Sample preparation for GC analysis of selected pesticides in surface water

Optimization of a Multiresidue Analysis of 65 Pesticides in Surface Water Using Solid-Phase Extraction by LC-MS/MS

An analytical method was developed and validated for simultaneous quantitation of 65 pesticides, including one single solid-phase extraction (SPE) procedure in surface water by liquid chromatography coupled to tandem mass spectroscopy. Different parameters that have an influence on extraction efficiency were evaluated in this research. Different types of cartridges, elution solvents, and sorbent drying time were investigated, and the most appropriate one was selected. Moreover, various pretreatment techniques were applied to remove sediments from water without the loss of pesticides. Centrifugation was introduced as the best option at the beginning of sample preparation to resolve the clogging of the sorbent cartridges. The recoveries of all pesticides ranged from 70% to 120%, with a relative standard deviation of less than 13.7%. The feasibility of the method was evaluated on 10 surface water samples with different concentrations of sand, sediment, and particles.

Green approach for simultaneous determination of multi-pesticide residue in environmental water samples using excitation-emission matrix fluorescence and multivariate calibration

Pesticides are among the most widespread organic contaminants in aquatic environments. In this work, a new green fluorescence application was proposed for the simultaneous determination of four widely employed pesticides in environmental water samples. To overcome the highly overlapped spectra within the analytes, and with the tissue matrix interferences in complex solutions, we have used the multivariate calibration methods such as parallel factor analysis (PARAFAC) and unfolded partial least squares coupled to residual bilinearization (U-PLS/RBL). These four pesticides can be identified simultaneously, and the correlation coefficients between resolved and actual spectra are all above 0.95. The second-order advantage allowed the determination of four pesticides at the ng mL^-1 level, even in the presence of humic acid (HA). The best results were obtained with the limits of detection of 1.72-18.69 for Carbendazim (CBZ), 0.30-5.19 for carbaryl (CAR), 0.35-6.32 for chlorothalonil (CHL), and 4.92-29.96 for tsumacide (TSU) (ng mL^-1), which can fully meet the quantitative detection and analysis requirements of trace pesticides in water samples. The real water sample of Bohai Seawater was used to check the performance of this approach in practical applications, which have achieved good prediction results of U-PLS/RBL. This study demonstrated the proposed method is rapid, accurate, sensitive, low detection limit, and environmentally friendly to determinate multi-pesticide residues in environmental water samples.

Multi-residues analysis of pre-emergence herbicides in fluvial sediments: application to the mid-Garonne River

Contamination of man and ecosystems by pesticides has become a major environmental concern. Whereas many studies exist on contamination from agriculture, the effects of urban sources are usually omitted. Fluvial sediment is a complex matrix of pollutants but little is known of its recent herbicide content. This study proposes a method for a fast and reliable analysis of herbicides by employing the accelerated solvent extractor (ASE). The aim of the study is to show the impact of a major town (Toulouse) on the herbicide content in the river. In this study, three herbicide families (i.e.s-triazine, substituted ureas and anilides) were analysed in fluvial sediment fractions at 11 sampling sites along the mid-Garonne River and its tributaries. River water contamination by herbicides is minor, except for at three sites located in urban areas. Among the herbicidal families studied, urban and suburban areas are distinguished from rural areas and were found to be the most contaminated sites during the study period, a winter low-water event. The herbicide content of the coarse sediment fractions is about one third of that found in the fine fractions and usually ignored. The distribution of pesticide concentrations across the whole range of particle sizes was investigated to clarify the role of plant remains on the significant accumulation in the coarse fractions.

Extracting Syringe for determination of organochlorine pesticides in leachate water and soil-water slurry: a novel technology for environmental analysis

The Extracting Syringe (ESy), a novel membrane-based sample preparation technique directly coupled as an autosampler to gas chromatography, has been employed for the analysis of organochlorine pesticides (OCPs) in raw leachate water. The ESy has also been applied for extraction of OCPs from contaminated soil samples and its performance has been compared to liquid-solid extraction (LSE) and accelerated solvent extraction (ASE). Extraction of 3-mL leachate sample at the optimised conditions resulted in enrichment factors from 32 (Endrin aldehyde) to 242 (Endrin) and detection limits from 1 to 20 ng/L. The inter-day and intra-day repeatability (% RSD) at 100 and 500 ng/L were <6% and <24%, respectively. The relative recovery at 100 and 500 ng/L ranged from 68% (Aldrin) to 116% (Endrin aldehyde); except Heptachlor that showed 51 and 60%, respectively. The ESy extraction of the slurry-made soil samples revealed occurrence of Endosulfan I (18.2 microg/g soil), 4,4'-DDE (2.6 ng/g soil), Endosulfan II (8.7 microg/g soil) and Endosulfan sulfate (1.1 microg/g soil); showing good agreement with LSE results. The total ESy consumption of organic solvents was 4.2 mL from which only 0.6 mL n-undecane was used during the extraction step (7 microL for the extraction per se), while in the LSE and ASE, it was 420 and 18.1 mL, respectively. The ESy extraction time (0.5 h) was comparable to the ASE time (0.6 h); and the time required for the LSE was 3.75 h. To sum up, the ESy has shown its competency to LSE and ASE technologies, demonstrating its applicability for environmental analysis of organic pollutants, towards green techniques for green environment.

Sol-gel glass immunosorbent-based determination of s-triazines in water and soil samples using gas chromatography with a nitrogen phosphorus detection system

A rapid and efficient method for the selective extraction of s-triazine herbicides in environmental samples was developed using an immunosorbent of monoclonal antiatrazine antibodies, which were encapsulated in a sol-gel glass matrix. The cross-reactivity of the antibody for analytes structurally related with atrazine enabled the simultaneous extraction of several s-triazine herbicides (atrazine, propazine, terbuthylazine, cyanazine, desethyl atrazine). After trace enrichment on the immunoextraction column, the s-triazines were desorbed by means of an acidic buffer (pH 2.5) and further extracted with ethyl acetate before being injected into the GC. Compared to liquid-liquid extraction and solid-phase extraction with a hydrophobic SDB-L support, the GC-NPD chromatograms obtained after immunoaffinity enrichment of surface water (river water) samples or soil extracts and analysis were free from matrix interferences. Nonspecific adsorption of humic acids was not observed. The method allows for the determination of the herbicides in linear ranges up to 1.5 microg/L with correlation coefficients higherthan 0.99 and relative standard deviations between 4% and 7% (n = 5). The LODs for 50-mL water samples were in the range 0.02 microg/L (atrazine, propazine) to 0.1 microg/L (desethyl atrazine) (S/N = 3). In addition to its high selectivity, the immunosorbent proved to be reusable for a significant number of preconcentration runs. However, the composition of samples may influence the lifetime of the column.