Guidelines for solvent selection for carrier mediated extraction of proteins

Changes of structural characteristics, functional properties and volatile compounds of Tenebrio molitor larvae protein after sustainable defatting process: Influence of the different volume ratios of n-hexane to ethanol

This work aimed to study the effect of defatting via the mixture of n-hexane and ethanol under different volume ratio on the changes of structural characteristics, functional properties and volatile compounds of Tenebrio molitor larvae protein (TMLP). The results showed that 1:0.6 vol ratio of n-hexane to ethanol rendered the highest defatting rate (P < 0.05), as well as led to the highest EAA/AA contents, sulfhydryl contents, surface hydrophobicity, solubility, water/oil holding capacities and emulsifying properties of TMLP (P < 0.05). However, higher volume ratio of n-hexane to ethanol led to negative impacts on functionalities of TMLP. Moreover, the contents of aldehydes and hydrocarbons which rendered off-flavour to TMLP significantly decreased with the increasing volume ratio of n-hexane to ethanol (P < 0.05), while the contents of pleasure flavour (hydrocarbons and ester compounds) were obviously enhanced. This study provides an eco-friendly defatting method on the processing of TMLP with superior quality attributes.

How the presence of residual lipids in a yellow mealworm protein concentrate affects its foaming properties?

The use of whole and visible insects is poorly accepted in Western countries, and this remains a significant challenge for product development. However, using insect-based protein-rich ingredients, like protein concentrate, can improve levels of consumer approval. The residual lipid content in insect protein concentrates can influence their techno-functional properties. Our study therefore aimed to evaluate the impact of the residual lipid content on the protein structure and foaming properties of a mealworm protein concentrate. Our results showed that the protein content increased from 78.01 to 84.82 % after using chloroform-methanol for lipid removal. The particle size distribution shifted from a bimodal to a unimodal pattern, and the surface hydrophobicity decreased from 267.02 to 48.91 after completely removing lipids by chloroform-methanol, with no noticeable impact on the protein profile. The foaming capacity improved, resulting in the formation of a firm and fluffy foam with high stability over time. These results highlight the importance of controlling the residual lipid content in mealworm protein concentrates to enhance their techno-functional properties. The next steps will entail comprehensively characterizing the lipid profile and exploring the various mechanisms contributing to the techno-functional properties.

Machine learning for surrogate process models of bioproduction pathways

Technoeconomic analysis and life-cycle assessment are critical to guiding and prioritizing bench-scale experiments and to evaluating economic and environmental performance of biofuel or biochemical production processes at scale. Traditionally, commercial process simulation tools have been used to develop detailed models for these purposes. However, developing and running such models can be costly and computationally intensive, which limits the degree to which they can be shared and reproduced in the broader research community. This study evaluates the potential of an automated machine learning approach to develop surrogate models based on conventional process simulation models. The analysis focuses on several high-value biofuels and bioproducts for which pathways of production from biomass feedstocks have been well-established. The results demonstrate that surrogate models can be an accurate and effective tool for approximating the cost, mass and energy balance outputs of more complex process simulations at a fraction of the computational expense.

Advances Achieved by Ionic-Liquid-Based Materials as Alternative Supports and Purification Platforms for Proteins and Enzymes

Ionic liquids (ILs) have been applied in several fields in which enzymes and proteins play a noteworthy role, for instance in biorefinery, biotechnology, and pharmaceutical sciences, among others. Despite their use as solvents and co-solvents, their combination with materials for protein- and enzyme-based applications has raised significant attention in the past few years. Among them, significant advances were brought by supported ionic liquids (SILs), in which ILs are introduced to modify the surface and properties of materials, e.g., as ligands when covalently bond or when physiosorbed. SILs have been mainly investigated as alternative supports for enzymes in biocatalysis and as new supports in preparative liquid chromatography for the purification of high-value proteins and enzymes. In this manuscript, we provide an overview on the most relevant advances by using SILs as supports for enzymes and as purification platforms for a variety of proteins and enzymes. The interaction mechanisms occurring between proteins and SILs/ILs are highlighted, allowing the design of efficient processes involving SILs. The work developed is discussed in light of the respective development phase and innovation level of the applied technologies. Advantages and disadvantages are identified, as well as the missing links to pave their use in relevant applications.

Effects of organic solvent on functional properties of defatted proteins extracted from Protaetia brevitarsis larvae

This study investigated the effect of aqueous fat separation and defatting using organic solvents (99% methanol, ethanol, and n-hexane) on the characteristics and functionality of proteins extracted from Protaetia brevitarsis. The defatting efficiency, amino acid composition, protein solubility, and technical properties were the highest when proteins were defatted using n-hexane. Proteins defatted using ethanol were similar in foam capacity and emulsifying capacity. Surface hydrophobicity decreased when using organic solvents, and excessive fat content disrupted the functional properties of the extracted proteins. Proteins extracted using the different solvents displayed different pH values. The pH of the aqueous extract was the lowest. CIE L* a* b* color values also differed using the different extraction methods. Although n-hexane might be the most efficient solvent for defatting the proteins extracted from edible insects, ethanol could also be used to obtain similar foam and emulsifying capacities.

An integrated process for enzymatic catalysis allowing product recovery and enzyme reuse by applying thermoreversible aqueous biphasic systems

Thermoreversible aqueous biphasic systems (ABS) composed of ammonium-based zwitterions (ZIs) and polymers are here disclosed to act as integrated bioreaction-separation processes. The biocatalytic reaction involving laccase occurs in homogeneous media, after which small changes in temperature induce the formation of two phases and the complete separation of the enzyme from the products in a single-step. These systems also allow the recover and reuse of the enzyme, along with the ZI-rich phase, contributing towards the development of sustainable biocatalytic processes.

Evaluation of the effect of ionic liquids as adjuvants in polymer-based aqueous biphasic systems using biomolecules as molecular probes

Aqueous biphasic systems (ABS) have been largely investigated for the extraction, separation and/or purification of biomolecules. Recently, the use of ionic liquids (ILs) as additives in conventional polymer-based ABS was proposed to overcome the limited range of polarities of the coexisting phases. However, the impact of ILs on the partitioning of biomolecules on IL additivated ABS is not universal and is still poorly understood. Aiming at obtaining additional insights on this matter, the effects of the chemical structure of the IL, tie-line length (TLL) and biomolecule nature upon the partition of a series of model biomolecules were investigated. For this purpose, ternary ABS (composed of polyethylene glycol (PEG) 400, citrate buffer at pH 7.0, and water), and several quaternary ABS (composed of PEG 400, citrate buffer at pH 7.0, water and ILs at 5 wt%), were prepared using different chloride-based ILs ([C₄mim]Cl, [C₄mpyr]Cl, [C₄mpip]Cl, [P₄₄₄₄]Cl and [N₄₄₄₄]Cl). The partition of a wide range of biomolecules in these systems (gallic acid, vanillic acid, eugenol, nicotine, caffeine, l-tryptophan, l-phenylalanine and l-tyrosine), used here as molecular probes, was studied. These solutes were chosen due to their wide range of polarities. The results obtained support the concept that ILs, when used as adjuvants in polymer-based ABS, change the coexisting phases' characteristics and modify the partition behavior of biomolecules. In general, a positive effect derived from the use of ILs as adjuvants in PEG-salt systems is observed, particularly when dealing with more hydrophobic biomolecules, whereas IL + salt ABS perform better in the extraction of more hydrophilic biomolecules. The favourable partition of more hydrophilic biomolecules in IL + salt ABS seems to be ruled by specific interactions with the IL, while the favourable partition of more hydrophobic biomolecules in PEG + salt and PEG + salt + IL seems to be governed by the differences in the phases hydrophobicities. It is shown that ILs preferentially migrate to the PEG-rich phase, and that there is a correlation between the partition coefficients of the biomolecules and ILs and the biomolecules octanol-water partition coefficients.

Bio-oil extraction of Jatropha curcas with ionic liquid co-solvent: Fate of biomass protein

The fate of oil-seed biomass protein has been tracked through all steps of a multi-phase extraction process using an ionic liquid based co-solvent system previously demonstrated to extract bio-oil and phorbol esters and to recover fermentable sugars from Jatropha oil seed. These analyses, however, did not address the fate of biomass protein. This work demonstrated that the majority of protein (∼86%) tracked with the biomass with the balance lost to co-solvent (∼12%) and methanol (∼2%) washes. A significant portion of the ionic liquid remained with the treated biomass and required aggressive methanol washes to recover. A system analysis showed a net-positive energy balance and thus the potential of this system to produce both bio-oil and protein-rich toxin-free biomass. While these results further support Jatropha as an oil seed crop, the additional costs of solvent recovery will need to be addressed if commercialization is to be realized.

Improving the extraction and purification of immunoglobulin G by the use of ionic liquids as adjuvants in aqueous biphasic systems

Immunoglobulins G (IgG) could become widespread biopharmaceuticals if cost-efficient processes for their extraction and purification are available. In this work, aqueous biphasic systems (ABS) composed of polyethylene glycols and a buffered salt, and with ionic liquids (ILs) as adjuvants, have been studied as alternative extraction and purification platforms of IgG from a rabbit serum source. Eleven ILs were investigated to provide insights on the chemical features which maximize the IgG partitioning. It is shown that in polymer-salt systems pure IgG preferentially partitions to the polymer-rich phase; yet, the complete extraction was never attained. Remarkably, after the addition of 5wt% of adequate ILs to polymer-salt ABS, the complete extraction of pure IgG in a single-step was accomplished. The best systems and conditions were then applied to the extraction and purification of IgG directly from rabbit serum samples. The complete extraction of IgG in a single-step was maintained while its purity in the polymer-rich phase was enhanced by ca. 37% as compared to the IL-free ABS. The antibody stability was also evaluated revealing that appropriate ILs are able to maintain the IgG stability and can be used as phase-forming components of ABS when envisaging the purification of high-cost biopharmaceuticals.

Extraction of tryptophan with ionic liquids studied with molecular dynamics simulations

Extraction of amino acids from aqueous solutions with ionic liquids (ILs) in biphasic systems is analyzed with molecular dynamics (MD) simulations. Extraction of tryptophan (TRP) with the imidazolium-based ILs [C(4)mim][PF(6)], [C(8)mim][PF(6)], and [C(8)mim][BF(4)] are considered as model cases. Solvation free energies of TRP are calculated with MD simulations and thermodynamic integration in combination with an empirical force field, whose parametrization is based on the liquid-phase charge distribution of the ILs. Calculated solvation free energies reproduce successfully all observed experimental trends according to the previously reported partition of TRP between water and IL phases. Water is present in ILs as a cosolvent, due to direct contact with the aqueous phase during extraction, and is found to play a major role in the extraction of TRP. Water improves solvation of cationic TRP by 7.8 and 5.1 kcal/mol in [C(4)mim][PF(6)] and [C(8)mim][PF(6)], respectively, which is in the case of [C(4)mim][PF(6)] sufficient to extract TRP. Extraction in [C(8)mim][PF(6)] is not feasible, since the hydrophobic octyl groups of the cations limit the water concentration in the IL. The solvation of cationic TRP is 2.4 kcal/mol less favorable in [C(8)mim][PF(6)] than in [C(4)mim][PF(6)]. Water improves the solvation of TRP in ILs mostly through dipole-dipole interactions with the polar backbone of TRP. Extraction is most efficient with [C(8)mim][BF(4)], where hydrophilic BF(4)(-) anions substantially increase the water concentration in the IL. Additionally, stronger direct electrostatic interactions of TRP with BF(4)(-) anions improve its solvation in the IL further. The solvation of cationic TRP in [C(8)mim][BF(4)] is 3.4 kcal/mol more favorable than in [C(8)mim][PF(6)]. Overall, the extractive power of the ILs correlates with the water saturation concentration of the IL phase, which in turn is determined by the hydrophilicity of the constituting ions. The results of this work identify relations between the extraction performance of ILs and the basic chemical properties of the ions, which provide guidelines that could contribute to the design of improved novel ILs for amino acid extraction.

Evaluation of anion influence on the formation and extraction capacity of ionic-liquid-based aqueous biphasic systems

Extractive fermentation using aqueous biphasic systems (ABS) is a promising separation process since it provides a nondenaturing environment for biomolecules and improves the stability of cells. Due to environmental concerns and toxicity issues related with common volatile organic solvents, ionic liquids (ILs), a new class of nonvolatile alternative solvents, are being currently investigated for extraction purposes. In this work, a wide range of imidazolium-based ILs was studied aiming at obtaining new insights regarding their ability toward the formation of ABS and their capacity to the extraction of biomolecules. On the basis of the IL cations 1-ethyl-3-methylimidazolium and 1-butyl-3-methylimidazolium, the IL anion influence on ABS formation was assessed through their combination with chloride, bromide, acetate, hydrogensulfate, methanesulfonate, methylsulfate, ethylsulfate, trifluomethanesulfonate, trifluoroacetate, and dicyanamide. Ternary phase diagrams (and respective tie-lines) formed by these hydrophilic ILs, water, and the inorganic salt K(3)PO(4), were measured and are reported. The results indicate that the ability of an IL to induce ABS closely follows the decrease in the hydrogen bond accepting strength or the increase in the hydrogen bond acidity of the IL anion. In addition, the extraction capacity of the studied ABS was evaluated through their application to the extraction of an essential amino acid, L-tryptophan. It is shown that the partition coefficients obtained between the IL and the K(3)PO(4)-aqueous rich phases were substantially larger than those typically obtained with polymers-inorganic salts or polymers-polysaccharides aqueous systems.