Graphene-based nanocomposites in analytical extraction processes

Preparation of a sustainable magnetic sorbent for the extraction and preconcentration of progestogens in natural water samples

A film composed of agarose and graphene (G) and magnetic nanoparticles (G-MNPs) is proposed as a sorbent for the extraction and determination of medroxyprogesterone (MED), levonorgestrel (LEV), norethisterone (NOR) and progesterone (PRO) in natural water samples. Both the preparation of the film and the extraction procedure were optimized. The optimal extraction parameters were as follows: isopropyl alcohol as activation solvent, sample pH value of 3.0, extraction time of 30 min, 1.00 mL of acetonitrile as eluent, elution time of 5 min and sample volume of 100.00 mL. HPLC with photodiode array detector was used for the separation and determination. The method presented a linear range between 2.50 and 75.0 μg L-1 for all analytes, and the LODs were between 1.40 and 1.80 μg L-1. The method was applied to natural water samples, obtaining satisfactory recovery values (75-111 %). In conclusion, for the immobilization of the G-MNPs, agarose was used, which is a non-toxic, renewable and biodegradable material. The G-MNPs-agarose film was reused up to 70 times, without losing its extraction capacity significantly and presenting excellent sorbent properties, which allow the extraction and preconcentration of the progestogens under study.

Adsorption Study of Neodymium from the Aqueous Phase Using Fabricated Magnetic Chitosan-Functionalized Graphene Oxide Composites

This work reports the performances of the magnetic chitosan@graphene oxide composite (MCh@GO) for the sorption of Nd(III) from aqueous medium. The prepared composite was synthesized by a coprecipitation method and then examined by FT-IR, XRD, SEM, and TGA. XRD analysis proved physical interactions between magnetic chitosan and graphene oxide through (inter- and intramolecular H-bonding and peptide bonding). TGA data approved the thermal stability of the prepared MCh@GO nanocomposite over their constituents. The optimum pH for the sorption process was 4.5. The Langmuir model and PSO fitted the experimental data. The adsorption process was found to be endothermic and spontaneous with a Q max of 56.6 mg g-1. Indeed, the MCh@GO composite proved to be an excellent adsorbent for the purification, remediation, and separation of Nd due to its promising properties.

Synthesis of imidazolium ionic liquid immobilized on magnetic mesoporous silica: A sorbent material in a green micro-solid phase extraction of multiclass pesticides in water

In this study, we synthesized an imidazolium ionic liquid immobilized on magnetic mesoporous silica (IL-MMS) and evaluated its performance as a sorbent material for a green micro-solid phase extraction (μ-SPE) of multiclass pesticides in water. The synthesized IL-MMS was characterized by various analytical techniques, including Fourier-transform infrared spectroscopy (FTIR), Brunauer-Emmett-Teller (BET) and Barrett-Joyner-Halenda (BJH) analyses (N2 adsorption/desorption), Vibrating Sample Magnetometer (VSM), energy-dispersive spectroscopy (EDS) and Field emission scanning electron microscopy (FESEM). Our synthesized IL-MMS demonstrated excellent magnetic properties (31.5 emu/g), high surface area (1177.4 m2/g), proper pore size (⁓4.2 nm) and volume (1.80 cm3/g). Under optimized extraction conditions, the IL-MMS exhibited a high adsorption capacity for a variety of pesticides, including organophosphates, carbamates, and pyrethroids. The proposed μ-SPE method using IL-MMS showed good linearity (R2 > 0.99), low limits of detection (LODs) ranging from 0.04 to 1.63 ng/L, and suitable recovery rate was between 82.4% and 109.8% for different pesticides. In addition, the method also exhibited excellent reproducibility, with relative standard deviations (RSDs) of less than 8% for both intra and inter-day precision. In overall, the synthesized IL-MMS has proven to be a highly promising material for sorbent-based micro-solid phase extraction (μ-SPE) of multiclass pesticides in water. With its simple, efficient, and eco-friendly approach to pesticide analysis, this method shows great potential for future pesticide detection and monitoring efforts due to its sensitivity, accuracy, and adaptability to various environmental conditions.

Recent advances in the functionalization, substitutional doping and applications of graphene/graphene composite nanomaterials

Recently, graphene and graphene-based nanomaterials have emerged as advanced carbon functional materials with specialized unique electronic, optical, mechanical, and chemical properties. These properties have made graphene an exceptional material for a wide range of promising applications in biological and non-biological fields. The present review illustrates the structural modifications of pristine graphene resulting in a wide variety of derivatives. The significance of substitutional doping with alkali-metals, alkaline earth metals, and III-VII group elements apart from the transition metals of the periodic table is discussed. The paper reviews various chemical and physical preparation routes of graphene, its derivatives and graphene-based nanocomposites at room and elevated temperatures in various solvents. The difficulty in dispersing it in water and organic solvents make it essential to functionalize graphene and its derivatives. Recent trends and advances are discussed at length. Controlled reduction reactions in the presence of various dopants leading to nanocomposites along with suitable surfactants essential to enhance its potential applications in the semiconductor industry and biological fields are discussed in detail.

Fabrication of a biochar-doped monolithic adsorbent and its application for the extraction and determination of coumarins from Angelicae Pubescentis Radix

A monolithic adsorbent was designed aiming to the structure of osthole and columbianadin, and fabricated using diallyl phthalate as the monomer and ethylene dimethacrylate as the crosslinker with the addition of bamboo biochar, via polymerization reaction in a stainless-steel tube. The prepared composite adsorbent packed in the tube was used as a solid-phase extraction column for the extraction and determination of two coumarins (osthole and columbianadin) in Angelicae Pubescentis Radix, combing with a C18 analytical column through an HPLC instrument, which show excellent matrix-removal ability and good selectivity to osthole and columbianadin. Furthermore, the present adsorbent shows good applicability, which was used for the extraction of osthole from Duhuo Jisheng Pill. Compared to the commercial C18 and phenyl adsorbent, the present adsorbent own better selectivity and higher resolution. These results attributed to the enhanced specific surface area (141 m2/g) and enriched interaction sites of the resulting composite adsorbent, due to the doping of bamboo biochar, which can produce hydrogen bond, dipole-dipole, π-π and hydrophobic force interactions with the osthole and columbianadin. The methodology validation indicated that the present method showed good precision and good accuracy, and the composite adsorbent showed good preparative repeatability, which can be reused for no less than 100 times with the relative standard deviation ≤4.6 % (n = 100). The present work provided a simple and efficient method for the extraction and determination osthole and columbianadin from Angelicae Pubescentis Radix.

Volatilomes of human infection

The human volatilome comprises a vast mixture of volatile emissions produced by the human body and its microbiomes. Following infection, the human volatilome undergoes significant shifts, and presents a unique medium for non-invasive biomarker discovery. In this review, we examine how the onset of infection impacts the production of volatile metabolites that reflects dysbiosis by pathogenic microbes. We describe key analytical workflows applied across both microbial and clinical volatilomics and emphasize the value in linking microbial studies to clinical investigations to robustly elucidate the metabolic species and pathways leading to the observed volatile signatures. We review the current state of the art across microbial and clinical volatilomics, outlining common objectives and successes of microbial-clinical volatilomic workflows. Finally, we propose key challenges, as well as our perspectives on emerging opportunities for developing clinically useful and targeted workflows that could significantly enhance and expedite current practices in infection diagnosis and monitoring.

Reduced Graphene Oxide Aerogels Cartridges for Solid Phase Extraction of Benzotriazoles

UV-benzotriazoles have been identified as water micropollutants that cause serious problems for human health and the environment. Their low concentration in water bodies complicates their detection by direct water analysis, slowing the corrective actions to avoid bioaccumulation. In this regard, the use of graphene-based materials with a high affinity for non-polar molecules has been demonstrated to be a potential tool for the optimal separation and concentration of this type of molecules in solid phase extraction (SPE) processes. This work evaluates the potential of novel reduced graphene oxide aerogels (rGO) as extractants of mixtures of three UV-benzotriazoles in water at low concentrations. These rGO aerogels incorporate graphenic domains into a tough structure of polymeric chains by adding graphene oxide during the synthesis of resorcinol-formaldehyde gels. Aerogels with a different content and ordering of graphenic domains were obtained and characterized using Raman, XRD, SEM and nitrogen adsorption isotherms (-196 °C). The rGO aerogels that performed better as solid phase extractants were those containing 60% rGO. Aerogels with lower rGO contents (40%) required a high-temperature (2000 °C) treatment to render competitive results. The SPE methodology using selected rGO aerogels was optimized by varying the elution solvent, elution time and volume. The best performances, i.e., recoveries of 80-100% and enrichment factors of 12.5-50, were accomplished when using 0.8 mL of tetrahydrofuran (THF) as an elution solvent. As a result, a fast (10 min) and simple extraction method of UV-benzotriazoles in water was attained, achieving a detection limit of 1 ng mL^-1. Selected aerogels were finally tested for the SPE of spiked samples of river waters, showing a similar performance to that observed with synthetic mixtures.

Preconcentration and Removal of Pb(II) Ions from Aqueous Solutions Using Graphene-Based Nanomaterials

Direct determination of lead trace concentration in the presence of relatively complex matrices is often a problem. Thus, its preconcentration and separation are necessary in the analytical procedures. Graphene-based nanomaterials have attracted significant interest as potential adsorbents for Pb(II) preconcentration and removal due to their high specific surface area, exceptional porosities, numerous adsorption sites and functionalization ease. Particularly, incorporation of magnetic particles with graphene adsorbents offers an effective approach to overcome the separation problems after a lead enrichment step. This paper summarizes the developments in the applications of graphene-based adsorbents in conventional solid-phase extraction column packing and its alternative approaches in the past 5 years.

Determination of selected herbicides in sugarcane-derived foods by graphene-oxide based disposable pipette extraction followed by liquid chromatography-tandem mass spectrometry

Sugarcane is widely cultivated in Brazil. Although there are Maximum Residue Limits of pesticides determined for this plant, there is no legislation covering alimentary products from sugarcane. In this study, Disposable Pipette Tip Extraction (DPX) technique was evaluated as a sample preparation technique for simultaneous determination of eleven herbicides followed by LC-MS/MS analysis in three sugarcane-derived food matrices: juice, candy, and syrup. First, graphene oxide anchored to silica functionalized with octadecyl silane and endcapped was synthesized, which was evaluated as a sorbent in DPX. Then, after evaluating the parameters involved in DPX extraction, the method was validated following the ICH guide. As a result, the method showed acceptable linearity (r ≥ 0.99), limits of quantification (1.0 - 5.0 ng mL^-1 for juice and 5.0 - 25.0 ng g ^- 1 for candy and syrup, varying according to the pesticide), precision, and accuracy within the limits of the literature, and recoveries ranging from 48 - 69% (juice), 34 - 89% (candy), and 28 - 76% (syrup). Finally, the developed method was successfully applied in actual samples of the three studied matrices.

Graphene oxide modified magnetic polyamidoamide dendrimers based magnetic solid phase extraction for sensitive measurement of polycyclic aromatic hydrocarbons

In this study, graphene oxide modified magnetic polyamidoamine dendrimers (MNPs@PAMAM-G2.0@GO) nanoparticles were successfully prepared by amidation method. The obtained MNPs@PAMAM-G2.0@GO nanocomposites were examined by fourier transform infrared spectroscopy (FT-IR), X-ray diffraction (XRD), vibrating sample magnetometer (VSM), scanning electron microscope (SEM) and transmission electron microscopy (TEM), etc. MNPs@PAMAM-G2.0@GO exhibited excellent adsorption property and was investigated for magnetic solid phase extraction (MSPE) of polycyclic aromatic hydrocarbons (PAHs) from water. The detection of extracted PAHs was accomplished by high performance liquid chromatography (HPLC) and gas chromatography tandem mass spectrometry (GC-MS/MS). The target PAHs included anthracene (ANT), pyrene (PYR), fluoranthene (FLT), carbazole (CB), 7-methylquinoline (7-MQL), 9-methylcarbazole (9-MCB), dibenzothiophene (DBT) and 4,6-dimethyldibenzothiophene (4,6-DBT). Important operation parameters for MSPE that could affect the extraction efficiencies of PAHs were investigated in detail. Under optimal parameters, the constructed method demonstrated excellent linear range with 0.001-10 μg L^-1 for analytes and low limits of detection within the range of 0.11-0.9 ng L^-1. The spiked average recoveries of PAHs in natural water samples ranged from 92.5% to 105.2%. The promising results indicated that MNPs@PAMAM-G2.0@GO could be employed to efficiently extract PAHs from aqueous samples.

Electromembrane extraction of polar substances - Status and perspectives

In this article, the scientific literature on electromembrane extraction (EME) of polar substances (log P < 2) is reviewed. EME is an extraction technique based on electrokinetic migration of analyte ions from an aqueous sample, across an organic supported liquid membrane (SLM), and into an aqueous acceptor solution. Because extraction is based on voltage-assisted partitioning, EME is fundamentally suitable for extraction of polar and ionizable substances that are challenging in many other extraction techniques. The article provides an exhaustive overview of papers on EME of polar substances. From this, different strategies to improve the mass transfer of polar substances are reviewed and critically discussed. These strategies include different SLM chemistries, modification of supporting membranes, sorbent additives, aqueous solution chemistry, and voltage/current related strategies. Finally, the future applicability of EME for polar substances is discussed. We expect EME in the coming years to be developed towards both very selective targeted analysis, as well as untargeted analysis of polar substances in biomedical applications such as metabolomics and peptidomics.