Ab Initio Study of CO2 Activation on Pristine and Fe-Decorated WS2 Nanoflakes

Fe2O3 Nanoflakes - WS2 Nanosheets Heterojunctions for Multi-Fold Enhancement in Photoelectrochemical Solar Energy Conversion

Fe2O3-based photoanodes show great potential in photoelectrochemical water splitting due to their excellent stability, moderate band gap, and abundance. However, a short hole diffusion length limits its photocurrent density. Here, a multi-fold enhancement in photocurrent density from Fe2O3 nanoflakes - WS2 nanosheets heterojunction is reported. The heterojunction exhibits a synergistic photocurrent density of 0.52 mA cm-2 at 1.3 V (versus RHE) under AM 1.5G simulated sunlight, which is 2.23 times higher than pristine Fe2O3 nanoflakes. The Mott-Schottky and Nyquist plots indicate a higher charge density with lower charge transfer resistance at the semiconductor-electrolyte junction. The density functional theory (DFT) -based first-principles calculations are performed by designing a heterostructure between Fe2O3(110) and WS2(001) similar to the experimentally found arrangement of crystal planes. Free energy analysis and relative band extrema positions, obtained from DFT calculations and valence band spectroscopy, indicate the formation of type II heterojunction with partial oxygen terminated surface of Fe2O3. The type-II band alignment with a charge transfer of 4.8 × 10-4 e per interfacial WS2 to Fe2O3, helps in easy separation of photogenerated charges. The work establishes both an experimental design and a theoretical framework of highly crystalline nanoflakes-nanosheet heterojunctions for efficient photoelectrochemical solar energy conversion.

Edge engineering on layered WS2 toward the electrocatalytic reduction of CO2: a first principles study

Transition-metal dichalcogenides (TMDCs) have been modified to show excellent electrocatalytic performance for the CO₂ reduction reaction (CO₂RR). However, little research has been reported on the edge modification of WS₂ and its electrocatalytic CO₂RR. In this work, the edge structure of WS₂ with W atoms exposed in the top layer was established by density functional theory calculations. Through using WS₂-xTM-y (x = 1, 2 or 3; y = 1 or 2; TM = Zn, Fe, Co or Ni) models by doping TM atoms on the top layer of WS₂, the effects of dopant species, doping concentration and adsorption sites on their electrocatalytic activity were investigated. Among the models, the active site for the CO₂RR is the W atoms. The doping of TM atoms would affect the bond strength between W and S atoms. After the doping of TM atoms in WS₂-2TM-1 ones, the electrical conduction of S atoms and the underlying W atoms can greatly be improved. Thus the catalytic activities can be significantly increased, in which the WS₂-2Zn-1 model shows the best catalytic activity. The limiting potential (U_L) of the CO₂RR to CO on the WS₂-2Zn-1 model is -0.51 V and the Gibbs energy change (ΔG) for the adsorption of intermediates on the WS₂-2Zn-1 model is ΔG(COOH*) = -0.37 and ΔG(CO*) = -0.51 eV, respectively. Solvation correction showed that WS₂-2Zn-1 could maintain good catalytic performance in a wide range of pH values. The present results may provide a theoretical basis for the design and synthesis of novel electrocatalysts with high performance for the CO₂RR.