Determination of cisapride, its oxidation product, propyl and butyl parabens in pharmaceutical dosage form by reversed-phase liquid chromatography

A New Validated HPLC Method for the Simultaneous Determination of 2-phenoxyethanol, Methylparaben, Ethylparaben and Propylparaben in a Pharmaceutical Gel

A novel reversed-phase HPLC method has been developed and validated for the simultaneous determination of 2-phenoxyethanol, methylparaben, ethylparaben and propylparaben preservatives. The method uses a Lichrosorb C8 (150×4.6 mm, 5 µm) column and isocratic elution. The mobile phase consisted of a mixture of acetonitrile, tetrahydrofuran and water (21:13:66, v/v/v), pumped at a flow rate of 1 ml/min. The UV detection was set at 258 nm. The method was validated with respect to accuracy, precision (repeatability and intermediate precision), specificity, linearity and range. All the parameters examined met the current recommendations for bioanalytical method validation. The developed method was successfully applied to the determination of commercially available pharmaceutical gel products for these preservatives. The procedure describes here is simple, selective and reliable for routine quality control analysis and stability tests.

Determination of methylparaben from cosmetic products by ultra performance liquid chromatography

A new method for the determination of methylparaben by ultra-performance liquid chromatography (UPLC) was developed. Methylparaben is often used as preservative, alone or in combination with other parabens, being added to cosmetic products, pharmaceutical products and foods to avoid microbial contamination. Due to its widespread use and potential risk to human health, assessing human exposure to this compound is of interest. A good determination and quantification of methylparaben was developed with a gradient elution using a mixture of methanol and water (60:40, v/v) within 1.455 min. Under optimized conditions, the linear working range extends over two orders of magnitude with relative standard deviations of intra- and inter-day precision below 2.3 %, and a detection limit of 0.02 ng ?L-1 for methylparaben. The proposed method was successfully applied to the assay of methylparaben in cosmetic products with minimal sample preparation.

Counterfeit homeopathic medicinal products: syrups. A simple and rapid LC-ESI-MS method to detect preservatives not declared in label

A rapid and simple LC-ESI-MS method for the simultaneous detection and quantitation of six preservatives in homeopathic syrups has been developed. Counterfeit homeopathic syrups are suspected to contain preservatives that are not declared in label. For this reason a method to ascertain the absence of sorbic and benzoic acids, methyl-, ethyl-, propyl- and butyl-parabens, as the most frequently utilised preservatives, has been developed. Analytes were eluted with a linear gradient of acetonitrile-5mM ammonium acetate in 12 min using 2,4-dichlorobenzylalchol as Internal Standard. The HPLC separation was performed on an Eclipse XDB-C18 (2.1 mm x 50 mm-5 microm) column and the ESI-MS detection was performed in negative ion mode. Linearity of the method was studied in the range of 2 pg to 10 ng injected and correlation coefficients r2 > or =0.9992 were obtained. LOD ranged from 0.04 to 0.4 ng mL(-1).

Assay of artemether, methylparaben and propylparaben in a formulated paediatric antimalarial dry suspension

Two HPLC-UV methods are described for the separate determination of artemether (AM) and the combined preservatives, methylparaben and propylparaben in a pharmaceutical dosage form. These analytes are contained in a dry suspension with a high amount of non-soluble excipients, some of which can interfere with the analysis. This makes their separation and analysis of the actives complex. Moreover, due to the wide difference in concentrations, the three analytes could not be quantitated simultaneously. Artemether was analysed using a reversed-phase Nucleosil C(18) column [5 microm, 125 mm x 4 mm (i.d.)] with a mixture of acetonitrile: potassium phosphate buffer pH 5.0 (0.05 M): water [48:32:10 (v/v/v)] as mobile phase. Due to the low solubility of the hydroxy benzoic acid esters in water, their sodium salts were used in the formulation. Complete separation of these preservatives was achieved on the same type of column as artemether using as eluent acetonitrile: potassium phosphate buffer pH 5.0 (0.05 M) (30:70, v/v). Quantitation was achieved with UV detection at 215 nm for artemether and 254 nm for the parabens, respectively. And in both methods, pump flow rate was 1.0 ml/min, sample injection volume 20 microl, ambient temperature maintained and no prior sample extraction methods were necessary throughout the experiments. Calibration curves were linear at concentration ranges of 4-16 microg/ml, 1-4 microg/ml and 1-10 mg/ml for methylparaben, propylparaben and artemether respectively. The excipient powder interference could be eliminated by diluting the sample and the analytes eluted at relatively short times using these systems. Both methods were further validated in terms of specificity, linearity, precision and accuracy. The procedures prescribed here are simple, selective and can be used for routine quality control and stability indicating tests involving the analysed compounds formulated in complex matrices.