Generation and identification of 1O2 in catalysts/peroxymonosulfate systems for water purification

Environmental transformation and hazards of decachlorobiphenyl on suspended particles under sunlight irradiation

Decachlorobiphenyl (PCB-209) can be widely detected in suspended particles and sediments due to its large hydrophobicity, and some of its transformation products may potentially threaten organisms through the food chain. Here we investigate the photochemical transformation of PCB-209 on suspended particles from the Yellow River. It was found that the suspended particles had an obvious shielding effect to largely inhibit the photodegradation of PCB-209. Meanwhile, the presence of inorganic ions (e.g. Mg2+ and NO3-) and organic matters (e.g. humic acid, HA) in the Yellow River water inhibited the reaction. The main transformation products of PCB-209 were lower-chlorinated and hydroxylated polychlorinated biphenyls (OH-PCBs), and small amounts of pentachlorophenol (PCP) and polychlorinated dibenzofurans (PCDFs) were also observed. The mechanisms of PCP formation by double •OH attacking carbon bridge and PCDFs formation by elimination reaction of ionic state OH-PCBs were proposed using theoretical calculations, which provided some new insights into the inter-transformations between persistent organic pollutants. In combination with VEGA and EPI Suite software, some intermediates such as PCDFs were more toxic to organisms than PCB-209. This study deepens the understanding of the transformation behavior of PCB-209 on suspended particles under sunlight.

Precise Modulation of the Coordination Environment of Single Cu Site Catalysts to Regulate the Peroxymonosulfate Activation Pathway for Water Remediation

Single atom site catalysts (SACs) with atomically dispersed active sites can be expected to be potential ideal catalysts for accurately modulating the persulfate activation pathway during the water remediation process because of their well-defined structure and the maximum metallic atom utilization. In this paper, a series of Cu SACs with different coordination environments were synthesized to elaborately regulate the peroxymonosulfate activation pathway in AOPs to clarify active species generation and transformation in water remediation. The degradation rate constants (kobs) of Cu-N2, Cu-N3, and Cu-N4 were 0.028, 0.021, and 0.015 min-1, respectively. Cu-N2 SACs exhibited a noticeable enhanced performance for bisphenol A (BPA) removal from water compared to that of the Cu-Nx SACs (x = 3, 4), accompanied by peroxymonosulfate (PMS) activation pathway variation. As shown by experimental and theoretical results, the PMS activation pathway was transformed from ROS to electron transfer with nitrogen coordination numbers decreasing from 4 to 2, which can be ascribed to the uneven charge distribution of Cu sites as well as upshifts in the d-band center, and thereby optimized electron transfer for PMS activation. Furthermore, the increasing nitrogen vacancies of single Cu site catalysts can also result in more unoccupied 3d orbitals of Cu atoms in SACs, thereby improving the intermediates' (PMS and BPA) adsorption-desorption process and BPA removal performance. These findings provided a beneficial approach for the coordination number regulation of SACs in water remediation.

Peroxydisulfate activation and versatility of defective Fe3O4@MOF-808 for enhanced carbon and phosphorus recovery from sludge anaerobic fermentation

Although being viewed as a promising technology for reclamation of carbon and phosphorus from excess sludge, anaerobic fermentation (AF) grapples with issues such as a low yield of volatile fatty acids (VFAs) and high phosphorus recovery costs. In this study, we synthesized Fe3O4@MOF-808 (FeM) with abundant defects and employed it to simultaneously enhance VFAs and phosphorus recovery during sludge anaerobic fermentation. Through pre-oxidization of sludge catalyzed by FeM-induced peroxydisulfate, the soluble organic matter increased by 2.54 times, thus providing ample substrate for VFAs production. Subsequent AF revealed a remarkable 732.73 % increase in VFAs and a 1592.95 % increase in phosphate. Factors contributing to the high VFAs yield include the non-biological catalysis of unsaturated Zr active sites in defective FeM, enhancing protein hydrolysis, and the inhibition of methanogenesis due to electron competition arising from the transformation between Fe(III) and Fe(II) under Zr influence. Remarkably, FeM exhibited an adsorption capacity of up to 92.64 % for dissolved phosphate through ligand exchange and electrostatic attractions. Furthermore, FeM demonstrated magnetic separation capability from the fermentation broth, coupled with excellent stability and reusability in both catalysis and adsorption processes.

Advances in Atomically Dispersed Metal and Nitrogen Co-Doped Carbon Catalysts for Advanced Oxidation Technologies and Water Remediation: From Microenvironment Modulation to Non-Radical Mechanisms

Atomically dispersed metal and nitrogen co-doped carbon catalysts (M-N-C) have been attracting tremendous attentions thanks to their unique MNx active sites and fantastic catalytic activities in advanced oxidation technologies (AOTs) for water remediation. However, precisely tailoring the microenvironment of active sites at atomic level is still an intricate challenge so far, and understanding of the non-radical mechanisms in persulfate activation exists many uncertainties. In this review, latest developments on the microenvironment modulation strategies of atomically dispersed M-N-C catalysts including regulation of central metal atoms, regulation of coordination numbers, regulation of coordination heteroatoms, and synergy between single-atom catalysts (SACs) with metal species are systematically highlighted and discussed. Afterwards, progress and underlying limitations about the typical non-radical pathways from production of singlet oxygen, electron transfer mechanism to generation of high-valent metal species are well demonstrated to inspire intrinsic insights about the mechanisms of M-N-C/persulfate systems. Lastly, perspectives for the remaining challenges and opportunities about the further development of carbon-based SACs in environment remediation are also pointed out. It is believed that this review will be much valuable for the further design of active sites in M-N-C/persulfate catalytic systems and promote the wide application of SACs in various fields.

Atomic-Level Engineered Cobalt Catalysts for Fenton-Like Reactions: Synergy of Single Atom Metal Sites and Nonmetal-Bonded Functionalities

Single atom catalysts (SACs) are atomic-level-engineered materials with high intrinsic activity. Catalytic centers of SACs are typically the transition metal (TM)-nonmetal coordination sites, while the functions of coexisting non-TM-bonded functionalities are usually overlooked in catalysis. Herein, the scalable preparation of carbon-supported cobalt-anchored SACs (CoCN) with controlled Co─N sites and free functional N species is reported. The role of metal- and nonmetal-bonded functionalities in the SACs for peroxymonosulfate (PMS)-driven Fenton-like reactions is first systematically studied, revealing their contribution to performance improvement and pathway steering. Experiments and computations demonstrate that the Co─N3C coordination plays a vital role in the formation of a surface-confined PMS* complex to trigger the electron transfer pathway and promote kinetics because of the optimized electronic state of Co centers, while the nonmetal-coordinated graphitic N sites act as preferable pollutant adsorption sites and additional PMS activation sites to accelerate electron transfer. Synergistically, CoCN exhibits ultrahigh activity in PMS activation for p-hydroxybenzoic acid oxidation, achieving complete degradation within 10 min with an ultrahigh turnover frequency of 0.38 min-1, surpassing most reported materials. These findings offer new insights into the versatile functions of N species in SACs and inspire rational design of high-performance catalysts in complicated heterogeneous systems.

Lattice oxygen activation of MnO2 by CeO2 for the improved degradation of bisphenol A in the peroxymonosulfate-based oxidation

The structure of MnO2 was modified by constructing the composites CeO2/ MnO2 via a facile hydrothermal method. The catalytic performance of optimal composite (Mn-Ce10) in peroxymonosulfate (PMS) activation for the degradation of bisphenol A (BPA) is approximately three times higher than that of MnO2 alone. The average valence of manganese in CeO2/MnO2 is lowered compared to MnO2, which induces the generation of more free radicals, such as OH and SO4•-. In addition, the composite exhibits a higher concentration of oxygen vacancies than MnO2, facilitating bondingwith PMS to produce more singlet oxygen (1O2). Moreover, the incorporation of CeO2 activates the lattice oxygen of MnO2, improving its oxidative ability. Consequently, approximately 48% of BPA decomposition in 10min is attributed to direct oxidation in the Mn-Ce10/PMS system, whereas only 36% occurs in 30min for the MnO2/PMS system. Simulation results confirm weakened Mn-O covalency and elongated Mn-O bonds due to the activation of lattice oxygen in CeO2/MnO2, demonstrating that PMS tends to be adsorbed on the composite rather than on MnO2. This work establishes a relationship between lattice oxygen and the degradation pathway, offering a novel approach for the targeted regulation of catalytic oxidation.

Ultrafast removal of organics via peroxymonosulfate activation over Co2P/TD hollow spheres derived from ZIF-67

Co2P/tetrasodium diphosphate (TD) derived from ZIF-67/sodium phytate was newly developed and synthesized, and exhibited excellent degradation ability toward various refractory organics via peroxymonosulfate activation. A corresponding reaction mechanism was proposed. In addition, a continuous-flow operation of phenol degradation was realized.