Ultrasensitive detection of explosives and chemical warfare agents by low-pressure photoionization mass spectrometry

Ultrasensitive detection of trace chemical warfare agent-related compounds by thermal desorption associative ionization time-of-flight mass spectrometry

A thermal desorption associative ionization time-of-flight mass spectrometer was developed for ultrasensitive detection of semi-volatile chemical warfare agents (CWAs). The excited-state CH₂Cl₂-induced associative ionization method presented a soft ionization characterization and an excellent sensitivity towards CWAs. The detection sensitivities of the investigated nine CWA-related substances were 2.56 × 10⁵-5.01 × 10⁶ counts ng^-1 in a detection cycle (30 s or 100 s). The corresponding 3σ limits of detection (LODs) were 0.08-3.90 pg. Compared with the best-documented LODs via the dielectric barrier discharge ionization (DBDI) and secondary electrospray ionization (SESI), the obtained LODs of the investigated compounds were improved by 2-76 times. Additionally, the measured sensitivity of 2-Chloroethyl ethyl, a proxy for mustard gas, is 550 counts pptv^-1, which exceeds the DBDI and SESI's corresponding values (4.4 counts pptv^-1 and 6.5 counts pptv^-1) nearly by two orders of magnitude. A field application simulation was conducted by putting a strip of PTFE film contaminated with the CWA-related agent into the thermal desorption unit. The simulation showed that the sensitivities of the instrument via swipe surveying could achieve 2.19 × 10⁵ to 5.23 × 10⁶ counts ng^-1. The experimental results demonstrate that the excited-state CH₂Cl₂-induced associative ionization is an ultrasensitive ionization method for CWAs and reveal a prospect for improving the detection of CWA species future.

Development of membrane inlet photoionization ion trap mass spectrometer for trace VOCs analysis

With the development of instrumental miniaturization, the portable mass spectrometer is becoming a new tool for on-site rapid analysis of environmental samples. Membrane inlet (MI) and photoionization (PI) are two commonly used sampling and ionization techniques, respectively, as they both exhibit detection selectivity for volatile organic compounds (VOCs). In this paper, a membrane inlet photoionization ion trap mass spectrometer was developed for the direct analysis of VOCs in gaseous samples. With the new structure and timing design, various operation modes were proposed and tested. In particular, the use of pulse carrier gas can integrate the appropriate pressure conditions required by each module, thus improving the efficiency of analyte transport, ionization, and mass analysis. The detection limit of sub-ppb was obtained, and the response time can be greatly reduced by increasing the sample flow rate. Furthermore, the capability of selective enrichment for organic analytes was also realized by using a special accumulation mode with a modified sequence, which is easy to operate because no additional devices are needed.

Detection of Organophosphorous Chemical Agents with CuO-Nanorod-Modified Microcantilevers

Microcantilevers are really promising sensitive sensors despite their small surface. In order to increase this surface and consequently their sensitivity, we nanostructured them with copper oxide (CuO) nanorods. The synthesis of the nanostructure consists of the oxidation of a copper layer deposited beforehand on the surface of the sample. The oxidation is performed in an alkaline solution containing a mixture of Na(OH) and (NH4)2S2O8. The synthesis procedure was first optimized on a silicon wafer, then transferred to optical cantilever-based sensors. This transfer requires specific synthesis modifications in order to cover all the cantilever with nanorods. A masking procedure was specially developed and the copper layer deposition was also optimized. These nanostructured cantilevers were engineered in order to detect vapors of organophosphorous chemical warfare agents (CWA). The nanostructured microcantilevers were exposed to various concentration of dimethyl methylphosphonate (DMMP) which is a well-known simulant of sarin (GB). The detection measurements showed that copper oxide is able to detect DMMP via hydrogen interactions. The results showed also that the increase of the microcantilever surface with the nanostructures improves the sensors efficiency. The evolution of the detection performances of the CuO nanostructured cantilevers with the DMMP concentration was also evaluated.

Ultrasensitive detection of volatile aldehydes with chemi-ionization-coupled time-of-flight mass spectrometry

The chemi-ionization reaction is a high-efficiency pathway to produce molecular ions in plasma, however, it has rarely been applied in mass spectrometry to directly produce analyte ions. In this study, a novel chemi-ionization technique for mass spectrometry was applied for the direct and ultrasensitive detection of gaseous aldehydes. The ionization technique was enacted by a recently observed chemi-ionization reaction: the efficient proton transfer from H₂O to oxygenated compounds was stimulated by vacuum ultraviolet (VUV)-excited CH₂Cl₂. By analyzing a series of aliphatic aldehydes (C2-C5) and benzaldehyde with different proton affinities (PAs) and polarities, the ionization features of the new ionization method were investigated for the first time. The chemi-ionization of aldehydes presented soft ionization characteristics with fragmentation patterns analogous to that of VUV photoionization. The method showed ultrahigh sensitivities toward aldehydes (up to 1108 ± 6 counts pptv^-1 for benzaldehyde in 10 s acquisition time). The corresponding 3σ limits of detection (LODs) achieved 0.30-0.69 pptv, which are equivalent of 1.35-1.92 ng m^-3, for the compounds investigated. The humidity experiments revealed that the moisture in the sample gas had an evident impact on the detection efficiency of the analyte and the influence was PA dependent. In addition, the applicability of this ionization mode was further tested by analysis of aldehydes in cigarette smoke. This study provides a promising ionization method for greatly improving the current on-line detection sensitivity of volatile aldehydes.

Single photon ionization time-of-flight mass spectrometry with a windowless RF-discharge lamp for high temporal resolution monitoring of the initial stage of methanol-to-olefins reaction

Methanol-to-olefins (MTO) is a very important industrial catalysis technique for the production of light olefins, which is of great economic value and strategic significance. However, it is a great challenge for the traditional analytical methods to obtain the real-time information of product variation during MTO reaction process, which is vital for the conversion process research and mechanism explanation. In this study, a single photon ionization time-of-flight mass spectrometry (SPI-TOFMS) based on a windowless RF-discharge (WLRF) lamp was developed for real-time measurement of catalytic product during the initial stage of MTO reaction. The vacuum ultraviolet (VUV) photon energy was easily adjusted by changing the discharge gas. Argon (Ar) gas was eventually adopted as the discharge gas, since it produces photons with appropriate energy of 11.6 eV and 11.8 eV for ionization of light olefin molecules. The detection sensitivities of ethylene and propylene were largely improved to a substantially similar level with limits of detection (LODs) down to 16.98 and 9.64 ppbv, respectively. The initial stage of MTO reaction was real-time monitored with a high temporal resolution of 0.5 s, revealing that ethylene was the first olefin product followed by propylene. The successful application of WLRF-SPI-TOFMS in the monitoring of MTO catalytic process indicated broad application prospects of this instrument in the industrial reaction process monitoring.

Recent Developments in Spectroscopic Techniques for the Detection of Explosives

Trace detection of explosives has been an ongoing challenge for decades and has become one of several critical problems in defense science; public safety; and global counter-terrorism. As a result, there is a growing interest in employing a wide variety of approaches to detect trace explosive residues. Spectroscopy-based techniques play an irreplaceable role for the detection of energetic substances due to the advantages of rapid, automatic, and non-contact. The present work provides a comprehensive review of the advances made over the past few years in the fields of the applications of terahertz (THz) spectroscopy; laser-induced breakdown spectroscopy (LIBS), Raman spectroscopy; and ion mobility spectrometry (IMS) for trace explosives detection. Furthermore, the advantages and limitations of various spectroscopy-based detection techniques are summarized. Finally, the future development for the detection of explosives is discussed.

Protonation enhancement by dichloromethane doping in low-pressure photoionization

Doping has been used to enhance the ionization efficiency of analytes in atmospheric pressure photoionization, which is based on charge exchange. Compounds with excellent ionization efficiencies are usually chosen as dopants. In this paper, we report a new phenomenon observed in low-pressure photoionization: Protonation enhancement by dichloromethane (CH2Cl2) doping. CH2Cl2 is not a common dopant due to its high ionization energy (11.33 eV). The low-pressure photoionization source was built using a krypton VUV lamp that emits photons with energies of 10.0 and 10.6 eV and was operated at ~500-1000 Pa. Protonation of water, methanol, ethanol, and acetaldehyde was respectively enhanced by 481.7 ± 122.4, 197.8 ± 18.8, 87.3 ± 7.8, and 93.5 ± 35.5 times after doping 291 ppmv CH2Cl2, meanwhile CH2Cl2 almost does not generate noticeable ions itself. This phenomenon has not been documented in the literature. A new protonation process involving in ion-pair and H-bond formations was proposed to expound the phenomenon. The observed phenomenon opens a new prospect for the improvement of the detection efficiency of VUV photoionization.

Analysis of 62 synthetic cannabinoids by gas chromatography-mass spectrometry with photoionization

Gas chromatography–mass spectrometry (GC–MS) in electron ionization (EI) mode is one of the most commonly used techniques for analysis of synthetic cannabinoids, because the GC–EI-MS spectra contain characteristic fragment ions for identification of a compound; however, the information on its molecular ions is frequently lacking. To obtain such molecular ion information, GC–MS in chemical ionization (CI) mode is frequently used. However, GC–CI-MS requires a relatively tedious process using reagent gas such as methane or isobutane. In this study, we show that GC–MS in photoionization (PI) mode provided molecular ions in all spectra of 62 synthetic cannabinoids, and 35 of the 62 compounds showed only the molecular radical cations. Except for the 35 compounds, the PI spectra showed very simple patterns with the molecular peak plus only a few fragment peak(s). An advantage is that the ion source for GC–PI-MS can easily be used for GC–EI-MS as well. Therefore, GC–EI/PI-MS will be a useful tool for the identification of synthetic cannabinoids contained in a dubious product. To the best of our knowledge, this is the first report to use GC–PI-MS for analysis of synthetic cannabinoids.