Analysis of the isomeric composition of the proline peptide bond in an angiotensin-converting enzyme inhibitor using capillary electrophoresis

Following a Folding Transition with Capillary Electrophoresis and Ion Mobility Spectrometry

Ion mobility spectrometry (IMS) is increasingly used to describe solution-phase phenomena and has recently been used to establish the presence of multiple intermediates during the folding of a model polypeptide, polyproline. These observations, however, are made on gas-phase structures. Capillary electrophoresis (CE) is a complementary solution-phase technique, also based on the separation of charged species as a function of size and charge. Here, both ion mobility and capillary electrophoresis are used to follow the folding transition of a 13-mer polyproline peptide from the all-cis polyproline I (PPI) conformation to the all-trans polyproline II (PPII) conformation upon immersion in aqueous solvent. Synchronous folding processes are observed using both techniques. Eight conformers are observed using ion mobility. Although only five peaks are observed using capillary electrophoresis, these peaks can be modeled as sums of the observed IMS conformers; this is strong evidence that ion mobility is sampling solution-phase structures. CE measurements provide the first direct evidence that multiple folding intermediates are present in solution.

Development of a capillary electrophoresis method for the assay of ramipril and its impurities: an issue of cis-trans isomerization

The development of a rapid and selective capillary electrophoresis method for the quantitation of ramipril and its eight main impurities in pharmaceutical dosage form is described. Ramipril and three of its impurities contain a proline-similar moiety which causes in solution the presence of interconverting cis-trans isomers with respect to the amide bond. The interplay between electrophoretic migration and isomerization may yield the presence of an undesired interconversion zone between the two isomer peaks in the electropherogram, depending on the experimental conditions. Different capillary electrophoresis operative modes and pseudostationary phases were evaluated, both in normal and reverse polarity, in order to find the essential analytical parameters which could make it possible to overcome this issue and thus accurately quantify the analytes. The best results were obtained by using microemulsion electrokinetic chromatography in reverse polarity, where all the compounds which undergo cis-trans interconversion migrate as a single narrow peak. Experimental design led to identification of the following optimised conditions: background electrolyte, microemulsion made by 88.95% of 90 mM phosphate pH 2.5, 1.05% of n-heptane and 10.00% of SDS/n-butanol in 1:2 ratio; voltage, -26 kV; temperature, 17°C. Applying these conditions, the baseline separation of the analytes was obtained in about 10 min. Validation of the method following ICH guidelines was carried out and the procedure was applied to a real sample of ramipril tablets.

The sensitivity of the cis/trans-isomerization of enalapril and enalaprilat to solvent conditions

The cis- and trans-isomers of enalapril and enalaprilat can be resolved by HPLC and by capillary electrophoresis. The isomeric content of enalapril is perturbed by the ionization of both its carboxyl and amine groups, while the isomeric content of enalaprilat is only perturbed by the ionization of its amine group. Increasing the hydrophobicity of the analyte solvent, as reflected in its molar polarization, increases the Z (cis) content of enalapril and markedly decreases the kinetics for isomerization. Far UV circular dichroic measurements suggest that the increase in Z (cis) content of enalapril is due to protonation of its carboxylate group. Taken together, the in-vitro properties of enalapril and enalaprilat suggest that the in-vivo transformation of the prodrug enalapril to the inhibitor enalaprilat and its delivery to angiotensin-converting enzyme should not be significantly limited by cis/trans-isomerization.

Counter-current chromatographic estimation of hydrophobicity of Z-(cis) and E-(trans) enalapril and kinetics of cis/trans isomerization

The kinetics of Z-(cis)/E-(trans) isomerization of enalapril was investigated by reversed phase high-performance liquid chromatography (RP-HPLC) using a monolith ODS column under a series of different temperature and pH conditions. At a neutral pH 7, the rate (k(obs)) of Z-(cis)/E-(trans) isomerization of enalapril at 4 degrees C (9.4 x 10(-3)min(-1)) is much lower than at 23 degrees C (1.8 x 10(-1)min(-1)), while the fractional concentration of Z-(cis) isomer is always higher than that of E-(trans) isomer in the pH range 2-7. The fractional concentration of the E-(trans) isomer becomes a maximum (about 40%) in the pH range 3-6, where enalapril exists as a zwitterion. The hydrophobicity (logP(O/W)) of both isomers was estimated by high-speed counter-current chromatography (HSCCC). Normal phase HSCCC separation using a tert-butyl methyl ether-acetonitrile-20mM potassium phosphate buffer (pH 5) two-phase solvent system (2:2:3, v/v/v) at 4 degrees C was effective in partially separating the isomers, and the partition coefficient (K) of each isomer was directly calculated from the retention volume (V(R)). The logP(O/W) values of Z-(cis) and E-(trans) isomers were -0.46 and -0.65, respectively.

Recent developments in capillary electrophoresis and capillary electrochromatography of peptides

The article gives a comprehensive review on the recent developments in the applications of high-performance capillary electromigration methods, zone electrophoresis, isotachophoresis, isoelectric focusing, affinity electrophoresis, electrokinetic chromatography, and electrochromatography, to analysis, preparation, and physicochemical characterization of peptides. The article presents new approaches to the theoretical description and experimental verification of electromigration behavior of peptides, covers the methodological aspects of capillary electroseparations of peptides, such as rational selection of separation conditions, sample preparation, suppression of peptide adsorption, new developments in individual separation modes, and new designs of detection systems. Several types of applications of capillary electromigration methods to peptide analysis are presented: conventional qualitative and quantitative analysis, purity control, determination in biomatrices, monitoring of chemical and enzymatical reactions and physical changes, amino acid and sequence analysis, and peptide mapping of proteins. Some examples of micropreparative peptide separations are given and capabilities of capillary electromigration techniques to provide important physicochemical characteristics of peptides are demonstrated.

Determination of saikosaponins a, c, and d in Bupleurum Chinese DC from different areas by capillary zone electrophoresis

A fast capillary zone electrophoresis (CZE) method was developed for the determination and separation of saikosaponins a, c, and d in Chinese herbal extracts of Bupleurum Chinese DC from different areas. Detection at 214 nm with a system containing sodium borate buffer and mono-3-phenylcarbamoyl-beta-CD was found to be the most suitable approach for this analysis. Saikosaponins a, c, and d could be easily determined within 8 min. The effect of the concentration of mono-3-phenylcarbamoyl-beta-CD, the concentration of the running buffer and buffer pH value on the migration behavior of the saikosaponins is discussed.

ACE-inhibitory activity and structural properties of peptide Asp-Lys-Ile-His-Pro [beta-CN f(47-51)]. Study of the peptide forms synthesized by different methods

Some of the most potent ACE-inhibitory peptides described in food have a proline at the end of their sequence, a characteristic that can cause problems in the synthesis procedures. In this work, we studied two different preparations of peptide Asp-Lys-Ile-His-Pro (DKIHP), which were obtained by two different synthetic procedures (Boc and Fmoc). The peptide synthesized by the Boc method yielded a unique conformer, containing trans-Pro, and significant ACE-inhibitory activity (IC(50) = 113.18 microM). The chromatographic and NMR data of this active conformer are reported. The peptide synthesized by Fmoc chemistry yielded three conformers, two of them containing trans-Pro and a third one containing cis-Pro, and showed a lower activity (IC(50) = 577.92 microM). This was attributed to the presence of conformers with less (or none) activity. We have pointed out the importance of performing structural studies on these type of peptides before testing their ACE-inhibitory activity.