Investigation of a liquid–liquid extraction system based on non-ionic surfactant–salt–H2O and mechanism of drug extraction

Extraction and purification of wheat-esterase using aqueous two-phase systems of ionic liquid and salt

To explore a new and simple rapid extraction and purification technique for wheat-esterase, an ionic liquids (ILs)-based aqueous two-phase system (ATPS) was developed for the purification of wheat-esterase from wheat extracts. Effects of various process parameters such as the concentrations of [Bmim]BF4, the types and concentrations of phase-forming salt, the system pH and the temperature on partitioning of wheat-esterase were evaluated. The obtained data indicated that wheat-esterase was preferentially partitioned into the ILs-rich phase and the ATPS composed of 20 % [Bmim]BF4 (w/w) and 25 % (w/w) NaH2PO4(pH = 4.8) showed good selectivity on wheat-esterase. Under the optimum conditions, wheat-esterase was purified with an acceptable yield (88.93 %), but produced wheat-esterase was 4.23 times as pure. It was obvious that temperature shows little influence on the purification between 10 and 50 °C. Sephadex G-150FF revealed that the band intensity of contaminating proteins in ATPS fraction almost disappeared. Therefore, ILs-based ATPS was an effective method for partitioning and recovery of wheat-esterase from wheat crude extracts.

Extraction and determination of chloramphenicol in feed water, milk, and honey samples using an ionic liquid/sodium citrate aqueous two-phase system coupled with high-performance liquid chromatography

A green, simple, non-toxic, and sensitive sample pretreatment procedure coupled with high-performance liquid chromatography (HPLC) was developed for the analysis of chloramphenicol (CAP) that exploits an aqueous two-phase system based on imidazolium ionic liquid (1-butyl-3-methylimidazolium tetrafluoroborate, [Bmim]BF(4)) and organic salt (Na(3)C(6)H(5)O(7)) using a liquid-liquid extraction technique. The influence factors on partition behaviors of CAP were studied, including the type and amount of salts, the pH value, the volume of [Bmim]BF(4), and the extraction temperature. Extraction efficiency of the CAP was found to increase with increasing temperature and the volume of [Bmim]BF(4). Thermodynamic studies indicated that hydrophobic interactions were the main driving force, although electrostatic interactions and salting-out effects were also important for the transfer of the CAP. Under the optimal conditions, 90.1% of the CAP could be extracted into the ionic liquid-rich phase in a single-step extraction. This method was practical when applied to the analysis of CAP in feed water, milk, and honey samples with a linear range of 2~1,000 ng mL(-1). The method yielded a limit of detection of 0.3 ng mL(-1) and a limit of quantification of 1.0 ng mL(-1). The recovery of CAP was 90.4-102.7% from aqueous samples of real feed water, milk, and honey samples by the proposed method. This novel process is much simpler and more environmentally friendly and is suggested to have important applications for the separation of antibiotics.

Extraction and mechanism investigation of trace roxithromycin in real water samples by use of ionic liquid-salt aqueous two-phase system

The ionic liquid, as a green solvent, has several advantages over the organic solvents in traditional liquid-liquid extraction. Aqueous two-phase system (ATPS) consisting of a hydrophilic ionic liquid (1-butyl-3-methylimidazolium tetrafluoraborate, [Bmim]BF(4)) and Na(2)CO(3), which is a novel, simple, non-toxic and effective sample pretreatment technique coupled with molecular fluorescence spectrophotometry, was developed for the simultaneous separation, enrichment and rapid analysis of roxithromycin. The extraction yield of roxithromycin in [Bmim]BF(4)-Na(2)CO(3) aqueous two-phase system is influenced by the types of salts, concentrations of Na(2)CO(3) and [Bmim]BF(4), as well as the extracting temperature. Under the optimum conditions, the average extraction efficiency is up to 90.7%. The mechanism of ionic liquid-salt ATPS formation was discussed by hydration theory, and the extraction mechanism of the [Bmim]BF(4)-salt ATPS was investigated by FT-IR spectroscopy and UV-vis spectroscopy. The results demonstrate that no chemical (bonding) interactions are observed between ionic liquid and roxithromycin, while the nature properties of the roxithromycin are not altered. This method was practical when applied to the analysis of roxithromycin in real water samples with the detection limit of 0.03 microg mL(-1), relative standard deviation (RSD) of 1.9% (n=13), and linear ranges of 1.00-20.00 microg mL(-1). The proposed extraction technique will be promising in the separation of other small biomolecules.

Extraction and determination of papaverin in pericarpium papaveris using aqueous two-phase system of poly(ethylene glycol)–(NH4)2SO4 coupled with high-performance liquid chromatography

Based on aqueous two-phase system (ATPS) of poly(ethylene glycol) (PEG)-(NH4)2SO4, a simple pretreatment approach was developed for the extraction and determination of papaverin in pericarpium papaveris. The influence factors on phase behavior of the ATPS and partition behavior of papaverin was investigated, and partition mechanism based on the hydrophobic interaction between PEG and analyte molecules was proposed. Under the optimal conditions, the extraction efficiencies for papaverin were 93-96%, and the recoveries of the added standard were 97-106% with relative standard deviations of 1.8-2.5%. Combined with a high-performance liquid chromatography (HPLC) method, this extraction technique has been successfully applied to the determination of papaverin in pericarpium papaveris with the detection limit of 2 ng mL(-1) and the linear range of 0.10-10 microg mL(-1). Compared with the conventional liquid-liquid extraction or solid-phase extraction, this method was more environmentally benign, more cost effective and much simpler due to the direct injection of the upper phase into HPLC system.

Quantitative determination of cationic modified polysaccharides on hair using LC–MS and LC–MS–MS

Cationic polysaccharides containing N-hydroxypropyl-N,N,N-trimethylammonium substituents are widely used as conditioning agents for hair-care products. A sensitive method has been developed for the quantitation of these polymers. After acidic extraction from hair the polysaccharides are hydrolyzed using trifluoroacetic acid. The cationic monoglycosides are determined using liquid chromatography-tandem mass spectrometry (LC-MS-MS). The developed method is independent of hair treatment. Even hair cut from test persons after customary hair wash can be analyzed. After treatment of natural and bleached hair tresses using a real-life treatment procedure 180 microg and 300 microg of polymer per gram hair were quantified, respectively. Additionally the fragmentation mechanism of the cationic N-hydroxypropyl-N,N,N-trimethylammonium group during electrospray ionization was investigated. A mass loss of 60 Da in combination with loss of a single charge is observed and associated with cleavage of trimethylamine and a proton. It is assumed that this process is promoted by the anionic counter-ion which might be hydroxide in an aqueous environment.