Acetone Cyanohydrin as a Source of HCN in the Cu-Catalyzed Hydrocyanation of α-Aryl Diazoacetates

pH-controlled regioselective nucleophilic ring-opening of epoxide: an improved process for the preparation of (R)-(-)- or (S)-(+)-3-hydroxytetrahydrofuran

An environmentally benign, cost-effective and scalable process for the preparation of both the enantiomers of 3-hydroxytetrahydrofuran has been developed. pH-Controlled ring opening of enantiomerically pure epichlorohydrins with cyanohydrin is the key step of the process. The entire protocol does not require any column purification.

Application of combined cyanide sources in cyanation reactions

The cyanation reaction is a key transformation due to the wide-ranging applications of nitrile compounds in organic chemistry. Traditionally, the cyanation reaction employs metal cyanides as cyanide sources, which are toxic and environmentally unfriendly. Very recently, many excellent examples of using combined cyanide sources as cyanating agents have been reported. This review summarizes the applications of combined cyano-group sources in a variety of cyanation reactions.

A fatal poisoning case of acetone cyanohydrin and citalopram

Acetone cyanohydrin (ACH) is a readily available source of cyanide and is widely used in basic and applied sciences. In toxicology, ACH is classified as extremely hazardous as it readily decomposes on contact with water, with the potential rapid release of highly toxic hydrogen cyanide (HCN). We report the case of a young woman found dead from the intentional ingestion of ACH and citalopram, an antidepressant of the selective serotonin reuptake inhibitor class. The autopsy findings included bright reddish-purple hypostasis and mild pulmonary edema. As ACH can decompose to acetone and HCN, we quantified the concentration of each compound and thiocyanate separately in various body fluids and organs and determined their whole-body distributions by using gas chromatography-mass spectrometry (GC-MS). We observed high concentrations of both acetone and cyanide in the blood (0.63 mg/mL and 17.99 mM, respectively) and gastric contents (9.76 mg/mL and 472.44 mM). The whole-body distributions of acetone and cyanide were similar (i.e., the concentration of each compound was the highest in the lung, followed by the heart, and then the liver). Our results suggest that not only the route of administration but also the dose taken could greatly affect the body distributions of cyanide in humans. In addition, as toxicological screening detected citalopram, which was not prescribed to the deceased, we performed a chiral analysis by using liquid chromatography-tandem mass spectrometry (LC-MS/MS). We determined that only (S)-citalopram was ingested antemortem; its concentration was 0.36 μg/mL, which is in the toxic range.

Mechanistic Study of Unprecedented Highly Regioselective Hydrocyanation of Terminal Alkynes: Insight into the Origins of the Regioselectivity and Ligand Effects

Density functional theory (DFT) calculations were performed to gain insight into the mechanism of the nickel-catalyzed hydrocyanation of terminal alkynes with Zn(CN)₂ and water to exclusively generate the branched nitrile with excellent Markovnikov selectivity. After precatalyst activation to give the LNi(0) active species, the transformation proceeds via the following steps: (1) oxidative addition of H₂ O to the LNi(0) provides the intermediate LNi(II)H(OH); (2) ligand exchange of LNi(II)H(OH) with Zn(CN)₂ gives the intermediate LNi(II)H(CN); (3) alkyne insertion to the LNi(II)H(CN) forms the alkenyl nickel complex, followed by the reductive elimination step reaching the final product. This mechanism is kinetically and thermodynamically more favorable than that of the experimental proposed ones. On the basis of the experimental observations, more water molecules cannot further improve the reaction as it has also been rationalized. Furthermore, the origin of the high regioselectivity of the product, the variable effectiveness of the metal mediator as function of ligands, as well as the high yield of the alkyl-substituted alkynes substrates, is analyzed in detail. © 2019 Wiley Periodicals, Inc.

Recent advances in C–CN and C–H bond activation of green nitrile (MeCN) for organo-complexation, cyanation and cyanomethylation

The use of green and inexpensive organic nitrile (MeCN) as a cyano and cyano-methyl source for organo-complexation, cyanation, and cyanomethylation is reviewed.

An asymmetric hydrocyanation/Michael reaction of α-diazoacetates via Cu(i)/chiral guanidine catalysis

An asymmetric one-pot hydrocyanation/Michael reaction of α-aryl diazoacetates with trimethylsilyl cyanide, tert-butanol, and N-phenylmaleimides has been realized using a chiral guanidinium salt/CuBr catalyst.

Copper catalyzed cyanation through CC bond cleavage of gem-aryl dibromide followed by second cyanation of iodoarene by a released CN unit

A new approach for the synthesis of aryl cyanides through CC cleavage of styrenyl gem-dibromide has been achieved.

Atom-Economic Route to Cyanoarenes and 2,2'-Dicyanobiarenes via Iron-Catalyzed Chemoselective [2 + 2 + 2] Cycloaddition Reactions of Diynes and Tetraynes with Alkynylnitriles

An efficient protocol for the synthesis of cyanoarenes has been developed via an iron-catalyzed chemoselective [2 + 2 + 2] cycloaddition reaction of diynes with alkynylnitriles under mild reaction conditions with good to excellent yields. The reaction is catalyzed by the combination of FeCl₂·4H₂O as a metal source, 2-(2,6-diisopropylphenyl)iminomethylpyridine (dipimp) as a ligand, and Zn as a reducing agent in DME solvent. The protocol was further extended to the synthesis of 2,2'-dicyanobiarene skeletons from the reaction of tetraynes with alkynylnitriles.

Cyanation of aromatic/vinylic boronic acids with α-cyanoacetates

A protocol is reported to achieve safe and convenient aromatic and vinylic cyanation of boronic acids (as well as halides) with α-cyanoacetates, avoiding the use of toxic cyanide salts.

Copper-catalyzed cyanation of aryl iodides with α-cyanoacetates via C–CN bond activation

A mild copper-catalyzed cyanation of aryl iodides using readily available and friendly α-cyanoacetates as the CN source is reported.

Copper-catalyzed aerobic oxidative inert C-C and C-N bond cleavage: a new strategy for the synthesis of tertiary amides

A copper-catalyzed aerobic oxidative amidation reaction of inert C-C bonds with tertiary amines has been developed for the synthesis of tertiary amides, which are significant units in many natural products, pharmaceuticals, and fine chemicals. This method combines C-C bond activation, C-N bond cleavage, and C-H bond oxygenation in a one-pot protocol, using molecular oxygen as the sole oxidant without any additional ligands.

Transition Metals Catalyzed Element-Cyano Bonds Activations

Cyano group as a versatile functionalized intermediate has been explored for several decades, as it readily transfers to many useful functionalization groups such as amine, amide, acid, etc., which make it possess high popularization and use value in organic synthesis. Reactions involved with element-cyano bond cleavage can provide not only a new cyano group but also a freshly functionalized skeleton in one-pot, consequently making it of high importance. The highlights reviewed herein include H-CN, Si-CN, C-CN, B-CN, Sn-CN, Ge-CN, S-CN, Halo-CN, N-CN, and O-CN bonds cleavages and will summarize progress in such an important research area. This review article will focus on transition metal catalyzed reactions involving element-cyano bond activation.

Copper-mediated transformation of organosilanes to nitriles with DMF and ammonium iodide

Cyanation of aryl-, diaryldimethyl-, and styrylsilanes was developed for the first time under copper-mediated oxidative conditions using ammonium iodide and DMF as the combined source of nitrogen and carbon atom of the introduced cyano unit, respectively. The reaction was observed to proceed in a two-step process: initial conversion of organosilanes to their iodo intermediates and then cyanation. This method has a broad substrate scope with high functional group tolerance.

Copper-mediated selective cyanation of indoles and 2-phenylpyridines with ammonium iodide and DMF

Copper-mediated regioselective cyanation of indoles and 2-phenylpyridines was developed by using ammonium iodide and DMF as the combined source of a cyano unit under "Pd-free" conditions. Mechanistic studies indicate that the reaction of indoles proceeds through a two-step sequence: electrophilic initial iodination and then cyanation. The cyanation has a broad substrate scope, high functional group tolerance, and excellent regioselectivity.

Intramolecular aromatic carbenoid insertion of biaryldiazoacetates for the regioselective synthesis of fluorenes

The rhodium- or copper-catalyzed intramolecular aromatic carbenoid insertion of biaryldiazoacetates offers a convenient route to fluorene carboxylates with high yields. Whereas, thermal conditions provided a mixture of two regioisomeric products when substituted biaryldiazoacetates were employed as substrates. The developed catalytic conditions displayed an excellent level of regioselectivity, presumably owing to steric effects. The insertion mechanism was assumed to be an electrophilic aromatic substitution, which was supported by preliminary mechanistic studies. A chloro-substituted fluorene derivative was efficiently synthesized and utilized as a base-sensitive protecting group of amines.