Enhanced photocatalytic activity of fish scale loaded TiO2 composites under solar light irradiation

MoS2/N-TiO2/Ti mesh plate for visible-light photocatalytic ozonation of naproxen and industrial wastewater: comparative studies and artificial neural network modeling

This paper presents the results of visible-light assisted photocatalytic ozonation for the degradation of naproxen as a model pharmaceutical pollutant from water using MoS₂/N-TiO₂ immobilized on a titanium mesh plate in addition to treatment of a real industrial wastewater. The batch studies were performed for naproxen degradation by varying the reaction variables such as ozone flow rate, initial pH and pollutant concertation. It was observed that almost 90% degradation was achieved at pH = 4, ozone flow rate = 3 L min^-1 and initial naproxen concentration = 5 mg L^-1. The catalyst exhibited constant activity even after seven successive cycles. Comparative studies among sorption, ozonation, photocatalysis, catalytic ozonation and photocatalytic ozonation revealed that the later process had the highest degradation of pollutant. Moreover, an artificial neural network (ANN) model was developed to simulate the performance of visible-light photocatalytic ozonation in naproxen degradation. The developed ANN model could estimate the visible-light photocatalytic ozonation process under the different experimental conditions. Finally, the applicability of the photocatalytic ozonation was successfully approved for industrial wastewater treatment. The results showed that the COD removal efficiency reached 65% within 150 min. HIGHLIGHTS: • MoS₂/N-TiO₂/Ti was synthesized by the quick electrophoretic deposition method. • The catalyst showed good ability in naproxen degradation via visible-light photocatalytic ozonation. • A three-layer artificial neural network model was developed to predict the naproxen degradation. • Naproxen degradation efficiency through the photocatalytic ozonation was higher than the individual methods. • COD of real wastewater was reduced significantly after the visible-light photocatalytic ozonation process.

Preparation, characterization of fish scales biochar and their applications in the removal of anionic indigo carmine dye from aqueous solutions

The preparation and applications of Tilapia (Oreochromis niloticus) fish scale biochars (FSB) as an adsorbent in the removal of indigo carmine dye (ICD) from aqueous solutions is described. The biochars were prepared through pyrolysis over a temperature range of 200 °C-800 °C and characterized for surface charge, functional groups, thermal stability, particle size and morphology, elemental composition, crystallinity, and surface area by using pH_pzc, Fourier transform infrared (FTIR) spectroscopy, thermo-gravimetric analysis (TGA), transmission electron microscopy/scanning electron microscopy (TEM/SEM), energy dispersive X-ray (EDX) spectroscopy, powder X-ray diffraction (PXRD) and Brunauer-Emmett-Teller (BET) techniques, respectively. Batch experiments were carried out to determine the variation of adsorption process with initial dye concentration, contact time, initial solution pH, adsorbent load, temperature and adsorbent pyrolysis temperature on the removal of the dye. The percentage removal increased with increase in initial dye concentration and adsorbent dosage. A pH of 2 was the most appropriate for the adsorption experiments. The equilibrium data fitted pseudo-first-order kinetics and Freundlich models, while the thermodynamic parameters confirmed that the adsorption process was endothermic.

Fabrication of Bi2O3/TiO2 nanocomposites and their applications to the degradation of pollutants in air and water under visible-light

A nanoheterojunction composite photocatalyst Bi2O3/TiO2 working under visible-light (lambda > or = 420 nm) was prepared by combining two semiconductors Bi2O3 and TiO2 varying the Bi2O3/TiO2 molar ratio. Maleic acid was employed as an organic binder to unite Bi2O3 and TiO2 nanoparticles. The SEM, TEM, XRD and diffuse reflectance spectra were utilized to characterize the prepared Bi2O3/TiO2 nanoheterojunction. The nanocomposite exhibited unusual high photocatalytic activity in decomposing 2-propanol in gas phase and phenol in aqueous phase and, evolution of CO2 under visible light irradiation while the end members exhibited low photocatalytic activity. The composite was optimized to 5 mol% Bi2O3/TiO2. The remarkable high photocatalytic efficiency originates from the unique relative energy band position of Bi2O3 and TiO2 as well as the absorption of visible light by Bi2O3.