An efficient sensor for relay recognition of Zn2+ and Cu2+ through fluorescence ‘off–on–off’ functionality

Sugar-based carboxamidoquinoline conjugate for sensing Cu2+ and Au3+ ions in water through different binding modes and real application

A simple water-soluble carboxamidoquinoline derivative of glucofuranose 1 exhibited reversible selectivity toward Cu2+ and Au3+ ions in different binding modes. Sensor 1 is an example of a dual sensor for identifying copper and gold ions in the water medium. Sensor 1 exhibited excellent selection ability and sensitivity for Cu2+ and Au3+ ions rather than several metal ions and anions with a wide pH range (5-10). The association constants for both ions were determined to be 3.58 × 104 M-1 and 1.84 × 104 M-1, respectively. The 1:1 binding chemistry of the complexes was verified from the Job method and again validated through mass spectra. Sensor 1 can detect Cu2+ and Au3+ ions at very low concentrations, such as 0.014 μM for Cu2+ and 0.058 μM for Au3+. The different sensing strategies of sensor 1 towards Cu2+ and Au3+ were manifested from the photophysical properties of sensor 2 with metal ions, FT-IR spectra, and theoretical (DFT) observations. The useful relevance of the sensor for Cu2+ and Au3+ ions was tested in different water samples.

An effective dual sensor for Cu2+ and Zn2+ with long-wavelength fluorescence in aqueous media based on biphenylacrylonitrile Schiff-base

Although some sensors for Cu²⁺ and Zn²⁺ had been reported, the sensor with long-wavelength emission in aqueous media for in-situ detecting Cu²⁺ and Zn²⁺ was always expected. Herein, a biphenylacrylonitrile Schiff-base (OPBS) with large aromatic conjugated system was designed and synthesized in yield of 82%. OPBS possessed excellent long-wavelength fluorescence at 550-750 nm in aqueous media, which selectively response to sense Cu²⁺ with quenched fluorescence and Zn²⁺ with chromotropic fluorescence from red to yellow. The detection of Cu²⁺ and Zn²⁺ were realized without mutual interference in their coexistence system by means of the assistance of ATP. The detection limits were 2.3 × 10^-7 M for Cu²⁺ and 1.8 × 10^-6 M for Zn²⁺, respectively. The sensing mechanism was elucidated by binding MS spectra, fluorescence Job's plot and ¹H NMR spectra. Moreover, OPBS exhibited good bioimaging performance and the in-situ sensing abilities for Cu²⁺ and Zn²⁺ in living cells, suggesting the application potential for detecting Cu²⁺ and Zn²⁺ in both vitro assay and vivo environment.

A simple approach based on transmetalation for the selective and sensitive colorimetric/fluorometric detection of copper(II) ions in drinking water

The search for feasible and efficient methods for sensing cations in the environment is a challenge of current scientific interest. Among colorimetric and fluorometric methods, those allowing a direct and...

A Fluorescence Sensor Array Based on Zinc(II)-Carboxyamidoquinolines: Toward Quantitative Detection of ATP*

The newly prepared fluorescent carboxyamidoquinolines (1-3) and their Zn(II) complexes (Zn@1-Zn@3) were used to bind and sense various phosphate anions utilizing a relay mechanism, in which the Zn(II) ion migrates from the Zn@1-Zn@3 complexes to the phosphate, namely adenosine 5'-triphosphate (ATP) and pyrophosphate (PPi), a process accompanied by a dramatic change in fluorescence. Zn@1-Zn@3 assemblies interact with adenine nucleotide phosphates while displaying an analyte-specific response. This process was investigated using UV-vis, fluorescence, and NMR spectroscopy. It is shown that the different binding selectivity and the corresponding fluorescence response enable differentiation of adenosine 5'-triphosphate (ATP), adenosine 5'-diphosphate (ADP), pyrophosphate (PPi), and phosphate (Pi). The cross-reactive nature of the carboxyamidoquinolines-Zn(II) sensors in conjunction with linear discriminant analysis (LDA) was utilized in a simple fluorescence chemosensor array that allows for the identification of ATP, ADP, PPi, and Pi from 8 other anions including adenosine 5'-monophosphate (AMP) with 100 % correct classification. Furthermore, the support vector machine algorithm, a machine learning method, allowed for highly accurate quantitation of ATP in the range of 5-100 μM concentration in unknown samples with error <2.5 %.

4-Quinolone-Carboxamide and Carbothioamide Compounds as Fluorescent Sensors. New Fluorimetric Methods for Cu2+ and Fe3+ Determination in Tap Water and Soil

Ion sensor properties of the carboxamide and carbothioamide compounds carrying 4-quinolone group were investigated by means of emission spectrometry in methanol-water (1:1). The compounds were selectively complexed with Cu²⁺, Pd²⁺, and Fe³⁺ among many metal ions. The complex stoichiometry and the stability constant were determined by fluorimetric measurements. The carboxamide compound having phenyl group (QPO) showed sensitivity for Fe³⁺ ion with a linear range between 0.1 and 0.7 mg/L. The new method was applied in the determination of iron in the spiked tap water samples and the sandy-soil reference material. A modified standard addition method was used to remove the matrix effect. Limit of detection was 0.03 mg/L for the Fe³⁺ determination method. The carboxamide compound with benzyl group (QBO) showed sensitivity for Cu²⁺ ion with linear range 0-0.4 mg/L. There was no matrix effect for copper determination in the spiked tap water samples. The detection limit of the method for Cu²⁺ ion was 0.05 mg/L. The quantification limits of the methods were low enough to determine iron and copper amount in drinking water samples according to EPA.

A quinoline-based fluorescent probe for selective detection and real-time monitoring of copper ions – a differential colorimetric approach

A quinoline moiety was used as a building block for designing a probe for the selective detection of copper ions in a partially aqueous medium.

A new Schiff-base chemosensor for selective detection of Cu2+ and Co2+ and its copper complex for colorimetric sensing of S2- in aqueous solution

A new Schiff-base colorimetric chemosensor 1 was developed for the detection of Cu²⁺, Co²⁺ and S^2-. Sensor 1 could simply monitor Cu²⁺ and Co²⁺ by a color change from colorless to yellow. The binding modes of 1 to Cu²⁺ and Co²⁺ were determined to be a 2 : 1 complexation stoichiometry through Job's plot and ESI-mass spectrometry analysis. The detection limits (0.02 μM and 0.63 μM) for Cu²⁺ and Co²⁺ were lower than the recommended values (31.5 μM and 1.7 μM) by the World Health Organization (WHO) for Cu²⁺ and the Environmental Protection Agency (EPA) for Co²⁺, respectively. Importantly, 1 could detect and quantify Cu²⁺ in real water samples. In addition, the Cu²⁺-2·1 complex could be used as a highly selective colorimetric sensor for S^2- in the presence of other anions without any interference. Moreover, the sensing mechanisms of Cu²⁺ and Co²⁺ by 1 were explained by theoretical calculations.

A single fluorescent chemosensor for multiple targets of Cu2+, Fe2+/3+ and Al3+ in living cells and a near-perfect aqueous solution

A naphthol-based chemosensor 1 was developed for detection of Cu²⁺ and Fe^2+/3+ by fluorescence quenching and Al³⁺ by fluorescence emission change.

A new Schiff-based chemosensor for chromogenic sensing of Cu2+, Co2+and S2−in aqueous solution: experimental and theoretical studies

A new Schiff-based multifunctional colorimetric chemosensor1was developed for the detection of various analytes (Cu²⁺, Co²⁺and S²⁻).

Optical sensor: a promising strategy for environmental and biomedical monitoring of ionic species

In this review, we cover the recent developments in fluorogenic and chromogenic sensors for Cu²⁺, Fe²⁺/Fe³⁺, Zn²⁺and Hg²⁺.

A fluorescent sensor with a detection level of pM for Cd2+ and nM for Cu2+ based on different mechanisms

L showed excellent selectivity and sensitivity towards Cd²⁺ in acetonitrile–H₂O buffer solution and towards Cu²⁺ in pure water.

Two fluorescent Schiff base sensors for Zn2+: the Zn2+/Cu2+ion interference

While theenol-iminetautomer inL1exhibits Zn²⁺/Cu²⁺ion interference, theketo-enaminetautomer inL2recognizes only Zn²⁺.

A highly selective fluorescent chemosensor based on a quinoline derivative for zinc ions in pure water

A water-soluble fluorescent sensor with a low detection limit could be used to detect and quantify Zn²⁺in water samples.

Fluorescent metal ion chemosensors via cation exchange reactions of complexes, quantum dots, and metal–organic frameworks

Overview of a new paradigm in the design of fluorescent chemosensors for detecting metal ions via cation exchange reactions of complexes, quantum dots, and metal–organic frameworks.

A fluorescence on–off sensor for Cu2+and its resultant complex as an off–on sensor for Cr3+in aqueous media

A coumarin–quinoline based fluorescence “on–off–on” sensor detects Cu²⁺and Cr³⁺in aqueous media and MCF-7 cells.

A new fluorescent and electrochemical Zn2+ ion sensor based on Schiff base derived from benzil and L-tryptophan

Single molecule acting as both fluorescent and electrochemical sensor for Zn(2+) ion is rare. The product (L) obtained on condensation between benzil and L-tryptophan has been characterized by H NMR, ESI-MS and FT-IR spectroscopy. L in 1:1 (v/v) CH3OH:H2O solution shows fluorescence emission in the range 300 nm to 600 nm with λmax at 350 nm when is excited with 295 nm photon. Zn(2+) ion could induce a 10-fold enhancement in fluorescent intensity of L. Fluorescence and UV/Visible spectral data analysis shows that the binding ratio between Zn(2+) ion and L is 1:1 with log β=4.55. Binding of Zn(2+) ion disrupts the photoinduced electron transfer (PET) process in L and causes the fluorescence intensity enhancement. When cyclic voltammogram is recorded for L in 1:1 (v/v) CH3OH:H2O using glassy carbon (GC) electrode, two quasi reversible redox couples at redox potential values -0.630±0.005 V and -1.007±0.005 V are obtained (Ag-AgCl as reference, scan rate 0.1 V s(-1)). Interaction with Zn(2+) ion makes the first redox couple irreversible while the second couple undergoes a 0.089 V positive shift in redox potential. Metal ions - Cd(2+), Cu(2+), Co(2+), Hg(2+), Ag(+), Ni(2+), Fe(2+), Mn(2+), Mg(2+), Ca(2+)and Pb(2+), individually or all together, has no effect on the fluorescent as well as electrochemical property of L. DFT calculations showed that Zn(2+) ion binds to L to form a stable complex. The detection limit for both fluorescence as well as electrochemical detection was 10(-6) M.