Synthesis, Structures, and Magnetic Properties of End-to-End Azide-Bridged Manganese(III) Chains: Elucidation of Direct Magnetostructural Correlation

Slow magnetic relaxation in a μ1,1'-azido cobalt(ii) methylquinoline chain complex

A [Co(N3)2(mqu)] complex with a 1D chain architecture (mqu - 4-methylquinoline) displays the paramagnetic behaviour with a slight exchange interaction of antiferromagnetic nature among Co(ii) centres. It shows slow magnetic relaxation with three distinct modes. The relaxation time strongly depends upon the applied external field. The slowest relaxation time refers to the low-frequency mode τLF = 1.6(2) s at BDC = 0.8 T and T = 1.9 K.

Pressure dependence of spin canting in ammonium metal formate antiferromagnets

High-pressure single-crystal X-ray diffraction at ambient temperature and high-pressure SQUID measurements down to 2 K were performed up to ∼2.5 GPa on ammonium metal formates, [NH₄][M(HCOO)₃] where M = Mn²⁺, Fe²⁺, and Ni²⁺, in order to correlate structural variations to magnetic behaviour. Similar structural distortions and phase transitions were observed for all compounds, although the transition pressures varied with the size of the metal cation. The antiferromagnetic ordering in [NH₄][M(HCOO)₃] compounds was maintained as a function of pressure, and the magnetic ordering transition temperature changed within a few kelvins depending on the structural distortion and the metal cation involved. These compounds, in particular [NH₄][Fe(HCOO)₃], showed greatest sensitivity to the degree of spin canting upon compression, clearly visible from the twenty-fold increase in the low-temperature magnetisation for [NH₄][Fe(HCOO)₃] at 1.4 GPa, and the change from purely antiferromagnetic to weakly ferromagnetic ordering in [NH₄][Mn(HCOO)₃] at 1 GPa. The variation in the exchange couplings and spin canting was checked with density-functional calculations that reproduce well the increase in canted moment within [NH₄][Fe(HCOO)₃] upon compression, and suggest that the Dzyaloshinskii-Moriya (DM) interaction is evolving as a function of pressure. The pressure dependence of spin canting is found to be highly dependent on the metal cation, as magnetisation magnitudes did not change significantly for when M = Ni²⁺ or Mn²⁺. These results demonstrate that the overall magnetic behaviour of each phase upon compression was not only dependent on the structural distortions but also on the electronic configuration of the metal cation.

A one dimensional coordination polymer composed of antiferromagnetically coupled disk-like [Mn7] units

A single-chain magnet (SCM) was constructed from disk-like Mn₇ clusters linked by azide units.

Towards Catalytic Ammonia Oxidation to Dinitrogen: A Synthetic Cycle by Using a Simple Manganese Complex

Oxidation of the nucleophilic nitride, (salen)Mn≡N (1) with stoichiometric [Ar₃ N][X] initiated a nitride coupling reaction to N₂ , a major step toward catalytic ammonia oxidation (salen=N,N'-bis(salicylidene)-ethylenediamine dianion; Ar=p-bromophenyl; X=[SbCl₆ ]^- or [B(C₆ F₅ )₄ ]^- ). N₂ production was confirmed by mass spectral analysis of the isotopomer, 1-¹⁵ N, and the gas quantified. The metal products of oxidation were the reduced Mn^III dimers, [(salen)MnCl]₂ (2) or [(salen)Mn(OEt₂ )]₂ [B(C₆ F₅ )₄ ]₂ (3) for X=[SbCl₆ ]^- or [B(C₆ F₅ )₄ ]^- , respectively. The mechanism of nitride coupling was probed to distinguish a nitridyl from a nucleophilic/electrophilic coupling sequence. During these studies, a rare mixed-valent Mn^V /Mn^III bridging nitride, [(salen)Mn^V (μ-N)Mn^III (salen)][B(C₆ F₅ )₄ ] (4), was isolated, and its oxidation-state assignment was confirmed by X-ray diffraction (XRD) studies, perpendicular and parallel-mode EPR and UV/Vis/NIR spectroscopies, as well as superconducting quantum interference device (SQUID) magnetometry. We found that 4 could subsequently be oxidized to 3. Furthermore, in view of generating a catalytic system, 2 can be re-oxidized to 1 in the presence of NH₃ and NaOCl closing a pseudo-catalytic "synthetic" cycle. Together, the reduction of 1→2 followed by oxidation of 2→1 yield a genuine synthetic cycle for NH₃ oxidation, paving the way to the development of a fully catalytic system by using abundant metal catalysis.

Syntheses, crystal structures, magnetochemistry and catechol oxidase activity of a tetracopper(ii) compound and a new type of dicopper(ii)-based 1D coordination polymer

One phenoxo–hydroxo bridged tetranuclear cluster and one phenoxo-µ_1,1-azido-µ_1,3-azido bridged one-dimensional coordination polymer of copper(ii) derived from a Schiff base ligand are described.

Both end-on and end-to-end azide bridged tetranuclear ferromagnetic nickel(ii) Schiff base complexes

Variable temperature magnetic measurement of a tetranuclear nickel(ii) complex, consisting of two pseudo-dinuclear entities, indicates the presence of intra- and inter-dinuclear ferromagnetic interactions, corroborated by DFT calculations.

Field-induced ferromagnetism due to magneto-striction in 1-D helical chains

Under high magnetic field and at lower temperature orthogonality of d-orbitals of Cu(ii) centers increases significantly due to contraction of lattice parameters giving rise to long range ferromagnetic ordering in the helical chain.

Four tetrazolate-based 3D frameworks with diverse subunits directed by inorganic anions and azido coligand: hydro/solvothermal syntheses, crystal structures, and magnetic properties

Four magnetic frameworks with hourglass-shaped {Cu₅(μ₃-OH)₂}⁸⁺ cluster, linear {Cu₃(μ-Cl)₂}⁴⁺ core, linear {Cu(μ_1,1-N₃)}⁺ chain and trigonal-prismatic {Cu₈(μ₃-tz)₆}¹⁰⁺ motifs were reported.

Bis(4-pyridyl)mercury – a new linear tecton in crystal engineering: coordination polymers and co-crystallization processes

Three new coordination polymers have been obtained using bis(4-pyridyl)mercury (py₂Hg) as a spacer: [Cu(Hmea)₂(py₂Hg)](ClO₄)₂·2(py₂Hg) (1), [Cu₂(pa)₂(py₂Hg)(ClO₄)₂]·0.5(py₂Hg)·H₂O (2), and [Cu₂(pa)₂(py₂Hg)₂](BF₄)₂ (3) (Hmea = monoethanolamine; Hpa = propanolamine).