Comparison of the application of higher mass resolution and cool plasma conditions to avoid spectral interferences in Cr(III)/Cr(VI) speciation by means of high-performance liquid chromatography – inductively coupled plasma mass spectrometry

Rapid determination of chromium species in environmental waters using a diol-bonded polymer-stationary column under water-rich conditions coupled with ICPMS

Chromium speciation analysis in environmental water is of great significance for the monitoring of water pollution and assessing its influences on human health. This study proposes a rapid analytical approach for the simultaneous determination of Cr(VI) and Cr(III) in environmental waters by hydrophilic interaction chromatography (HILIC) coupled with ICPMS under a water-rich condition. 2,6-Pyridinedicarboxylic acid (PDCA) was used to unify Cr(III) species in various chemical forms into a stable Cr(III)-PDCA anion complex and then separated from Cr(VI) oxyanion on a diol-bonded polymer-based HILIC column. An aqueous mobile phase containing 50 mmol L-1 ammonium acetate (pH 7.0), 2 mmol L-1 PDCA, and 4% acetonitrile successfully separates chromium species as well as chloride ions. In addition, our method elutes Cr(VI) preferentially over Cr(III)-PDCA, enabling rapid determination of Cr(VI), and both chromium species were analyzed within 6.2 min. The detection limits of 0.19 μg L-1 for Cr(VI) and 0.35 μg L-1 for Cr(III) at m/z 52 under He collision mode are comparable to or better than the conventional ion exchange chromatography-ICPMS methods, and quantitative recovery was obtained from spike-recovery tests on river water samples containing various levels of matrix. Optimization experiments of the HPLC conditions indicate that the retentions of Cr(VI) and Cr(III)-PDCA are characterized by electrostatic and nonpolar interactions, respectively. The retention behavior of inorganic anions and cations in water-rich conditions observed in this study will provide new insights into the separation mechanism in polymer-based HILIC columns, which has been poorly understood.

Chromium and its speciation in water samples by HPLC/ICP-MS--technique establishing metrological traceability: a review since 2000

Chromium holds a special position among living organisms because depending on its species it can be either essential or toxic. Cr(VI) even at very low concentrations is harmful and carcinogenic, while Cr(III) is a necessary microelement for cellular metabolism. Therefore, a simple analysis of Cr concentration in collected samples will not be able to distinguish these differences effectively: for a proper chemical analysis we need to perform a reliable detection and quantification of Cr species. Separation and detection of chromium can be accomplished with high performance liquid chromatography hyphenated to inductively coupled plasma mass spectrometry (HPLC/ICP-MS) in a one-step. Our review assembles articles published since 2000 regarding chromium speciation in water samples with the use of HPLC/ICP-MS. It addresses the following issues: chromium chemistry, the possibilities of dealing with interferences, metrological aspects, analytical performance and speciated isotope dilution mass spectrometry (SIDMS) which is a definitive measurement method. The authors would like to advocate this hyphenated advanced technique as well as the metrological approach in speciation analysis of chromium.

Chromium speciation in solid matrices and regulation: a review

In recent years, the extensive use of chromium in industrial processes has led to the promotion of several directives and recommendations by the European Union, that try to limit and regulate the presence of Cr(VI) in the environment and to protect industrial workers using chromium and end-users of manufactured products. As a consequence, new standard methods and analytical procedures have been published at the EU level for Cr(VI) determination in soil, sludge, sediment, and similar waste materials, workplace atmospheres, cement, packaging materials, industrially produced samples, and corrosion-protection layers on some components of vehicles and electrical and electronic equipment. The objective of this article is to summarize the different directives and recommendations and to critically review the currently existing standard methods and the methods published in the literature for chromium speciation in the above mentioned solid matrices, putting the emphasis on the different extraction procedures which have been developed for each matrix. Particular attention has been paid to Cr(III) and Cr(VI) inter-conversions that can occur during extraction and efforts to minimize these unwanted reactions. Although the use of NaOH-Na(2)CO(3) solutions with hot plate extraction seems to be the more widespread procedure, species transformation can still occur and several studies suggest that speciated isotope-dilution mass spectrometry (SIDMS) could be a suitable tool for correction of these interconversions. Besides, recent studies have proved the role of Cr(III) in chromium toxicology. As a consequence, the authors suggest an update of standard methods in the near future.

Determination of (90)Sr in soil samples using inductively coupled plasma mass spectrometry equipped with dynamic reaction cell (ICP-DRC-MS)

A rapid method is reported for the determination of (90)Sr in contaminated soil samples in the vicinity of the Chernobyl Nuclear Power Plant by ICP-DRC-MS. Sample preparation and measurement procedures focus on overcoming the isobaric interference of (90)Zr, which is present in soils at concentrations higher by more than six orders of magnitude than (90)Sr. Zirconium was separated from strontium in two steps to reduce the interference by (90)Zr(+) ions by a factor of more than 10(7): (i) by ion exchange using a Sr-specific resin and (ii) by reaction with oxygen as reaction gas in a dynamic reaction cell (DRC) of a quadrupole ICP-MS. The relative abundance sensitivity of the ICP-MS was studied systematically and the peak tailing originating from (88)Sr on mass 90 u was found to be about 3 x 10(-9). Detection limits of 4 fg g(-1) (0.02 Bq g(-1)) were achieved when measuring Sr solutions containing no Zr. In digested uncontaminated soil samples after matrix separation as well as in a solution of 5 microg g(-1) Sr and 50 ng g(-1) Zr a detection limit of 0.2 pg g(-1) soil (1 Bq g(-1) soil) was determined. (90)Sr concentrations in three soil samples collected in the vicinity of the Chernobyl Nuclear Power Plant were 4.66+/-0.27, 13.48+/-0.68 and 12.9+/-1.5 pg g(-1) corresponding to specific activities of 23.7+/-1.3, 68.6+/-3.5 and 65.6+/-7.8 Bq g(-1), respectively. The ICP-DRC-MS results were compared to the activities measured earlier by radiometry. Although the ICP-DRC-MS is inferior to commonly used radiometric methods with respect to the achievable minimum detectable activity it represents a time- and cost-effective alternative technique for fast monitoring of high-level (90)Sr contamination in environmental or nuclear industrial samples down to activities of about 1 Bq g(-1).

The application of inductively coupled plasma mass spectrometry in clinical pharmacological oncology research

Metal-based anticancer agents are frequently used in the treatment of a wide variety of cancer types. The monitoring of these anticancer agents in biological samples is important to understand their pharmacokinetics, pharmacodynamics, and metabolism. In addition, determination of metals originating from anticancer agents is relevant to assess occupational exposure of health care personnel working with these drugs. The high sensitivity of inductively coupled plasma mass spectrometry (ICP-MS) has resulted in an increased popularity of this technique for the analysis of metal-based anticancer drugs. In addition to the quantitative analysis of the metal of interest in a sample, ICP-MS can be used as an ultrasensitive metal selective detector in combination with speciation techniques such as liquid chromatography. In the current review we provide a systematic survey of publications describing the analysis of platinum- and ruthenium-containing anticancer agents using ICP-MS, focused on the determination of total metal concentrations and on the speciation of metal compounds in biological fluids, DNA- and protein-adducts, and environmental samples. We conclude that ICP-MS is a powerful tool for the quantitative analysis of metal-based anticancer agents from multiple sample sources.

Simultaneous multichannel mass-specific detection for high-performance liquid chromatography using an array detector sector-field mass spectrometer

The use of a separation step, such as liquid chromatography, prior to inductively coupled plasma mass spectrometry (ICP-MS) has become a common tool for highly selective and sensitive analyses. This type of coupling has several benefits including the ability to perform speciation analysis or to remove isobaric interferences. Several limitations of conventional instruments result from the necessity to scan or pulse the mass spectrometer to obtain a complete mass spectrum. When the instrument is operated in such a non-continuous manner, duty cycle is reduced, resulting in poorer absolute limits of detection. Additionally, with scanning instruments, spectral skew can be introduced into the measurement, limiting quantitation accuracy. To address these shortcomings, a high-performance liquid chromatograph has been coupled to an ICP-MS capable of continuous sample introduction and simultaneous multimass detection. These features have been realized with a novel detector array, the focal plane camera. Instrument performance has been tested for both speciation analysis and for the elimination of isobaric interferences. Absolute limits of detection in the sub picogram to tens of picograms regime are obtainable, while the added mass dimension introduced by simultaneous detection dramatically increases chromatographic peak capacity.

Determination of Total Chromium in Seawater by Isotope Dilution Sector Field ICPMS Using GC Sample Introduction

A method for the accurate determination of total Cr in seawater by isotope dilution (ID) sector field inductively coupled plasma mass spectrometry (SF-ICPMS) using GC as a means of sample introduction is described. Chromium was reduced to Cr(III) by addition of SO(2)-saturated water and derivatized with trifluoroacetylacetonate (TFA) to form volatile Cr(TFA)(3). Derivatized analyte was either extracted into hexane or directly sampled by solid-phase microextraction (SPME) using a poly(dimethylsiloxane)-coated fused-silica fiber for GC/SF-ICPMS analysis. With medium resolution required to efficiently separate argide, argon chloride and oxide interferences, a concentration of 0.154 +/- 0.013 ng mL(-1) (1 SD, n = 4) was obtained for Cr in NRCC seawater CRM CASS-4 using a 1-microL hexane extract, in agreement with the certified value of 0.144 +/- 0.029 ng mL(-1) (95% confidence interval). A detection limit of 20 pg mL(-1) was achieved. Low-resolution GC/SF-ICPMS in combination with solvent-free SPME sampling effectively eliminated spectroscopic interferences, yielding a concentration of 0.132 +/- 0.004 ng mL(-1) (1 SD, n = 4) for Cr in CASS-4 with a method detection limit of 3.9 pg mL(-1). By comparison, SPME sampling with GC/SF-ICPMS in medium-resolution mode provided a concentration of 0.146 +/- 0.013 ng mL(-1) (1 SD, n = 4) and a method detection limit of 9.1 pg mL(-1).

Retention of Cr(III) by high-performance chelation ion chromatography interfaced to inductively-coupled plasma mass spectrometric detection with collision cell

High-performance chelation ion chromatography (HPCIC) was employed to retain cationic Cr(III) on an anion-exchange column and hence allow the separation of the two most prevalent forms of chromium, Cr(II) and Cr(VI). A mobile phase of nitric acid was utilized at pH = 1.5; additionally, 2,6-pyridinedicarboxylic acid was used at a concentration of 6 mM. Additives with different structural characteristics were used in an effort to elucidate retention mechanisms. Inductively-coupled plasma mass spectrometry was used for chromium detection. A collision cell was utilized to reduce chloride-based polyatomic ions that may interfere with the detection of Cr(III), and a detection limit study yielded levels in the low part-per-billion range. The newly developed method was applied to the chromatographic analysis of samples of an incubation medium containing Cr(VI) incubated with cell nuclei.