An ultrasensitive post chemiluminescence reaction of ammonium in NBS–dichlorofluorescein system and its application

Ultrafast capillary electrophoresis method for the simultaneous determination of ammonium and diphenhydramine in pharmaceutical samples

Ammonium and diphenhydramine are active ingredients commonly found in the same pharmaceutical preparations. We report, for the first time, a sub-minute method for the simultaneous determination of ammonium and diphenhydramine. The method is based on capillary electrophoresis with capacitively coupled contactless conductivity detection. Both analytes can be quantified in a single run (∼80 injections/h) using 30 mmol/L 2-(N-morpholino)ethanesulfonic acid and 15 mmol/L lithium hydroxide (pH 6.0) as background electrolyte. The separation by capillary electrophoresis was achieved on a fused-silica capillary (50 cm total length, 10 cm effective length, and 50 μm inside diameter). The limits of detection were 0.04 and 0.02 mmol/L for ammonium and diphenhydramine, respectively. The proposed method also provided adequate recovery values for spiked samples (100-106 and 97-104% for ammonium and diphenhydramine, respectively). The results obtained with the new capillary electrophoresis method were compared with those of the high-performance liquid chromatography method for diphenhydramine and the Kjeldahl method for ammonium and no statistically significant differences were found (95% confidence level).

Flow-injection post-chemiluminescence method for the determination of palmatine

A post-chemiluminescence (PCL) phenomenon was observed when palmatine was injected in a mixture of N-bromosuccinimide (NBS) and alkaline dichlorofluorescein (DCF) after the chemiluminescence (CL) reaction of NBS-alkaline DCF had finished. Based on the PCL reaction, a rapid and sensitive method for the determination of palmatine was established. Under optimum conditions, the CL intensity was linear, with the concentration of palmatine in the range of 5.0 × 10(-9) to 1.0 × 10(-6) M. The detection limit was 6.0 × 10(-10) M for palmatine. The relative standard deviation for 11 parallel measurements of 1.0 × 10(-7) M palmatine was 1.5%. This method was applied to the determination of palmatine in pharmaceutical samples and biological fluids, with satisfactory results. The possible reaction mechanism is discussed briefly.