Toward Enhancing the Chlorine Resistance of Reverse Osmosis Membranes: An Effective Strategy via an End-capping Technology

More resilient polyester membranes for high-performance reverse osmosis desalination

Thin-film composite reverse osmosis membranes have remained the gold standard technology for desalination and water purification for nearly half a century. Polyamide films offer excellent water permeability and salt rejection but also suffer from poor chlorine resistance, high fouling propensity, and low boron rejection. We addressed these issues by molecularly designing a polyester thin-film composite reverse osmosis membrane using co-solvent-assisted interfacial polymerization to react 3,5-dihydroxy-4-methylbenzoic acid with trimesoyl chloride. This polyester membrane exhibits substantial water permeability, high rejection for sodium chloride and boron, and complete resistance toward chlorine. The ultrasmooth, low-energy surface of the membrane also prevents fouling and mineral scaling compared with polyamide membranes. These membranes could increasingly challenge polyamide membranes by further optimizing water-salt selectivity, offering a path to considerably reducing pretreatment steps in desalination.

Modification Mechanism of Polyamide Reverse Osmosis Membrane by Persulfate: Roles of Hydroxyl and Sulfate Radicals

Oxidative modification is a facile method to improve the desalination performance of thin-film composite membranes. In this study, we comparatively investigated the modification mechanisms induced by sulfate radical (SO₄^• -) and hydroxyl radical (HO^•) for polyamide reverse osmosis (RO) membrane. The SO₄^• -- and HO^•-based membrane modifications were manipulated by simply adjusting the pH of the thermal-activated persulfate solution. Although both of them improved the water permeability of the RO membrane under certain conditions, the SO₄^• --modified membrane notably prevailed over the HO^•-modified one due to higher permeability, more consistent salt rejection rates over wide pH and salinity ranges, and better stability when exposed to high doses of chlorine. The differences of the membranes modified by the two radical species probably can be related to their distinct surface properties in terms of morphology, hydrophilicity, surface charge, and chemical composition. Further identification of the transformation products of a model polyamide monomer using high-resolution mass spectrometry demonstrated that SO₄^• - initiated polymerization reactions and produced hydroquinone/benzoquinone and polyaromatic structures; whereas the amide group of the monomer was degraded by HO^•, generating hydroxyl, carboxyl, and nitro groups. The results will enlighten effective ways for practical modification of polyamide RO membranes to improve desalination performances and the development of sustainable oxidation-combined membrane processes.

Biomolecule-Enabled Liquid Separation Membranes: Potential and Recent Progress

The implementation of membrane surface modification to enhance the performance of membrane-based separation has become a favored strategy due to its promise to address the trade-off between water permeability and salt rejection as well as to improve the durability of the membranes. Tremendous work has been committed to modifying polymeric membranes through physical approaches such as surface coating and ontology doping, as well as chemical approaches such as surface grafting to introduce various functional groups to the membrane. In the context of liquid separation membranes applied for desalination and water and wastewater treatment, biomolecules have gained increasing attention as membrane-modifying agents due to their intriguing structural properties and chemical functionalities. Biomolecules, especially carbohydrates and proteins, exhibit attractive features, including high surface hydrophilicity and zwitterionic and antimicrobial properties that are desired for liquid separation membranes. In this review, we provide an overview of the recent developments in biomolecule-enabled liquid separation membranes. The roles and potentials of some commonly explored biomolecules in heightening the performance of polymeric membranes are discussed. With the advancements in material synthesis and the need to answer the call for more sustainable materials, biomolecules could serve as attractive alternatives for the development of high-performance composite membranes.

Corn Stalk-Derived Carbon Quantum Dots with Abundant Amino Groups as a Selective-Layer Modifier for Enhancing Chlorine Resistance of Membranes

Low permeability and chlorine resistance of normal thin-film composite (TFC) membranes restrict their practical applications in many fields. This study reports the preparation of a high chlorine-resistant TFC membrane for forward osmosis (FO) by incorporating corn stalk-derived N-doped carbon quantum dots (N-CQDs) into the selective polyamide (PA) layer to construct a polydopamine (PDA) sub-layer (PTFC_CQD). Membrane modification is characterized by surface morphology, hydrophilicity, Zeta potential, and roughness. Results show that TFC_CQD (without PDA pretreatment) and PTFC_CQD membranes possess greater negative surface charges and thinner layer-thickness (less than 68 nm). With N-CQDs and PDA pretreatment, the surface roughness of the PTFC_CQD membrane decreases significantly with the co-existence of microsized balls and flocs with a dense porous structure. With the variation of concentration and type of draw solution, the PTFC_CQD membrane exhibits an excellent permeability with low J_{(reverse salt flux)}/J_{(water flux)} values (0.1-0.25) due to the enhancement of surface hydrophilicity and the shortening of permeable paths. With 16,000 ppm·h chlorination, reverse salt flux of the PTFC_CQD membrane (8.4 g m^-2 h^-1) is far lower than those of TFC_CQD (136.2 g m^-2 h^-1), PTFC (127.6 g m^-2 h^-1), and TFC (132 g m^-2 h^-1) membranes in FO processes. The decline of salt rejection of the PTFC_CQD membrane is only 8.2%, and the normalized salt rejection maintains 0.918 in the RO system (16,000 ppm·h chlorination). Super salt rejection is ascribed to the existence of abundant N-H bonds (N-CQDs), which are preferentially chlorinated by free chlorine to reduce the corrosion of the PA layer. The structure of the PA layer is stable during chlorination also due to the existence of various active groups grafted on the surface. This study may pave a new direction for the preparation of durable biomass-derivative (N-CQD)-modified membranes to satisfy much more possible applications.

Separation, anti-fouling, and chlorine resistance of the polyamide reverse osmosis membrane: From mechanisms to mitigation strategies

Membrane technology has been widely used in the wastewater treatment and seawater desalination. In recent years, the reverse osmosis (RO) membrane represented by polyamide (PA) has made great progress because of its excellent properties. However, the conventional PA RO membranes still have some scientific problems, such as membrane fouling, easy degradation after chlorination, and unclear mechanisms of salt retention and water flux, which seriously impede the widespread use of RO membrane technology. This paper reviews the progress in the research and development of the RO membrane, with key focus on the mechanisms and strategies of the contemporary separation, anti-fouling and chlorine resistance of the PA RO membrane. This review seeks to provide state-of-the-art insights into the mitigation strategies and basic mechanisms for some of the key challenges. Under the guidance of the fundamental understanding of each mechanism, operation and modification strategies are discussed, and reasonable analysis is carried out, which can address some key technical challenges. The last section of the review focuses on the technical issues, challenges, and future perspective of these mechanisms and strategies. Advances in synergistic mechanisms and strategies of the PA RO membranes have been rarely reviewed; thus, this review can serve as a guide for new entrants to the field of membrane water treatment and established researchers.

Utilization of Bidirectional Cation Transport in a Thin Film Composite Membrane: Selective Removal and Reclamation of Ammonium from Synthetic Digested Sludge Centrate via an Osmosis-Distillation Hybrid Membrane Process

Selective removal and resource recovery of ammonium nitrogen (NH₄⁺-N) from high-strength ammonium waste streams is of practical importance for biological wastewater treatment and environmental protection. In this study, we demonstrate the simultaneous removal and reclamation of ammonium from synthetic digested sludge centrate via a novel osmosis-distillation hybrid membrane (ODHM) process. Using NaHCO₃ as the draw solute, ammonium diffuses from the synthetic centrate to the draw solution by utilizing the bidirectional cation transport nature of the thin film composite (TFC) membrane. Then, NH₄⁺ is converted to gaseous NH₃ at 60 °C and recovered by a sweeping gas membrane distillation (SGMD) process. Herein, the bidirectional transport of monovalent cations in the osmotic process, selectivity of TFC membranes for different cations, and recovery of the draw solution following the extraction of ammonia through the SGMD process were systematically investigated. The removal of NH₄⁺-N from the synthetic centrate achieved 21.34% during a 6-h continuous operation of the ODHM system, with ammonium fluxes through the TFC and SGMD membranes at 1.39 and 0.57 mol m^-2 h^-1, respectively. A secondary interfacial polymerization was proposed to further enhance ammonium transport through the TFC membrane. Results reported here highlight the potential of the ODHM process for the selective removal and reclamation of ammonium from ammonium-rich waste streams.

Custom-Tailoring Loose Nanofiltration Membrane for Precise Biomolecule Fractionation: New Insight into Post-Treatment Mechanisms

Loose nanofiltration (NF) membranes with diverse selectivity can meet the great demands in various bioseparation applications. Thus, a facile strategy to tune the properties such as pore size, surface charge, and hydrophilicity of the NF membrane is required to produce tailor-made loose NF membranes without changing the existing production line. Herein, we systematically investigated the post-treatment of the nascent poly(piperazine amide) NF membranes using different reagents (organic acids, weak bases, organic solvents and ionic liquid (IL)). Various characterizations revealed that the skin/separation layer became looser and permeance was promoted with the decrease of salt rejection in varying degrees. It was found that the O/N ratio did not rigorously represent the cross-linking degree of the skin layer, because besides the hydrolysis of the residual acyl chloride impeding the amido bond formation, the breaking of existing amido bonds and the grafting of free trimesoyl chloride molecules on the nascent membranes could also increase the O/N ratio during post-treatments. Then three mechanisms including hydrolysis, swelling rearrangement and capping reaction effects were proposed to better understand the membrane properties variations. All these effects resulted in larger pore size of the NF membrane, and the hydrolysis/capping effect might increase negative charge and hydrophilicity on the membrane, while the swelling rearrangement could produce less defective skin structure. These three effects might be involved together during a single treatment. Finally, the NF membrane post-treated by N-hexane could efficiently separate antibiotics and NaCl with the highest permeate flux, whereas the one post-treated by ionic liquid outperformed others for the decoloration of cane molasses (much more efficient than NF270, DL, and NTR7450 membranes). The long-term operating stability of the post-treated membranes selected was also confirmed by a continuous crossflow filtration for 15 h with regular alkaline cleaning.

A Review on Reverse Osmosis and Nanofiltration Membranes for Water Purification

Sustainable and affordable supply of clean, safe, and adequate water is one of the most challenging issues facing the world. Membrane separation technology is one of the most cost-effective and widely applied technologies for water purification. Polymeric membranes such as cellulose-based (CA) membranes and thin-film composite (TFC) membranes have dominated the industry since 1980. Although further development of polymeric membranes for better performance is laborious, the research findings and sustained progress in inorganic membrane development have grown fast and solve some remaining problems. In addition to conventional ceramic metal oxide membranes, membranes prepared by graphene oxide (GO), carbon nanotubes (CNTs), and mixed matrix materials (MMMs) have attracted enormous attention due to their desirable properties such as tunable pore structure, excellent chemical, mechanical, and thermal tolerance, good salt rejection and/or high water permeability. This review provides insight into synthesis approaches and structural properties of recent reverse osmosis (RO) and nanofiltration (NF) membranes which are used to retain dissolved species such as heavy metals, electrolytes, and inorganic salts in various aqueous solutions. A specific focus has been placed on introducing and comparing water purification performance of different classes of polymeric and ceramic membranes in related water treatment industries. Furthermore, the development challenges and research opportunities of organic and inorganic membranes are discussed and the further perspectives are analyzed.