Use of LC-MS/MS to cross-validate a radioimmunoassay for the fibrinogen receptor antagonist, Aggrastat (tirofiban hydrochloride) in human plasma

Assay of tirofiban and identification of oxidative impurity in aqueous injection by using UPLC-PDA/QDa detectors

The basic objective of this study is to propose a short, reliable, mass compatible ultra-performance liquid chromatography (UPLC) method to confirm the identity of impurities and to estimate the assay and purity of Tirofiban simultaneously in aqueous injection (5mg/100mL bag). Aqueous formulations are susceptible to oxidation, hence the possible oxidative degradation impurities of Tirofiban were studied in this experiment by using UPLC coupled with photodiode array/Quadrupole Dalton Analyzer (PDA/QDa) detectors. The required separations were achieved in the column: ACQUITY HSS T3 (100×2.1) mm, 1.7μm, operated at 30°C by using 0.02% Triethyl amine (TEA) in water, pH 2.8 with formic acid as solution-A and 0.1% formic acid in 9:1 acetonitrile, water as solution-B. Binary gradient flow is delivered at the rate of 0.5mL/min and the detection of impurities specifically carried out at 227nm using empower3 software. RP-UPLC/PDA with QDa detector was used for the experiment. The method was linear and accurate from the concentrations: 0.04 to 0.38μg/mL for impurity-A and 0.04 to 75μg/mL for Tirofiban. The major unknown degradation impurity generated during the oxidative degradation has been identified as N-oxide derivative (Impurity-B) [(M+H)⁺ 455.1] by using QDa detector operated in an electro spray positive ion mode by applying a voltage of 0.8kV. This method was further validated as per ICH Q2 (R2) guidelines. Hence, the proposed method is said to be a fast, sensitive and comprehensive technique, which could give a clear idea about the assay and impurity profile of Tirofiban injection.

Validated spectrofluorimetric methods for the determination of apixaban and tirofiban hydrochloride in pharmaceutical formulations

Apixaban and Tirofiban Hydrochloride are low molecular weight anticoagulants. The two drugs exhibit native fluorescence that allow the development of simple and valid spectrofluorimetric methods for the determination of Apixaban at λ ex/λ em=284/450nm and tirofiban HCl at λ ex/λ em=227/300nm in aqueous media. Different experimental parameters affecting fluorescence intensities were carefully studied and optimized. The fluorescence intensity-concentration plots were linear over the ranges of 0.2-6μgml^-1 for apixaban and 0.2-5μgml^-1 for tirofiban HCl. The limits of detection were 0.017 and 0.019μgml^-1 and quantification limits were 0.057 and 0.066μgml^-1 for apixaban and tirofiban HCl, respectively. The fluorescence quantum yield of apixaban and tirofiban were calculated with values of 0.43 and 0.49. Method validation was evaluated for linearity, specificity, accuracy, precision and robustness as per ICH guidelines. The proposed spectrofluorimetric methods were successfully applied for the determination of apixaban in Eliquis tablets and tirofiban HCl in Aggrastat intravenous infusion. Tolerance ratio was tested to study the effect of foreign interferences from dosage forms excipients. Using Student's t and F tests, revealed no statistically difference between the developed spectrofluorimetric methods and the comparison methods regarding the accuracy and precision, so can be contributed to the analysis of apixaban and tirofiban HCl in QC laboratories as an alternative method.

Determination of Tirofiban in human serum by liquid chromatography–tandem mass spectrometry

A liquid chromatography-tandem mass spectrometric (LC-MS-MS) method with a rapid and simple sample preparation was developed and validated for the determination of Tirofiban in biological fluids. Tirofiban in serum samples was extracted and cleaned up by using an automated solid phase extraction method. An external calibration was used. The mass spectrometer was operated in the multiple reaction monitoring mode (MRM). A good linear response over the range of 2-200ng/ml was demonstrated. The accuracy for Tirofiban ranged from 94.8 to 110.8% within-day and from 103.0 to 104.7% between-day. The lower limit of quantification was 2ng/ml. This method is suitable for pharmacokinetic studies.