Determination of volatile halogenated organic compounds in soils by purge-and-trap capillary gas chromatography with atomic emission detection

Spatio-vertical characterization of the BTEXS group of VOCs in Chinese agricultural soils

Ubiquitous contamination of the BTEXS (benzene, toluene, ethylbenzene, xylene, and styrene) group in soils is a significant concern for ecological safety. However, comprehensive spatio-vertical survey of the BTEXS group on a national scale is rare to date. Using a static headspace gas chromatography-mass spectrometry method (HS-GCMS), this study performed a quantitative analysis of BTEXS levels in soils from Chinese rural areas in 2013 and 2016. The median ∑BTEXS concentrations in surface soils in 2013 and 2016 were 37.5 and 34.4 ng g^-1 dry weight, respectively. Toluene was the dominant pollutant, accounting for approximately 41.6% and 32.1% of the total levels. BTEXS contamination was higher in Shanxi province, Northeast China, and Yunnan-Guizhou Plateau compared to the other regions. Vertically, toluene, m,p'-xylene and o'-xylene concentrations were significantly higher in the top soil layer (0-15 cm) and decreased significantly with increasing soil depth (p < 0.05). Higher soil organic matter was significantly associated with higher BTEXS concentrations of sampling site. BTEXS was also enhanced at sites with higher elevations and lower temperature due to global distillation effects. The findings of this study could help decision-makers to protect against BTEXS contamination in rural areas. These findings provide a basis for further study of the mechanism of BTEXS migration and transport in large-scale environment. CAPSULE: Spatio-vertical distribution, influence factors, exposure risks of BTEXS in soils from Chinese agricultural region was studied.

Formation and transformation of chloroform during managed aquifer recharge (MAR)

Chlorination is an effective method to protect the safety of groundwater systems during managed aquifer recharge. However, chlorination leads to the formation of disinfection by-products, whose behavior in aquifers remains unclear and has caused public concern. In this study, an in-site test was performed on an anoxic aquifer in Shouguang City, China, to investigate the formation and transformation of chloroform during managed aquifer recharge. The field tests showed that the formation of chloroform in groundwater caused by the recharge of chlorinated water, and that the fate of chloroform was affected by adsorption and biodegradation. The retardation factor was 1.27, and the half-life was 29 days. The formation and transformation of chloroform during continuous recharge under different hydrochemical conditions was further investigated by batch experiments. These experiments showed that the formation of chloroform increased with contact time, tended to be stable after 10 h, and was facilitated by high chloride/TOC ratios, high pH, and low ionic strength (IS) for a given contact time. The adsorption experiments showed that the process accords with the pseudo-second-order kinetic equations and the Freundlich model. The adsorption capacity was pH dependent (1.01-1.66 μg/g at pH 5 and 2.17-3.05 μg/g at pH 9). Increasing the IS promotes adsorption. The results from biodegradation experiments indicated that the biodegradation was well fitted by the Monod equation. The retardation factor in the batch experiments was close to that of the field test, but the half-life was less than the field test. This is mainly due to the difference in the concentration of dissolved oxygen.

Survey of hazardous organic compounds in the groundwater, air and wastewater effluents near the Tehran automobile industry

Potential of wastewater treatment in car industry and groundwater contamination by volatile organic compounds include perchloroethylene (PCE), trichloroethylene (TCE) and dichloromethane (DCM) near car industry was conducted in this study. Samples were collected in September through December 2011 from automobile industry. Head-space Gas chromatography with FID detector is used for analysis. Mean PCE levels in groundwater ranged from 0 to 63.56 μg L(-1) with maximum level of 89.1 μg L(-1). Mean TCE from 0 to 76.63 μg L(-1) with maximum level of 112 μg L(-1). Due to the data obtained from pre treatment of car staining site and conventional wastewater treatment in car factory, the most of TCE, PCE and DCM removed by pre aeration. Therefor this materials entry from liquid phase to air phase and by precipitation leak out to the groundwater. As a consequence these pollutants have a many negative health effect on the workers by air and groundwater.

A green strategy for desorption of trihalomethanes adsorbed by humin and reuse of the fixed bed column

The objective of the present work was to develop a thermal desorption method for the removal of trihalomethanes (THM) adsorbed by humin, followed by multiple recycling of the fixed bed column in order to avoid excessive consumption of materials and reduce operating costs. The results obtained for adsorption on a fixed bed column confirmed the effectiveness of humin as an adsorbent, extracting between 45.9% and 90.1% of the total THM (TTHM). In none of the tests was the column fully saturated after 10h. Experiments involving thermal desorption were used to evaluate the potential of the technique for column regeneration. The adsorptive capacity of the humin bed increased significantly (p<0.05) between the first and fifth desorption cycle, by 18.9%, 18.1%, 24.2%, 20.2% and 24.2% for CHBr(3), CHBr(2)Cl, CHBrCl(2), CHCl(3) and TTHM, respectively.

Detection of halogenated organic compounds using immobilized thermophilic dehalogenase

Environmental pollutants containing halogenated organic compounds can cause a plethora of health problems. Detection, quantification, and eventual remediation of halogenated pollutants in the environment are important to human well-being. Toward this end, we previously identified a haloacid dehalogenase, L-HAD(ST), from the thermophile Sulfolobus tokodaii. This thermophilic enzyme is extremely stable and catalyzes, stereospecifically, the dehalogenation of L-2-haloacids. In the current study, we covalently linked L-HAD(ST) to an N-hydroxysuccinimidyl Sepharose resin to construct a highly specific sensor with long shelf life for the detection of L-2-haloacids. The enzyme-modified resin was packed into disposable columns. Samples containing L-2-haloacids were first incubated in the column, and were then collected to quantify the chloride produced through the breakdown of the substrate. The optimum pH of the immobilized enzyme is around 9.5, similar to that of the soluble protein. Its catalytic activity increased with temperature up to the highest temperature measured (50 degrees C). The resin could be fully regenerated after multiple reaction cycles and retained 70% of the initial activity after being stored at 4 degrees C for 6 months. The L-HAD(ST)-modified resin could be used to breakdown and quantify L-2-haloacids spiked in the simulated environmental samples, indicating dehalogenases from extremophiles can potentially be employed in the detection and decontamination of L-2-haloacids.

Monitoring the formation of trihalomethanes in the effluents from a shrimp hatchery

Formation of trihalomethanes (THM) was monitored at the Laboratório de Camarões Marinhos (LCM) from the Universidade Federal de Santa Catarina. THM could be present because chlorinated effluents from disinfection are discharged from the different hatchery rooms. THM quantification was done through an analytical methodology using Purge&Trap coupled with a gas chromatograph equipped with an electron capture detector. Relative standard deviation (RSD), limit of detection (LOD) and limit of quantification (LOQ) for the methodology corresponded to the ranges of 8-17%; 0.01-0.03 microg L(-1) and 0.03-0.08 microg L(-1), respectively. Linear working range was of 0.1-8.0 microg L(-1) for all compounds. Enrichment and recovery method was applied to evaluate possible matrix effects and the results varied from 71.2% to 107.9%. LCM was monitored between August and December, 2004. This study showed that THM did not increase with the increase in postlarvae production and also that the aquatic life and the surrounding environment were not affected.

Simultaneous determination of methyl tert-butyl ether, its degradation products and other gasoline additives in soil samples by closed-system purge-and-trap gas chromatography–mass spectrometry

A new protocol for the simultaneous determination of methyl tert-butyl ether (MTBE); its main degradation products: tert-butyl alcohol (TBA) and tert-butyl formate (TBF); other gasoline additives, oxygenate dialkyl ethers: ethyl tert-butyl ether (ETBE), tert-amyl methyl ether (TAME) and diisopropyl ether (DIPE); aromatics: benzene, toluene, ethylbenzene and xylenes (BTEX) and other compounds causing odour events such as dicyclopentadiene (DCPD) and trichloroethylene (TCE) in soils has been developed. On the basis of US Environmental Protection Agency (EPA) method 5035A, a fully automated closed-system purge-and-trap coupled to gas chromatography/mass spectrometry (P&T-GC/MS) was optimised and permitted to detect microg/kg concentrations in solid matrices avoiding losses of volatile compounds during operation processes. Parameters optimised were the sampling procedure, sample preservation and storage, purging temperature, matrix effects and quantification mode. Using 5 g of sample, detection limits were between 0.02 and 1.63 microg/kg and acceptable method precision and accuracy was obtained provided quantification was performed using adequate internal standards. Soil samples should be analysed as soon as possible after collection, stored under -15 degrees C for not longer than 7 days if degradation products have to be analysed. The non-preservative alternative (empty vial) provided good recoveries of the most analytes when freezing the samples up to 7 day holding time, however, if biologically active soil are analysed the preservation with trisodium phosphate dodecahydrate (Na(3)PO(4).12H(2)O or TSP) is strongly recommended more than sodium bisulphate (NaHSO(4)). The method was finally applied to provide threshold and background levels of several gasoline additives in a point source and in sites not influenced by gasoline spills. The proposed method provides the directions for the future application on real samples in current monitoring programs at gasoline pollution risk sites where till now little monitoring data for MTBE in soils are available.

Sorption study of 25 volatile organic compounds in several Mediterranean soils using headspace–gas chromatography–mass spectrometry

A sorption study of 25 volatile organic compounds (VOCs) in different agricultural soils was carried out by using headspace-gas chromatography-mass spectrometry. The extraction of the VOCs from soil samples was carried out following the EPA method with some differences such as addition of potassium chloride and different instrumental conditions which provide higher sample throughput. In addition, a complementary study on several procedures for soil fortification with VOCs was also assayed, fortification with minimal sample handling was selected in order to minimise evaporation losses of the VOCs. The effect of clay minerals (7.0-69.7%) and organic carbon (0.2-3.5%) contents on acid and alkaline (pH 5.3-8.8) soils were evaluated. Based on the results, all compounds assayed were more sorbed in alkaline soils than acid ones; chlorobenzenes interact more strongly with agricultural soils than do alkylbenzenes. The organic carbon content affects the sorption of 25 VOCs in alkaline soils (the highest sorption was found for the most organic soil), while in acid soils VOC sorption increases as the organic carbon content decreases. The clay mineral fraction plays an important role in the sorption of VOCs in acid soil owing to pi-/n-electron interactions, this effect being more marked for chlorobenzenes.