Quantifying the low-energy limit and spectral resolution in valence electron energy loss spectroscopy

Charging ain't all bad: Complex physics in DyScO3

Although charging is ubiquitous in electron microscopy, its effects are typically avoided or ignored. However, avoiding charging is not possible in some materials, e.g. lanthanide scandates with well-ordered surfaces positively charge immensely under electron beam illumination because of their electronic structure, and ignoring charging can leave new science undiscovered. In this work, a combination of rapidly acquired electron energy loss spectra and cross-correlation were used to understand and overcome charging effects in DyScO₃. A 5.4 eV band gap was extracted from the charging-corrected loss spectrum, in good agreement with previously reported band gaps, and a 3.8 eV in-gap peak was attributed to surface states via comparison with density functional theory calculations. Additionally, ultraviolet photoelectron spectroscopy measurements indicated that under some conditions well-annealed DyScO₃ surfaces charge negatively causing upward band bending associated with occupied surface states in the gap. As was previously found in the case of positive charging under electron beam illumination with in-situ flexoelectric bending observations, the magnitude of negative charging under ultraviolet illumination is Zener tunneling limited in well-annealed DyScO₃.

Exploring the capabilities of monochromated electron energy loss spectroscopy in the infrared regime

Monochromated electron energy loss spectroscopy (EELS) is one of the leading techniques to study materials properties that correspond to low (<5 eV) energy losses (i.e. band-gaps, plasmons, and excitons) with nanoscale spatial resolution. Recently a new generation of monochromators have become available, opening regimes and unlocking excitations that were previously unobservable in the electron microscope. The capabilities of these new instruments are still being explored, and here we study the effect of monochromation on various aspects of EELS analysis in the infrared (<1 eV) regime. We investigate the effect of varying levels of monochromation on energy resolution, zero-loss peak (ZLP) tail reduction, ZLP tail shape, signal-to-noise-ratio, and spatial resolution. From these experiments, the new capabilities of monochromated EELS are shown to be highly promising for the future of localized spectroscopic analysis.

Local Plasmon Engineering in Doped Graphene

Single-atom B or N substitutional doping in single-layer suspended graphene, realized by low-energy ion implantation, is shown to induce a dampening or enhancement of the characteristic interband π plasmon of graphene through a high-resolution electron energy loss spectroscopy study using scanning transmission electron microscopy. A relative 16% decrease or 20% increase in the π plasmon quality factor is attributed to the presence of a single substitutional B or N atom dopant, respectively. This modification is in both cases shown to be relatively localized, with data suggesting the plasmonic response tailoring can no longer be detected within experimental uncertainties beyond a distance of approximately 1 nm from the dopant. Ab initio calculations confirm the trends observed experimentally. Our results directly confirm the possibility of tailoring the plasmonic properties of graphene in the ultraviolet waveband at the atomic scale, a crucial step in the quest for utilizing graphene's properties toward the development of plasmonic and optoelectronic devices operating at ultraviolet frequencies.

Non-uniform Solute Segregation at Semi-Coherent Metal/Oxide Interfaces

The properties and performance of metal/oxide nanocomposites are governed by the structure and chemistry of the metal/oxide interfaces. Here we report an integrated theoretical and experimental study examining the role of interfacial structure, particularly misfit dislocations, on solute segregation at a metal/oxide interface. We find that the local oxygen environment, which varies significantly between the misfit dislocations and the coherent terraces, dictates the segregation tendency of solutes to the interface. Depending on the nature of the solute and local oxygen content, segregation to misfit dislocations can change from attraction to repulsion, revealing the complex interplay between chemistry and structure at metal/oxide interfaces. These findings indicate that the solute chemistry at misfit dislocations is controlled by the dislocation density and oxygen content. Fundamental thermodynamic concepts – the Hume-Rothery rules and the Ellingham diagram – qualitatively predict the segregation behavior of solutes to such interfaces, providing design rules for novel interfacial chemistries.

Local band gap measurements by VEELS of thin film solar cells

This work presents a systematic study that evaluates the feasibility and reliability of local band gap measurements of Cu(In,Ga)Se2 thin films by valence electron energy-loss spectroscopy (VEELS). The compositional gradients across the Cu(In,Ga)Se2 layer cause variations in the band gap energy, which are experimentally determined using a monochromated scanning transmission electron microscope (STEM). The results reveal the expected band gap variation across the Cu(In,Ga)Se2 layer and therefore confirm the feasibility of local band gap measurements of Cu(In,Ga)Se2 by VEELS. The precision and accuracy of the results are discussed based on the analysis of individual error sources, which leads to the conclusion that the precision of our measurements is most limited by the acquisition reproducibility, if the signal-to-noise ratio of the spectrum is high enough. Furthermore, we simulate the impact of radiation losses on the measured band gap value and propose a thickness-dependent correction. In future work, localized band gap variations will be measured on a more localized length scale to investigate, e.g., the influence of chemical inhomogeneities and dopant accumulations at grain boundaries.

Toward 10 meV electron energy-loss spectroscopy resolution for plasmonics

Energy resolution is one of the most important parameters in electron energy-loss spectroscopy. This is especially true for measurement of surface plasmon resonances, where high-energy resolution is crucial for resolving individual resonance peaks, in particular close to the zero-loss peak. In this work, we improve the energy resolution of electron energy-loss spectra of surface plasmon resonances, acquired with a monochromated beam in a scanning transmission electron microscope, by the use of the Richardson-Lucy deconvolution algorithm. We test the performance of the algorithm in a simulated spectrum and then apply it to experimental energy-loss spectra of a lithographically patterned silver nanorod. By reduction of the point spread function of the spectrum, we are able to identify low-energy surface plasmon peaks in spectra, more localized features, and higher contrast in surface plasmon energy-filtered maps. Thanks to the combination of a monochromated beam and the Richardson-Lucy algorithm, we improve the effective resolution down to 30 meV, and evidence of success up to 10 meV resolution for losses below 1 eV. We also propose, implement, and test two methods to limit the number of iterations in the algorithm. The first method is based on noise measurement and analysis, while in the second we monitor the change of slope in the deconvolved spectrum.

Prospects for vibrational-mode EELS with high spatial resolution

Taking advantage of previous measurements by Geiger and co-workers, we discuss the possibilities and problems of measuring vibrational modes of energy loss in a transmission electron microscope fitted with a monochromator and a high-resolution energy-loss spectrometer. The tail of the zero-loss peak is seen to be a major limitation, rather than its full-width at half-maximum. Because of the low oscillator strengths and small cross-sections involved, radiation damage will limit the spatial resolution if this technique is applied to organic specimens. Delocalization of the inelastic scattering may also be a limitation, if a dipole description of the scattering process is valid.

Dielectric response of pentagonal defects in multilayer graphene nano-cones

The dielectric response of pentagonal defects in multilayer graphene nano-cones has been studied by electron energy loss spectroscopy and ab initio simulations. At the cone apex, a strong modification of the dielectric response is observed below the energy of the π plasmon resonance. This is attributed to π → π* interband transitions induced by topology-specific resonant π bonding states as well as π*-σ* hybridization. It is concluded that pentagonal defects strongly affect the local electronic structure in such a way that multi-walled graphene nano-cones should show great promise as field emitters.