Low Operating Voltage Organic Field-Effect Transistors with Gelatin as a Moisture-Induced Ionic Dielectric Layer: The Issues of High Carrier Mobility

In-depth theoretical analysis of the influence of an external electric field on charge transport parameters

It is important to develop materials with environmental stability and long device shelf life for use in organic field-effect transistors (OFETs). The microscopic, molecular-level nature of the organic layer in OFETs is not yet well understood. The stability of geometric and electronic structures and the regulation of the external electric field (EEF) on the charge transport properties of four typical homogeneous organic semiconductors (OSCs) were investigated by density functional theory (DFT). The results showed that under the EEF, the structural changes in single-bond linked oligomers were more sensitive and complex than those of condensed molecules, and there were non-monotonic changes in their reorganization energy (λ) during charge transport under an EEF consisting of decreases and then increases (Series D). The change in λ under an EEF can be preliminarily and qualitatively determined by the change in the frontier molecular orbitals (FMOs) - the number of C-atoms with nonbonding characteristics. For single-bonded molecules, the transfer integral is basically unchanged under a low EEF, but it will greatly change at a high EEF. Because the structure and properties of the molecule will greatly change under different EEFs, the effect of an EEF should be fully considered when determining the intrinsic mobility of OSCs, which could cause a deviation 0.3-20 times in mobility. According to detailed calculations, one heterogeneous oligomer, TH-BTz, was designed. Its λ can be greatly reduced under an EEF, and the change in the energy level of FMOs can be adjusted to different degrees. This study provides a reasonable idea for verification of the experimental mobility value and also provides guidance for the directional design of stable high-mobility OSCs.

Trainable Bilingual Synaptic Functions in Bio-enabled Synaptic Transistors

The signal transmission of the nervous system is regulated by neurotransmitters. Depending on the type of neurotransmitter released by presynaptic neurons, neuron cells can either be excited or inhibited. Maintaining a balance between excitatory and inhibitory synaptic responses is crucial for the nervous system's versatility, elasticity, and ability to perform parallel computing. On the way to mimic the brain's versatility and plasticity traits, creating a preprogrammed balance between excitatory and inhibitory responses is required. Despite substantial efforts to investigate the balancing of the nervous system, a complex circuit configuration has been suggested to simulate the interaction between excitatory and inhibitory synapses. As a meaningful approach, an optoelectronic synapse for balancing the excitatory and inhibitory responses assisted by light mediation is proposed here by deploying humidity-sensitive chiral nematic phases of known polysaccharide cellulose nanocrystals. The environment-induced pitch tuning changes the polarization of the helicoidal organization, affording different hysteresis effects with the subsequent excitatory and inhibitory nonvolatile behavior in the bio-electrolyte-gated transistors. By applying voltage pulses combined with stimulation of chiral light, the artificial optoelectronic synapse tunes not only synaptic functions but also learning pathways and color recognition. These multifunctional bio-based synaptic field-effect transistors exhibit potential for enhanced parallel neuromorphic computing and robot vision technology.

MOF-Assimilated High-Sensitive Organic Field-Effect Transistors for Rapid Detection of a Chemical Warfare Agent

The selective and rapid detection of trace amounts of highly toxic chemical warfare agents has become imperative for efficiently using military and civilian defense. Metal-organic frameworks (MOFs) are a class of inorganic-organic hybrid porous material that could be potential next-generation toxic gas sensors. However, the growth of a MOF thin film for efficiently utilizing the material properties for fabricating electronic devices has been challenging. Herein, we report a new approach to efficiently integrate MOF as a receptor through diffusion-induced ingress into the grain boundaries of the pentacene semiconducting film in the place of the most adaptive chemical functionalization method for sensor fabrication. We used bilayer conducting channel-based organic field-effect transistors (OFETs) as a sensing platform comprising CPO-27-Ni as the sensing layer, coated on the pentacene layer, showed a strong response toward sensing of diethyl sulfide, which is one of the stimulants of bis (2-chloroethyl) sulfide, a highly toxic sulfur mustard (HD). Using OFET as a sensing platform, these sensors can be a potential candidate for trace amounts of sulfur mustard detection below 10 ppm in real time as wearable devices for onsite uses.

Multivalued Logic for Optical Computing with Photonically Enabled Chiral Bio-organic Structures

Photonic bio-organic multiphase structures are suggested here for integrated thin-film electronic nets with multilevel logic elements for multilevel computing via a reconfigurable photonic bandgap of chiral biomaterials. Herein, inspired by an artificial intelligence system with efficient information integration and computing capability, the photonically active dielectric layer of chiral nematic cellulose nanocrystals is combined with printed-in p- and n-type organic semiconductors as a bifunctional logical element. These adaptive logic elements are capable of triggering tailored quantized electrical output signals under light with different photon energy and at the different photonic bandgaps of the active dielectric layer. The bifunctional structures enable complex memory behavior upon repetitive changes of photonic bandgap (controlled by expansion/contraction of chiral nematic pitch) and photon energy (controlled by light absorption wavelength of complementary organic semiconductor layers), exhibiting effectively a reconfigurable ternary logic response. This proof-of-concept bio-assisted multivalued logic structure facilitates an optical computing system for low-power optical information processing integrated with human-machine interfaces.

High-Mobility Fungus-Triggered Biodegradable Ultraflexible Organic Transistors

Biodegradable organic field-effect transistors (OFETs) have drawn tremendous attention for potential applications such as green electronic skins, degradable flexible displays, and novel implantable devices. However, it remains a huge challenge to simultaneously achieve high mobility, stable operation and controllable biodegradation of OFETs, because most of the widely used biodegradable insulating materials contain large amounts of hydrophilic groups. Herein, it is firstly proposed fungal-degradation ultraflexible OFETs based on the crosslinked dextran (C-dextran) as dielectric layer. The crosslinking strategy effectively eliminates polar hydrophilic groups and improves water and solvent resistance of dextran dielectric layer. The device with spin-coated 2,7-dioctyl[1]benzothieno[3,2-b][1]benzothiophene (C8-BTBT) semiconductor and C-dextran dielectric exhibits the highest mobility up to 7.72 cm2 V-1 s-1 , which is higher than all the reported degradable OFETs. Additionally, the device still maintains high performance regardless of in an environment humidity up to 80% or under the extreme bending radius of 0.0125 mm. After completion of their mission, the device can be controllably biodegraded by fungi without any adverse environmental effects, promoting the natural ecological cycles with the concepts of "From nature, for nature". This work opens up a new avenue for realizing high-performance biodegradable OFETs, and advances the process of the "green" electrical devices in practical applications.

Organic Field-Effect Transistor Fabricated on Internal Shrinking Substrate

In the development of flexible organic field-effect transistors (OFET), downsizing and reduction of the operating voltage are essential for achieving a high current density with a low operating power. Although the bias voltage of the OFETs can be reduced by a high-k dielectric, achieving a threshold voltage close to zero remains a challenge. Moreover, the scaling down of OFETs demands the use of photolithography, and may lead to compatibility issues in organic semiconductors. Herein, a new strategy based on the ductile properties of organic semiconductors is developed to control the threshold voltage at close to zero while concurrently downsizing the OFETs. The OFETs are fabricated on prestressed polystyrene shrink film substrates at room temperature, then thermal energy (160 °C) is used to release the strain. The OFETs conformally attached to the wrinkled structure are shown to locally amplify the electric field. After shrinking, the horizontal device area is reduced by 75%, and the threshold voltage is decreased from -1.44 to -0.18 V, with a subthreshold swing of 74 mV dec^-1 and intrinsic gain of 4.151 × 10⁴ . These results reveal that the shrink film can be generally used as a substrate for downsizing OFETs and improving their performance.

Highly Stable Nonhydroxyl Antisolvent Polymer Dielectric: A New Strategy towards High-Performance Low-Temperature Solution-Processed Ultraflexible Organic Transistors for Skin-Inspired Electronics

Scarcity of the antisolvent polymer dielectrics and their poor stability have significantly prevented solution-processed ultraflexible organic transistors from low-temperature, large-scale production for applications in low-cost skin-inspired electronics. Here, we present a novel low-temperature solution-processed PEI-EP polymer dielectric with dramatically enhanced thermal stability, humidity stability, and frequency stability compared with the conventional PVA/c-PVA and c-PVP dielectrics, by incorporating polyethyleneimine PEI as crosslinking sites in nonhydroxyl epoxy EP. The PEI-EP dielectric requires a very low process temperature as low as 70°C and simultaneously possesses the high initial decomposition temperature (340°C) and glass transition temperature (230°C), humidity-resistant dielectric properties, and frequency-independent capacitance. Integrated into the solution-processed C8-BTBT thin-film transistors, the PEI-EP dielectric enables the device stable operation in air within 2 months and in high-humidity environment from 20 to 100% without significant performance degradation. The PEI-EP dielectric transistor array also presents weak hysteresis transfer characteristics, excellent electrical performance with 100% operation rate, high mobility up to 7.98 cm² V^-1 s^-1 (1 Hz) and average mobility as high as 5.3 cm² V^-1 s^-1 (1 Hz), excellent flexibility with the normal operation at the bending radius down to 0.003 mm, and foldable and crumpling-resistant capability. These results reveal the great potential of PEI-EP polymer as dielectric of low-temperature solution-processed ultraflexible organic transistors and open a new strategy for the development and applications of next-generation low-cost skin electronics.

Sweet Electronics: Honey-Gated Complementary Organic Transistors and Circuits Operating in Air

Sustainable harnessing of natural resources is key moving toward a new-generation electronics, which features a unique combination of electronic functionality, low cost, and absence of environmental and health hazards. Within this framework, edible electronics, of which transistors and circuits are a fundamental component, is an emerging field, exploiting edible materials that can be safely ingested, and subsequently digested after performing their function. Dielectrics are a critical functional element of transistors, often constituting their major volume. Yet, to date, there are only scarce examples of electrolytic food-based materials able to provide low-voltage operation of transistors at ambient conditions. In this context, a cost-effective and edible substance, honey, is proposed to be used as an electrolytic gate viscous dielectric in electrolyte-gated organic field-effect transistors (OFETs). Both n- and p-type honey-gated OFETs (HGOFETs) are demonstrated, with distinctive features such as low voltage (<1 V) operation, long-term shelf life and operation stability in air, and compatibility with large-area fabrication processes, such as inkjet printing on edible tattoo-paper. Such complementary devices enable robust honey-based integrated logic circuits, here exemplified by inverting logic gates and ring oscillators. A marked device responsivity to humidity provides promising opportunities for sensing applications, specifically, for moisture control of dried or dehydrated food.

Interface engineering of moisture-induced ionic albumen dielectric layers through self-crosslinking of cysteine amino acids for low voltage, high-performance organic field-effect transistors

The interface roughness between the semiconducting and dielectric layers of organic field-effect transistors (OFETs) plays a crucial role in the charge transport mechanism through the device. Here we report the interface engineering of a moisture induced ionic albumen material through systematic control of the temperature-dependent self-crosslinking of cysteine amino acids in the dielectric layer. The evolution of the surface morphologies of albumen and pentacene semiconducting films has been studied to achieve a smooth interface for enhanced charge transport. A structural transition of pentacene films from crystalline dendrite to amorphous was induced by the higher surface roughness of the albumen film. The devices showed a high transconductance of 11.68 μS at a lower threshold voltage of -0.9 V.

Improving Bias-Stress Stability of p-Type Organic Field-Effect Transistors by Constructing an Electron Injection Barrier at the Drain Electrode/Semiconductor Interfaces

Bias-stress instability has been a challenging problem and a roadblock for developing stable p-type organic field-effect transistors (OFETs). This device instability is hypothesized because of electron-correlated charge carrier trapping, neutralization, and recombination at semiconductor/dielectric interfaces and in semiconductor channels. Here, in this paper, a strategy is demonstrated to improve the bias-stress stability by constructing a multilayered drain electrode with energy-level modification layers (ELMLs). Several organic small molecules with high lowest unoccupied molecular orbital (LUMO) energy levels are experimented as ELMLs. The energy-level offset between the Fermi level of the drain electrode and the LUMOs of the ELMLs is shown to construct the interfacial barrier, which suppresses electron injection from the drain electrode into the channel, leading to significantly improved bias-stress stability of OFETs. The mechanism of the ELMLs on the bias-stress stability is studied by quantitative modeling analysis of charge carrier dynamics. Of all injection models evaluated, it is found that Fowler-Nordheim tunneling describes best the observed experimental data. Both theory and experimental data show that, by using the ELMLs with higher LUMO levels, the electron injection can be suppressed effectively, and the bias-stress stability of p-type OFETs can thereby be improved significantly.