Transcortin. A corticosteroid-binding protein of plasma. IX. Isolation and characterization

Protein binding of cortisol by means of competitive adsorption: application to cortisol binding by serum of sixteen eutherian mammals

1. Binding of 3H-cortisol by serum proteins by means of competitive adsorption was relatively high by serum of the gerbil, human, rabbit, sheep, tree shrew, hamster, rhesus monkey and horse. 2. A somewhat lower binding was observed by serum proteins of the baboon, cattle, dog, rat and cat. 3. Serum taken from either the mouse, guinea pig or pig gave very flat binding curves, specific binding not exceeding 5% of added 3H-cortisol. 4. It is concluded that the measurement of protein-binding of 3H-cortisol by means of competitive adsorption is a reliable method for serum of most eutherian species but is unsuited if serum of the mouse, guinea pig or pig is used.

Purification and partial characterization of a corticosteroid-binding globulin from hamster serum

Our objective was to characterize and purify the corticosteroid-binding proteins in hamster pregnancy serum. When [3H]cortisol-labeled pregnancy and proestrous serum were subjected to native polyacrylamide gel electrophoresis, a single peak of specific steroid-binding activity was detected in each, with identical electrophoretic mobility. The steroid-binding affinity (Ka = 1.07.10(8) M-1 for cortisol) is typical of corticosteroid-binding globulin from other species, but the steroid-binding specificity (cortisol greater than testosterone greater than progesterone) is not. An ultraviolet photoaffinity-labeling protocol was developed using 17 beta-hydroxy-4,6-[1,2-3H]androstadiene-3-one ([3H]androstadienolone), permitting analysis of ultraviolet photoaffinity-labeled proestrous and pregnancy serum by two-dimensional polyacrylamide gel electrophoresis and fluorography. Both sera contained the same labeled protein species. Corticosteroid-binding globulin was purified from pregnancy serum by DEAE-cellulose chromatography followed by steroid affinity chromatography on androstadienolone-17 beta-hemisuccinate-ethylenediamine-AffiGel 10. The purified protein (Mr = 62,250; pI = 3.95; n = 1; Stokes radius = 3.5; S = 4-5) was determined to be a glycoprotein. When analyzed by gel filtration and two-dimensional polyacrylamide gel electrophoresis, purified corticosteroid-binding globulin behaved the same as in unfractionated serum, and when ultraviolet photoaffinity-labeled with [3H]androstadienolone, purified corticosteroid-binding globulin produced the same fluorogram spot pattern seen in unfractionated serum. A specific corticosteroid-binding globulin antiserum was raised in rabbits, and this antiserum reacted with a single spot in Western blots of unfractionated serum. Thus, hamster pregnancy serum was determined to have one corticosteroid-binding protein. This protein is identical to the corticosteroid-binding globulin found in proestrous serum, with a higher titer in pregnancy serum. No other steroid-binding component is observed in hamster serum.

Electron spin resonance study of human transcortin: Thiol groups and binding site topography

A series of cortisol analogs bearing a nitroxide free radical on C-17 side chains with a variation of distance between the steroid D-ring and the spin label from 7.4 to 17.6 A has been synthesized. These analogs were found to retain a good affinity for the specific corticosteroid binding site of purified human transcortin. The spin-labeled cortisol analogs were used to probe the human transcortin binding site structure by electron spin resonance (ESR) spectroscopy. A total depth of approx. 25 A was estimated for the binding site crevice. Use of sulfhydryl reagents (N-ethylmaleimide, p-chloromercuribenzoate) showed that a maximum of two sulfhydryl groups were titratable after reduction and denaturation of the protein. One of these thiol groups appeared to be involved in the cortisol binding site and could not be detected in the presence of bound steroid. ESR study of its environment, using spin-labeled N-ethylmaleimide reagents of various side-chain lengths, led to the conclusion that this thiol was at a depth of approx. 15 A or more in the binding site cavity. The second sulfhydryl group may be present in an oxidized form in the purified native transcortin, since it became titratable only after reductive treatment of the protein. ESR study showed that this thiol may be located in a crevice at approx. 15 A from the protein surface. These findings are compatible with a structural organization of the transcortin cortisol binding site, taking into account tentative models previously proposed by others.

Preliminary characterization of a new androgen-binding protein in human seminal plasma

In order to obtain comparative analysis between the steroid binding proteins from blood serum and seminal plasma, fresh samples were incubated and assayed in parallel with the following tritiated steroids: dihydrotestosterone, testosterone, cortisol, progesterone and estradiol. Thereafter, and using techniques such as (1) polyacrilamide disk gel electrophoresis with elution of proteins from the gel slices, (2) ammonium sulphate precipitation, (3) enzymatic hydrolysis, and (4) gel filtration on Sephadex G-100, there was a resemblance in the electrophoretic patterns confirming the presence in both fluids of proteins like TeBG, CBG, and Albumin, previously described in blood serum. In seminal fluid, but not in blood serum, another small protein with androgen binding capacity was found and its preliminary characterization demonstrated: disappearance with enzymatic treatment, low molecular weight, negative charge, and precipitation range with ammonium sulphate from 30 to 35%. Its elution profile on Sephadex G-100 was contaminated with albumin.

[Characterization and physico-chemical properties of human transcortin]

The molecular weight of human transcortin, calculated from the sedimentation coefficient, was found to be 49,500, thus slightly lower than previously reported values. After purification, human transcortin trended to polymerize rapidly, with participation of both non covalent bonds and one disulfide bridge per dimer. The physicochemical parameters, the amino-acid and carbohydrate composition were determined; its stability was studied under different conditions. Preliminary structural studies showed that the N-terminal sequence of the polypeptide chain was: Met-Asp-Pro-Asn-Ala-Ala-Tyr-Val and that the C-terminal amino acid was leucine.