Electrospun fibrous thin film microextraction coupled with desorption corona beam ionization-mass spectrometry for rapid analysis of antidepressants in human plasma

Coupling Miniaturized Stir Bar Sorptive Dispersive Microextraction to Needle-Based Electrospray Ionization Emitters for Mass Spectrometry: Determination of Tetrahydrocannabinol in Human Saliva as a Proof of Concept

Direct coupling of sample preparation with mass spectrometry (MS) can speed up analysis, enabling faster decision-making. In such combinations, where the analysis time is mainly defined by the extraction procedure, magnetic dispersive solid-phase extraction emerges as a relevant technique because of its rapid workflow. The dispersion and retrieval of the magnetic sorbent are typically uncoupled stages, thus reducing the potential simplicity. Stir bar sorptive dispersive microextraction (SBSDME) is a novel technique that integrates both stages into a single device. Its miniaturization (mSBSDME) makes it more portable and compatible with low-availability samples. This article reports the direct combination of mSBSDME and MS using a needle-based electrospray ionization (NESI) emitter as the interface. This combination is applied to determine tetrahydrocannabinol in saliva samples, a relevant societal problem if the global consumption rates of cannabis are considered. The coupling requires only the transference of the magnet (containing the sorbent and the isolated analyte) from the mSBSDME to the hub of a hypodermic needle, where the online elution occurs. The application of 5 kV on the needle forms an electrospray on its tip, transferring the ionized analyte to the MS inlet. The excellent performance of mSBSDME-NESI-MS/MS relies on the sensitivity (limits of detection as low as 2.25 ng mL-1), the precision (relative standard deviation lower than 15%), and the accuracy (relative recoveries ranged from 87 to 127%) obtained. According to the results, the mSBSDME-NESI-MS/MS technique promises faster and more efficient chemical analysis in MS-based applications.

Natural cotton fiber-supported liquid extraction for convenient protein-rich aqueous sample preparation: Determination of glucocorticoids in milk and plasma as a proof-of-concept study

Protein-rich aqueous samples such as milk and plasma usually require complex sample preparation steps prior to instrumental analysis. This study proposed a novel cotton fiber-supported liquid extraction (CF-SLE) method for convenient sample preparation. Natural cotton fiber was directly loaded into a syringe tube to conveniently construct the extraction device. No filter frits were required due to the fibrous feature of the cotton fibers. The cost of the extraction device was less than 0.5 CNY, and the costly syringe tube could be easily reused to decrease the cost further. Extraction used a simple two-step protocol: protein-rich aqueous sample loading and elution. Emulsification and centrifugation steps involved in the classic liquid-liquid extraction were avoided. As a proof-of-concept study, the glucocorticoids in milk and plasma were extracted with satisfactory extraction recoveries. Coupled with liquid chromatography-tandem mass spectrometry, a sensitive quantification method was established with excellent linearity (R² > 0.991) as well as good accuracy (85.7-117.3%) and precision (<14.3%). This system is simple, low-cost, reproducible, and easy to automate. Thus, the proposed CF-SLE method is promising for the routine sample preparation of protein-rich aqueous samples prior to instrumental analysis.

Coupling in-syringe kapok fiber-supported liquid-phase microextraction with flow injection-mass spectrometry for rapid and green biofluid analysis: Determination of antidepressants as an example

Quantification of substances in biofluid samples (e.g., urine, blood, and cerebrospinal fluids) are useful for clinical diagnosis. In current study, a rapid and green strategy by coupling in-syringe kapok fiber-supported liquid-phase microextraction with flow-injection mass spectrometry was proposed. The natural kapok fiber was used as an oily extraction solvent (e.g., n-octanol) support material, and an in-syringe extraction device was conveniently constructed. The whole extraction processes, including sampling, washing and desorption, were conveniently conducted by simply pulling/pushing the syringe plunger, enabling rapid analyte enrichment and sample purification. The follow-up flow injection-mass spectrometry detection enabled rapid and high throughput analysis. As an example, the proposed method was applied to analyze antidepressants in plasma/urine, showing satisfied linearities (R² ≥0.993) in ranges of 0.2-1000 ng/mL. By employing the in-syringe extraction method prior to flow injection-mass spectrometry detection, the LOQs in plasma and urine were reduced by 25-80 folds and 5-25 folds, respectively. Besides, by employing ethanol and 80% ethanol as the desorption solvent and carrier solvent, respectively, the analytical method showed excellent greenness. In general, the integrated method provides a promising choice for rapid and green biofluid analysis.

Self-rotating stir mesh screen sorptive extraction for analyzing chlorpyrifos by ion mobility spectrometry

A mesh screen was electrochemically coated with polypyrrole and used as a sorptive extractor device, for the first time. This configuration acts in such a way that it is self-rotating in the presence of a magnetic force and can be used for extraction and concentration of analytes. Actually, applying a mesh screen instead of a bar or plate in sorptive extraction provided a more effective contact area between the sorptive materials and sample solution, resulting in higher sorption efficiency. The device performance was assessed by using chlorpyrifos pesticide as a model analyte. A thermal desorption unit was coupled to an ion mobility spectrometer and applied for evaporating the extracted analyte. Different parameters affecting the extraction efficiency during the electro-polymerization and the extraction process, including the time of electrodeposition, the concentration of pyrrole, oxalic acid and salt, temperature and time of extraction, and the stirring rate of the extractor device were investigated and optimized, simultaneously. The detection and quantification limits of the method were calculated to be 0.035 and 0.1 μg L^-1, respectively. The linear dynamic range obtained was from 0.1 to 20 μg L^-1, with a determination coefficient of 0.9984. The intra-day and inter-day-relative standard deviations (RSD, n = 3) were lower than 3% and 8%, respectively. Under the optimal conditions, the absolute recovery and the enrichment factor were found to be 97% and 5820, respectively. Finally, the relative recoveries of the proposed method were calculated to be in the range of 86-111% for spiked water, wastewater, and apple samples. The results obtained from the method were validated by EPA method 622.

Magnetic solid-phase extraction coupled with UHPLC-MS/MS for four antidepressants and one metabolite in clinical plasma and urine samples

Aim: Routine therapeutic drug monitoring is highly recommended since common antidepressant combinations increase the risk of drug-drug interactions or overlapping toxicity. Materials & methods: A magnetic solid-phase extraction by using C₁₈-functionalized magnetic silica nanoparticles (C₁₈-Fe₃O₄@SiO₂ NPs) as sorbent was proposed for rapid extraction of venlafaxine, paroxetine, fluoxetine, norfluoxetine and sertraline from clinical plasma and urine samples followed by ultra-HPLC-MS/MS assay. Results: The synthesized C₁₈-Fe₃O₄@SiO₂ NPs showed high magnetization and efficient extraction for the analytes. After cleanup by magnetic solid-phase extraction, no matrix effects were found in plasma and urine matrices. The analytes showed LODs among 0.15-0.75 ng ml^-1, appropriate linearity (R ≥ 0.9990) from 2.5 to 1000 ng ml^-1, acceptable accuracies 89.1-110.9% with precisions ≤11.0%. The protocol was successfully applied for the analysis of patients' plasma and urine samples. Conclusion: It shows high potential in routine therapeutic drug monitoring of clinical biological samples.

Recent advances in mixed-mode chromatographic stationary phases

Mixed-mode phases have become very popular in the last decade, and the number of new mixed/multi-mode sorbents is growing fast. Unlike single-mode stationary phases, perfectly suited for the separation of the analytes possessing similar physicochemical properties, for instance reversed-phase chromatography for hydrophobic solutes, mixed-mode sorbents providing multimodal interactions can render better separation selectivity for complex mixtures of solutes differing significantly in their physicochemical characteristics. The most frequent modern mixed-mode stationary phases are di/tri-mode sorbents embracing the following interactions, hydrophobic, electrostatic (coulombic), and hydrophilic. According to their structures, it is possible to distinguish silica-based, polymer-based, hybrid, and monolithic mixed-mode stationary phases. Herewith, newly synthesized mixed-mode sorbents developed within the last two and half years are categorized, discussed, and summarized. The main attention is devoted to the description of the synthetic routes and characterization methods applied for the new stationary phases.

Sniffing with mass spectrometry

Gaseous compounds are usually on-line detectable on sensors. The limitations of conventional sensors are suffering from incapability for exactly identifying multiple components as well as incompatibility to possible toxicants in every odor sample. Herein, we discuss an inlet modification to the laboratory standard mass spectrometer, inspired by the sensitive olfactory systems of animals, for direct sniffing, established by connecting a mini pump to the nebulizer gas tubing. The modified mass spectrometry method-sniffing-mass spectrometry (sniffing-MS)-can acquire detailed fingerprint spectra of mixed odors and shows high tolerance to toxicants. Furthermore, the method has a low limit of detection in the order of parts per trillion and is a 'sampling-free' technique for analyzing various gaseous compounds simultaneously, thus offering versatility for smelling daily commodities, tracking diffusion, and locating position of odors. Sniffing-MS can mimic or even surpass the olfaction of animals and is applicable for analyzing gaseous/volatile compounds, especially those polar compounds, in a simple manner depending on the intrinsic molecular mass-to-charge ratio.

Magnesium-aluminum-layered double hydroxide-graphene oxide composite mixed-matrix membrane for the thin-film microextraction of diclofenac in biological fluids

Herein, the applicability of Mg-Al-layered double hydroxide-graphene oxide (LDH/GO) mixed-matrix membrane (MMM) for microextraction purposes is reported for the first time. The LDH/GO MMM was used as sorbent for the thin film microextraction (TFME) of diclofenac in human body fluids. The prepared LDH/GO composite has been incorporated into a mechanically stable polyvinylidene difluoride (PVDF) membrane. The contribution of GO in LDH/GO composites significantly improved the extraction efficiency of the TFME sorbent. After elution with methanol, diclofenac was quantified by high performance liquid chromatography-ultraviolet detection (HPLC-UV). Plackett-Burman design was used for screening the experimental factors of interest and specify the significant variables affecting the extraction efficiency. The effective factors were optimized using Box-Behnken design (BBD). Under the optimum conditions, limits of detections (LODs) were 0.14, 0.23 and 0.57 μg L^-1 in water, urine and plasma samples, respectively. Limits of quantifications (LOQs) were 0.46, 0.76 and 1.8 μg L^-1 in water, urine and plasma samples, respectively. Relative standard deviations (RSDs) at a spiked concentration of 10 μg L^-1 were 6.7, 6.9 and 7.1% (as intra-day RSD) in water, urine and plasma samples, respectively. The linear dynamic ranges (LDRs) were in the range of 0.5-200 μg L^-1. The applicability of the method was investigated by the extraction and determination of diclofenac in different biological fluids including urine and plasma samples.

Carbon Nanohorn Suprastructures on a Paper Support as a Sorptive Phase

This article describes a method for the modification of paper with single-wall carbon nanohorns (SWCNHs) to form stable suprastructures. The SWCNHs form stable dahlia-like aggregates in solution that are then self-assembled into superior structures if the solvent is evaporated. Dipping paper sections into a dispersion of SWCNHs leads to the formation of a thin film that can be used for microextraction purposes. The coated paper can be easily handled with a simple pipette tip, paving the way for disposable extraction units. As a proof of concept, the extraction of antidepressants from urine and their determination by direct infusion mass spectrometry is studied. Limits of detection (LODs) were 10 ng/L for desipramine, amitriptyline, and mianserin, while the precision, expressed as a relative standard deviation, was 7.2%, 7.3%, and 9.8%, respectively.