Controlled Assembly of Gold Nanostructures on a Solid Substrate via Imidazole Directed Hydrogen Bonding for High Performance Surface Enhance Raman Scattering Sensing of Hypochlorous Acid

Beetle-inspired AuNPs semi-embedded colloidal crystal chips for the highly sensitive and colored detection of chloramphenicol in foods

Inspired by the desert beetle, a novel biomimetic chip was developed to detect chloramphenicol (CP). The chip was characterized by a periodic array in which hydrophobic Au nanoparticles (AuNPs) were semi-embedded on hydrophilic polymethyl methacrylate (PMMA) spheres. Among them, the AuNPs exhibited both a localized surface plasmon resonance effect to amplify the reflected signal and a synergistic effect with PMMA spheres to create a significant hydrophilic-hydrophobic interface, which facilitated the enrichment of target CP molecules and improved sensitivity. After optimization, the chip showed direct, ultrasensitive (as low as 0.2 ng/mL), fast (5 min), and selective detection of CP with a wide concentration range extending from 0.2 ng/mL to 1000 ng/mL. During detection, color changes of the chip were observed by naked eyes without any color display equipment. The recovery of CP was between 94.65 % and 108.70 % in chicken and milk samples.

Preparation of SERS base membrane with cellulose compound dopamine and determination of hypochlorite

Flexible silver substrates were made by in situ reduction of silver nanoparticles in bacterial cellulose membranes using the unique advantage of dopamine. Subsequently, we modified the substrate with 4-mercaptophenol (4-MP), a molecule capable of specifically recognizing ClO-, and its corresponding SERS signal changes with the concentration of hypochlorite, thus allowing the quantitative detection of ClO- content. The method showed a negative linear correlation (R2 = 0.9567) with the SERS intensity at 1077 cm-1 over the concentration range 0.5-100 µM, and the detection limit was 0.15 µM. The RSD of the SERS intensity at 1077 cm-1 under five batches was 4.2%, which proved the good reproducibility of P-BCM-Ag NP-MP. Finally, the P-BCM-Ag NPs were used for the detection of hypochlorite in cell contents, artificial urine, and clinical serum samples, utilizing spike experiments in all three environments. The recoveries were in the range 90-110% indicating the accuracy of the method for the detection of hypochlorite and validating the promising application of this assay for practical detection in intricate biological samples.

A rapid and sensitive colorimetric sensor for hypochlorite detection based on polyvinylpyrrolidone-stabilized gold nanoparticles

It is important to develop simple and effective approaches for hypochlorite (OCl-) detection at trace levels due to its widespread use as a disinfectant especially for water treatments including drinking water. In this work, a simple, facile colorimetric sensor for the sensitive determination of hypochlorite was developed based on the oxidation of cysteine by OCl-, a process that prohibits the cysteine-triggered aggregation of Au nanoparticles (AuNPs) stabilized by polyvinylpyrrolidone. With this strategy, the concentration of OCl- could be detected with the naked eye and/or ultraviolet-visible spectroscopy, and the limit of detection for OCl- was 1.0 μM and 250 nM, respectively. Additionally, the proposed method shows excellent anti-interference capability against many other interfering ions and real water sample applicability.

DNA self-assembled Au nanoparticle clusters on silver nanorod arrays for high-sensitive and multiplex detection of cancer-related biomarkers

To sensitively detect multiple and cross-species disease-related targets from a single biological sample in a quick and reliable manner is of high importance in accurately diagnosing and monitoring diseases. Herein, a surface-enhanced Raman scattering (SERS) sensor based on a functionalized multiple-armed tetrahedral DNA nanostructure (FMTDN) immobilized silver nanorod (AgNR) array substrate and Au nanoparticle (AuNP) SERS tags is constructed to achieve both multiplex detection and enhanced sensitivity using a sandwich strategy. The sensor can achieve single, dual, and triple biomarker detections of three lung cancer-related nucleic acid and protein biomarkers, i.e., miRNA-21, miRNA-486 and carcinoembryonic antigen (CEA) in human serum. The enhanced SERS signals in multiplex detections are due to the DNA self-assembled AuNP clusters on the silver nanorod array during the assay, and the experimentally obtained relative enhancement factor ratios, 150 for AuNP dimers and 840 for AuNP trimers, qualitatively agree with the numerically calculated local electric field enhancements. The proposed FMTDN-functionalized AgNR SERS sensor is capable of multiplex and cross-species detection of nucleic acid and protein biomarkers with improved sensitivity, which has great potential for the screening and clinical diagnosis of cancer in the early stage.

Chloride ion inhibition of electrochemical oscillations on the anode of an electrolytic manganese metal cell

In industrial electrolytic manganese metal process, the energy consumption closely related to the electrolysis of cathode and anode. The effect of Cl^- concentration on electrochemical oscillation at the anode of the electrolytic manganese metal cell was investigated. The results showed that the electrochemical oscillation at the anode was inhibited by Cl^-, and the amplitude and frequency of the electrochemical oscillation decreased as the increase of Cl^- concentration. When the concentration of Cl^- was 2.68 g/L, the cathode and anode electrodes could be effectively activated, and the manganese current efficiency reached its minimum, correspondingly, the power consumption reached its maximum. In addition, the presence of the chloride reduced the production of MnO₂ at the anode surface. ClO₄^- and free ions formed insoluble amorphous structures on the surface of the anode with the increase in reaction time and chloride ion concentration, and the insoluble amorphous structures prevented further generation of MnO₂. Thus, electrolytic manganese metal energy consumption decreased.

Ultrasensitive detection of trace Hg2+ by SERS aptasensor based on dual recycling amplification in water environment

Due to the nonbiodegradability and accumulation of mercury ion, even in extremely small amount, it will cause varying degrees of harm to environment and human health. Although researchers have developed many strategies to detect and monitor trace Hg²⁺, only a few provide sensitivities of less than 1.0 pM. Surface Enhanced Raman Spectroscopy (SERS) is a common method to detect mercury ion due to its high sensitivity, rapid detection and easy operation. In this work, we report a new SERS aptasensor based on dual recycling amplification for the detection of trace mercury ion, which combines SERS with nucleic acid signal amplification through functional aptamer and elaborately designed hairpin DNA. Under the optimal experimental conditions, this SERS aptasensor exhibits excellent selectivity and high sensitivity. A linear range (0.2-125 fM) and a low detection limit (0.11 fM) are obtained. By using specific aptamers, the strategy will provide a new idea for the trace detection of toxic contaminants in water environment.

Assembly of Water-soluble AIE-active Fluorescent Organic Nanoparticles for Ratiometric Detection of Hypochlorite in Living Cells

Hypochlorous acid (HOCl) plays a crucial role in many physiological processes and is widely used as bleach, deodorant and fungicide. In this work, we designed an amphiphilic hydrazone fluorescent molecule THG-1 containing hydrophilic sugar units and hydrophobic tetraphenylethylene unit for ratiometric detection of HOCl with high sensitivity and excellent selectivity based on HOCl-triggered hydrolyzation reaction and aggregation-induced emission (AIE) effect. The detection mechanism was verified by liquid chromatograph mass spectrometry experiments and scanning electron microscope (SEM) tests. Contrast experiments revealed that the numbers of lactose unit and hydrazone linker were essential for assembly of THG-1 and detection of HOCl. In addition, THG-1 was successfully used for imaging of exogenous and endogenous HOCl in living cells.

K. M, Biswas S. Fluorogenic naked eye “turn-on” sensing of hypochlorous acid by a Zr-based metal organic framework

A (dimethylthiocarbamoyl)oxy functionalized Zr-based UiO-66 MOF was utilized for the first time as a fluorogenic turn-on detector for the sensitive and specific sensing of HOCl in an aqueous medium.

Dual-Response Ratiometric Electrochemical Microsensor for Effective Simultaneous Monitoring of Hypochlorous Acid and Ascorbic Acid in Human Body Fluids

Redox homeostasis between hypochlorous acid (HClO/ClO^-) and ascorbic acid (AA) significantly impacts many physiological and pathological processes. Herein, we report a new electrochemical sensor for the simultaneous determination of HClO and AA in body fluids. We first coated a carbon fiber microelectrode (CFME) with a three-dimensional nanocomposite consisting of graphene oxide (GO) and carbon nanotubes (CNTs) to fabricate the CFME/GO-CNT electrode. After the electrochemical reduction of GO (ERGO), we integrated a latent 1-(3,7-bis(dimethylamino)-10H-phenothiazin-10-yl)-2-methylpropan-1-one (MBS) electrochemical molecular recognition probe to monitor HClO and employed anthraquinone (AQ) as an internal reference. The compact CFME/ERGO-CNT/AQ + MBS sensor enabled the accurate and simultaneous measurement of HClO and AA with excellent selectivity and sensitivity. Measurements were highly reproducible, and the sensor was stable and exceptionally biocompatible. We successfully detected changes in the redox cycles of HClO and AA in human body fluids. This sensor is a significant advance for the investigation of reactions involved in cellular redox regulation. More importantly, we have devised a strategy for the design and construction of ratiometric electrochemical biosensors for the simultaneous determination of various bioactive species.

Investigating the Performance of Carboxylate-Alumoxane Nanoparticles as a Novel Chemically Functionalized Inhibitor on Asphaltene Precipitation

In recent years, researchers have attempted to find some practical approaches for asphaltene adsorption and the prevention or postponement of asphaltene precipitation. Among different techniques, nanotechnology has attracted the researchers' attention to overcome the formation damage resulting from the deposition of asphaltenes. In this study, the application of two types of carboxylate-alumoxane nanoparticles (functionalized boehmite by methoxyacetic acid (BMA) and functionalized pseudo-boehmite by methoxyacetic acid (PBMA)) for asphaltene adsorption and precipitation was investigated. First, the synthesis of two functionalized nanoparticles was performed via the sol-gel method. For the assessment of the adsorption efficiency and adsorption capacity of these nanoparticles toward asphaltene adsorption, the batch adsorption experiments applying ultraviolet-visible (UV-Vis) spectroscopy were performed. The Langmuir and Freundlich isotherms were studied to describe the interaction between asphaltene molecules and carboxylate-alumoxane nanoparticles. For determining the "onset" point of asphaltene precipitation, the indirect method, which was based on the difference in the optical property of various solutions containing different concentrations of asphaltene, was utilized by applying UV-Vis spectroscopy. The isotherm models indicate that the adsorption of asphaltene on the surface of nanoparticles is better fitted to the Freundlich isotherm model compared with the Langmuir model. In the presence of PBMA (0.1 wt %), the onset point was delayed around 26, 20, and 17% in the asphaltene concentrations of 1000, 3000, and 5000 ppm, respectively, in comparison with their reference synthetic oils. On the other hand, these postponements for BMA nanoparticles (0.1 wt %) were 17%, 9%, and insignificant for the asphaltene concentrations of 1000, 3000, and 5000 ppm, respectively. The results reveal that two functionalized nanoparticles tend to adsorb asphaltene molecules and have a positive impact on the postponement of asphaltene precipitation due to molecular interactions between the surface of carboxylate-alumoxane nanoparticles and asphaltene molecules. However, PBMA nanoparticles exhibited better performance on the asphaltene adsorption and postponement of asphaltene precipitation, which is related to its smaller size, as well as higher surface area, compared with BMA nanoparticles.