Speciation of chromium dyes by high-performance liquid chromatography with inductively coupled plasma mass spectrometric detection

EDTA excess Zn(II) back-titration in the presence of 4-(2-pyridylazo)-resorcinol indicator and naphthol green beta as inert dye for determining Cr(III) as Cr(III)/EDTA complex: application of the method to a leather industry wastewater

The colour changes of 4-(2-pyridylazo)-resorcinol and naphthol green beta as new screening metallochromic indicator in back-titration of EDTA excess with Zn(II) to determine Cr(III)/EDTA complex was investigated with the help of tristimulus colorimetry. Specific colour discrimination (SCD) and L*, a*, b* 1976 parameters were successfully applied to evaluate the quality of colour transition at the end-point in non-alkaline media and in the presence of Zn(II) and Ca(II) which resulted in non-interfering species at 1x10(-3) M and 2x10(-3) M, respectively. The above concentrations are comparable with those used for Cr(III). Validation of the fast and accurate reported method was performed by atomic absorption spectroscopy. Moreover, the method was applied for determining Cr as Cr(III) in a wastewater effluent deriving from a leather industry.

Simultaneous determination of Cr(III)–EDTA and Cr(VI) by ion interaction chromatography using a C18 column

The simultaneous determination of Cr(III) and Cr(VI) by ion interaction chromatography has been investigated. The mobile phase consisted of a 5 mM octylammonium orthophosphate at pH 4.0 with 35% (v/v) MeOH. The Nucleosil-100, C18 (5 microm, 250 x 4.6 mm) was used as the separating column and the component was detected at 200 nm. The separation of Cr(III) and Cr(VI) was based on anionic interaction. Since the Cr(III) did not exist as an anionic form like the Cr(VI) (Cr2O7(2-)) presented at the optimum condition, Cr(II) was firstly reacted with EDTA (1:40 mole ratio) to form the anionic complex prior to injecting into the chromatographic system. The characteristics of the method for separation of Cr(III)-EDTA and Cr(VI) were satisfactory. The wide linear range (0.3-50.0 mg l(-1)) was achieved. The repeatabilities (%R.S.D.) calculated from peak areas were 0.49% and 0.14%, detection limit (signal to noise ratio of 3) of 0.02 mg l(-1) and 0.3 mg l(-1) were obtained and the average of percent recoveries were found to be 98.5% and 99.6% for Cr(III) and Cr(VI), respectively.

Liquid chromatography-inductively coupled plasma mass spectrometry

The technique of coupling liquid chromatography to inductively plasma mass spectrometry (ICP-MS) is reviewed. A brief introduction to the ICP-MS instrument is given as well as methods to couple the two analytical instruments together. The various types of LC that have been used with ICP-MS detection are discussed and advantages over traditional methods of detection are highlighted, such as the improvements in sensitivity and selectivity. Several applications that have been described in the literature are reviewed. An outlook for the future of LC-ICP-MS, particularly with regard to elemental speciation is given.

Inductively coupled plasma mass spectrometric detection for chromatography and capillary electrophoresis

Inductively coupled plasma mass spectrometry (ICP-MS) is now a well established detection technique for liquid chromatography, gas chromatography, supercritical fluid chromatography and capillary electrophoresis. A review of the literature with particular regard to ICP-MS as a chromatographic and capillary electrophoretic detector is presented. The various modes of chromatography and capillary electrophoresis are discussed and practical descriptions for hyphenating the techniques with the ICP mass spectrometer are given. Sample introduction systems and data acquisition methods are reviewed along with the numerous applications of ICP-MS as a chromatographic detector. In addition, alternative plasma sources, such as the atmospheric and reduced pressure helium microwave-induced plasmas for chromatographic detection are described.