Zinc(II)-based metal–organic nanotubes coating for high sensitive solid phase microextraction of nitro-polycyclic aromatic hydrocarbons

Incorporation of Cu-TATAB metal-organic framework within polyurethane nanocomposite for enhanced thin film microextraction of some chlorinated pesticides

In this research, electrospun nanofibers based on copper-based metal organic framework (MOF)/polyurethane (PU) were prepared in order to achieve an applicable and superior extractive phase. The incorporation of MOF, in the synthesized nanocomposite contributed to the enhanced sorption efficiency. The prepared sorbent was implemented for the thin film microextraction (TFME) of target compounds with subsequent quantification using gas chromatography-mass spectrometry (GC-MS). To obtain the maximum efficiency of the synthesized sorbent, the influential parameters on extraction and desorption steps, including the MOF percentage in nanocomposite, desorption solvent type and its volume, desorption time, solution ionic strength and extraction time were optimized. After method development, the linear dynamic range (0.02-700 μg L-1), limits of detection (LODs) (0.005-0.1 μg L-1) and limits of quantification (LOQs))0.02-0.33 μg L-1(were calculated. The relative standard deviations values for intra-day and inter-day analysis were found to be in the range of 4.3-5.3 % and 6.2-8.1 %, respectively. The developed method was validated for the TFME of model organochlorine (OC) pesticide residues in fish, soil and water samples. the recovery values for the spiked samples at two concentration levels of 5 and 100 µg l-1 were found in the range of 72-110 %.

Development of magnetic solid phase extraction based on magnetic chitosan-graphene oxide nanoparticles and deep eutectic solvents for the determination of flavonoids by high performance liquid chromatography

An environmentally friendly magnetic solid phase extraction method was developed based on magnetic chitosan-graphene oxide nanoparticles and deep eutectic solvents (DESs) for the pre-concentration and isolation of flavonoids (apigenin, morin, naringenin, and quercetin) of natural orange juice, commercial apple juice, onion juice, green tea, and natural apple juice samples. DESs via hydrophilic and π-π interactions could increase the extraction performance. The immobilization of chitosan-graphene oxide on the surface of Fe₃O₄ nanoparticles improved their chemical properties and mechanical stability. In addition, the prepared magnetic nanoparticles with the hydrophilic polymeric network and the high surface area of the graphene oxide increased the access of binding sites and extraction performance. The use of DESs as desorption of solvent and the individual properties of MANPs provided the ability for high extraction recovery and accelerates the time to reach equilibrium. The principal variables that influence microextraction efficiency, including the extraction time, type of DES, stirring rate, desorption time, type of eluent solvent, and pH of the sample solution, were screened via the Plackett-Burman design and then the variables were optimized by the Box-Behnken design. Under the optimum conditions obtained, the developed method showed a good working range (R² ≥ 0.9962). The limit of detection (LOD) and the limit of quantification (LOQ) ranged from 0.03 μg L^-1 (morin) to 0.14 μg L^-1 (naringenin) and from 0.09 μg L^-1 (morin) to 0.46 μg L^-1 (naringenin) variables, respectively. The intraday precision was in the range of 4.1-4.8. In order to experiment with the precision and applicability of the MSPE-DES method, spiking recovery studies were performed in beverages and vegetable samples (natural orange juice, onion juice, commercial apple juice, natural apple juice, and green tea). The recovery results for real samples were calculated as 90-102%.

High crystalline magnetic covalent organic framework with three-dimensional grapevine structure for ultrasensitive extraction of nitro-polycyclic aromatic hydrocarbons in food and environmental samples

Developing and establishing an efficient pre-treatment approach for the precise extraction of nitrated-polycyclic aromatic hydrocarbons (N-PAHs) from real-life samples is critical for ensuring their safety. In this study, a novel crystalline magnetic covalent organic framework with a grapevine structure not a single core-shell, Fe₃O₄@TAPT-DMTA-COF, was fabricated via chemical bonding. Unchanging the reticulated structure and high crystallinity of TAPT-DMTA-COF, the combination made this material possess not only simple operation via magnetic decantation but also remarkable chemical stability. Fe₃O₄@TAPT-DMTA-COF had a large surface area (1578.45 m²/g), and rich electronegative triazine-groups, which makes it become a superior magnetic enrichment material for trace N-PAHs. For N-PAHs analysis, low limits of detection (LODs) (1.43-17.24 ng/L), excellent relative standard deviations (RSDs ≤ 11.52%), and wide linearity (10-5000 ng/L) were obtained. Real-life applications based on this composite have been successfully explored by capturing the N-PAHs emitted from food and environmental samples.

Quantitation of ultra-trace nitrated polycyclic aromatic hydrocarbons isomers in water by online solid-phase extraction coupled-liquid chromatography-mass spectrometry

An online solid-phase extraction (SPE)-coupled liquid chromatography-mass spectrometry (LC-MS) method was established for the determination of 10 nitrated polycyclic aromatic hydrocarbons (nitro-PAHs) in water. Water samples were mixed with methanol to generate 40% methanol solutions (v/v), and filtered by 0.45 μm membrane. The filtration with polytetrafluoroethylene(PTFE) membrane got higher recovery rates than nylon membrane, especially for 4-ring and 5-ring nitro-PAHs. 2.5 mL solution was directly injected into online SPE flow path to allow for online purification and enrichment of target analytes in the SPE column. The nitro-PAHs eluted from the SPE column were automatically transferred to the analytical flow path by a well-designed valve-switching system. With the optimization of LC and MS condition, ten nitro-PAH isomers was separated and detected from each other by LC-MS/MS with negative atmospheric pressure chemical ionization (APCI). It was firstly found that nitro-PAHs could produce strong [M-H]^- precursor ions in the primary MS besides [M+e]^- and [M+15]^-. In the secondary MS, the precursor ions mainly lose NO neutral molecule (30 Daltons) to produce daughter ions. The online SPE and LC-MS analysis process was completed in 15.5 min. The linear correlation coefficients of 10 nitro-PAH standard curves were higher than 0.99. The detection limits of nitro-PAHs were about 1.2~22.2 ng/L (S/N=3). The intra-day and inter-day reproducibility (RSD, n=6) were 1.6%~8.4% and 5.3%~16.9%, respectively. The recoveries of 10, 40 and 200 ng/L in tap water were 71.7%~106.4%, 79.7%~100.9% and 73.0%~105.5%, with the corresponding RSD of 2.4%~10.5%, 2.1%~8.6% and 2.7%~6.2%, respectively.

Critical review of micro-extraction techniques used in the determination of polycyclic aromatic hydrocarbons in biological, environmental and food samples

Polycyclic Aromatic Hydrocarbons (PAHs) are ubiquitous environmental contaminants and their accurate determination is very important to human health and environment safety. In this review, sorptive-based micro-extraction techniques [such as Solid-Phase Micro-extraction (SPME), Stir Bar Sorptive Extraction (SBSE), Micro-extraction in Packed Sorbent (MEPS)] and solvent-based micro-extraction [Membrane-Mediated Liquid-Phase Micro-extraction (MM-LPME), Dispersive Liquid-Liquid Micro-extraction (DLLME), and Single Drop Micro-extraction (SDME)] developed for quantification of PAHs in environmental, biological and food samples are reviewed. Moreover, recent micro-extraction techniques that have been coupled with other sample extraction strategies are also briefly discussed. The main objectives of these micro-extraction techniques are to perform extraction, pre-concentration and clean up together as one step, and the reduction of the analysis time, cost and solvent following the green chemistry guidelines.

Recent Applications and Newly Developed Strategies of Solid-Phase Microextraction in Contaminant Analysis: Through the Environment to Humans

The present review aims to describe the recent and most impactful applications in pollutant analysis using solid-phase microextraction (SPME) technology in environmental, food, and bio-clinical analysis. The covered papers were published in the last 5 years (2014–2019) thus providing the reader with information about the current state-of-the-art and the future potential directions of the research in pollutant monitoring using SPME. To this end, we revised the studies focused on the investigation of persistent organic pollutants (POPs), pesticides, and emerging pollutants (EPs) including personal care products (PPCPs), in different environmental, food, and bio-clinical matrices. We especially emphasized the role that SPME is having in contaminant surveys following the path that goes from the environment to humans passing through the food web. Besides, this review covers the last technological developments encompassing the use of novel extraction coatings (e.g., metal-organic frameworks, covalent organic frameworks, PDMS-overcoated fiber), geometries (e.g., Arrow-SPME, multiple monolithic fiber-SPME), approaches (e.g., vacuum and cold fiber SPME), and on-site devices. The applications of SPME hyphenated with ambient mass spectrometry have also been described.

Carbon and Tin-Based Polyacrylonitrile Hybrid Architecture Solid Phase Microextraction Fiber for the Detection and Quantification of Antibiotic Compounds in Aqueous Environmental Systems

In this study, the detection and quantification of multiple classes of antibiotics in water matrices are proposed using a lab-made solid phase microextraction (SPME) fiber coupled with high-performance liquid chromatography-tandem mass spectrometry (LC-MS/MS). The lab-made fiber was prepared using a graphene oxide (G), carbon nanotubes (C), and titanium dioxide (T) composite, namely GCT, with polyacrylonitrile (PAN) as supporting material. The detected antibiotics were enrofloxacin, sulfathiazole, erythromycin, and trimethoprim. The custom-made fiber was found to be superior compared with a commercial C18 fiber. The excellent reproducibility and lower intra-fiber relative standard deviations (RSDs 1.8% to 6.8%) and inter-fiber RSDs (4.5% to 8.8%) made it an ideal candidate for the detection of traces of antibiotics in real environmental samples. The proposed validated method provides a satisfactory limit of detection and good linear ranges with higher (>0.99) coefficient of determination in the aqueous system. Application of the method was made in different real water systems such as river, pond and tap water using the standard spiking method. Excellent sensitivity, reproducibility, lower amount of sample detection and higher recovery was found in a real water sample. Therefore, the extraction method was successfully applied to the detection and quantification of multiple classes of antibiotics in different aqueous systems with satisfactory results.

An organic-inorganic hybrid silica aerogel prepared by co-precursor method for solid-phase microextraction coating

In order to improve the extraction performance of silica aerogel, an organic-inorganic hybrid silica aerogel was developed as the coating of solid-phase microextraction (SPME). It was prepared via the co-precursor reaction between tris(triethoxysilylpropyl)amine and tetraethyl orthosilicate. Coupled with gas chromatography, the hybrid silica aerogel-coated SPME fiber was evaluated using polycyclic aromatic hydrocarbons (PAHs). Compared to silica aerogel, the hybrid silica aerogel displayed better extraction performance, peak areas of PAH analytes were increased by about 2 times. The affecting parameters including extraction time, extraction temperature, ionic strength, stirring rate and desorption time were optimized, and an analytical method was established with wide linear ranges (0.005-20 μg L^-1, 0.010-20 μg L^-1, 0.100-20 μg L^-1), good correlation coefficients (0.9967-0.9994), low limits of detection (0.001-0.030 μg L^-1) and limits of quantitation (0.005-0.100 μg L^-1). Satisfactory extraction repeatability (RSD≤6.1%, n = 3) and preparation repeatability (RSD ≤ 9.8%, n = 3) were also obtained. Compared to the reported coatings and the commercial coating, the organic-inorganic hybrid silica aerogel has higher or comparable sensitivity, better repeatability, and shorter extraction time and longer service life. The established method was used for the detection of lake water and rain water, and some targets were quantified successfully.