF-8 as a sacrificial template. The optical properties confirm that coupling of both the modified pore and the n-n heterojunction effectively reduces the possibility of photoinduced charge carrier recombination under irradiation. The mesoporous Fe(25)ZnO with 25% loading of α-Fe₂O₃ exhibited the best performance in MB degradation, up to ∼100% after 150 minutes irradiation, higher than that of pristine ZnO and α-Fe₂O₃. Furthermore, after three cycles reusability, mesoporous Fe(25)ZnO still showed an excellent stability performance of up to 95.42% for degradation of MB. The proposed photocatalytic mechanism of mesoporous Fe(25)ZnO for the degradation of MB corresponds to the n-n heterojunction system. This study provides a valuable reference for preparing mesoporous MOF-derived metal oxides with an n-n heterojunction system to enhance MB photodegradation.

Improved Photocatalytic Activity via n-Type ZnO/p-Type NiO Heterojunctions

The design and construct pn heterojunction to reduce the recombination rate of photogenerated electron-hole pairs can effectively improve photocatalytic activity. In this study, ZnO/NiO heterojunctions were fabricated by annealing a Zn/Ni metal organic framework precursor synthesized via coprecipitation. The effects of the precursor annealing temperature on the microstructure, morphology, and optical properties of the ZnO/NiO nanocomposites were investigated using X-ray diffraction, scanning electron microscopy, transmission electron microscopy, X-ray photoelectron spectroscopy, and UV-vis absorption spectroscopy. The results showed that the nanocomposite was composed of hexagonal wurtzite ZnO and cubic NiO, with the former being the dominant phase. Large ZnO nanoparticles were attached to small NiO nanoparticles, and a pn heterojunction interface was formed. The photodegradation performance of the nanomaterials was evaluated by monitoring the degradation of RhB under irradiation by ultraviolet light. The ZnO/NiO nanocomposites exhibited excellent photocatalytic activity when the annealing temperature was 550 °C. The photodegradation mechanism was also analyzed in detail, revealing that the heterojunction between the n-type ZnO and the p-type NiO played an important role in impeding the recombination of photogenerated electron-hole pairs and improving the photocatalytic efficiency.

Photocatalytic activity study of ZnO modified with nitrogen–sulfur co-doped carbon quantum dots under visible light

Enhanced degradation rate of RhB under visible light by N,S-CQDs-modified ZnO.