Spectroscopic Characterization of Highly Dispersed Vanadia Supported on SBA-15

Mesoporous sol-gel silica supported vanadium oxide as effective catalysts in oxidative dehydrogenation of propane to propylene

Vanadium oxide incorporated mesoporous silica (V-m-SiO₂) were designed and synthesized using a surfactant-modified sol-gel method. Detailed characterization shows that monomeric [VO₄] sites containing one terminal V[double bond, length as m-dash]O bond and three V-O-support bonds are dominated until atomic ratio of vanadium to silicon approaches to 5%. It is also confirmed that such V-m-SiO₂ catalyst contains high proportion of vanadium oxide species interacting strongly with silica. Compared to vanadium oxide supported mesoporous silica (V/m-SiO₂) prepared using a traditional impregnation method, present V-m-SiO₂ catalyst exhibits more superior ability to catalyze oxidative dehydrogenation of propane to propylene. By correlation with structural data, superior catalytic performance of present V-m-SiO₂ catalyst can be reasonably attributed, in part, to its favorable geometric and electronic properties rendered by the unique preparation method.

Low-temperature propane oxidative dehydrogenation over UiO-66 supported vanadia catalysts: Role of support confinement effects

Overoxidation is the principal barrier against commercializing propane oxidative dehydrogenation (PODH) catalysts for propylene production. The current approach to reducing overoxidation, i.e., coating the non-selective support surface with a monolayer of active phase, can itself increase the probability of overoxidation of the produced propylene due to polymerization of active phase species. Incorporating the "confinement agents" onto the metal oxide support might be considered as an alternative solution to prevent hydrocarbons from reaching the support and overoxidizing. Herein, the UiO-66 metal-organic framework, which contains numerous organic ligands connected to the zirconia nodes, was used as support for the vanadia active phase to highlight the role of support's confinement effects on the overall catalytic performance toward the PODH. The UiO-66 supported vanadia catalysts with various vanadium loadings were fabricated via an ultrasonic-assisted wet impregnation procedure. The catalytic function is related to the underlying chemical processes at catalyst surfaces using physicochemical characterization techniques, PODH performance measurements, and machine learning tools. The results showed that the catalyst with a relatively low vanadia density of 2.7 nm-2, equivalent to less than half of the entire support surface coverage, could achieve propylene productivity of 4.43 [Formula: see text] , propane conversion of 17.1%, and propylene selectivity of 49.7% at 350 °C.

Gold nanoparticles grown on a hydrophobic and texturally tunable PDMS-like framework

A sol-gel analogue of PDMS was used to built hydrophobic siloxane supports, while confining gold nanoparticles.

Increasing the Efficiency of Optimized V-SBA-15 Catalysts in the Selective Oxidation of Methane to Formaldehyde by Artificial Neural Network Modelling

The present study investigates the possibility of improving the selective oxidation of methane to formaldehyde over V-SBA-15 catalysts in two different ways. In a classical approach of catalyst optimization, the in situ synthesis of V-SBA-15 catalysts was optimized with regard to the applied pH value. Among the set of catalysts synthesized, a higher amount of incorporated vanadium, a higher content of polymeric VOx species as well as a less ordered structure of the support material were observed by increasing the pH values from 2.0 to 3.0. An optimum in performance during the selective oxidation of methane to formaldehyde with respect to activity and selectivity was found over V-SBA-15 prepared at a pH value of 2.5. With this knowledge, we have now evaluated the possibilities of reaction control using this catalyst. Specifically, artificial neural network modelling was applied after the collection of 232 training samples for obtaining insight into the influence of different reaction parameters (temperature; gas hourly space velocity (GHSV); and concentration of O2, N2 and H2O) onto methane conversion and selectivity towards formaldehyde. This optimization of reaction conditions resulted in an outstanding high space-time yield of 13.6 kgCH2O∙kgcat∙h−1.

Non-oxidative dehydrogenation of isobutane over supported vanadium oxide: nature of the active sites and coke formation

We combine Raman spectroscopy, EPR, XPS, temperature programmed reduction, XRD, ⁵¹V MAS ssNMR, TEM and N₂-physisorption to unravel structure–activity relationships during the non-oxidative dehydrogenation of isobutane over a V based catalyst.

Direct Visualization of Independent Ta Centers Supported on Two-Dimensional TiO2 Nanosheets

Highly dispersed, supported oxides are ubiquitous solid catalysts but can be challenging to characterize with atomic precision. Here, it is shown that crystalline anatase TiO₂ nanosheets (∼5 nm thick) are ideal supports for imaging highly dispersed active sites. Ta cations were deposited by several routes, and high-resolution high angle annular dark-field scanning transmission electron microscopy was used to determine the location of Ta with respect to the TiO₂ lattice and quantify Ta-Ta distances. In the best case, it is shown that >80% of Ta atoms are isolated from one another, whereas other techniques are blind to this critical catalytic property or give only qualitative estimates. TiO₂ nanosheets may prove to be a useful platform for other types of catalysis studies.

Nanoscale Structuring in Confined Geometries using Atomic Layer Deposition: Conformal Coating and Nanocavity Formation

Nanoscale structuring in confined geometries using atomic layer deposition (ALD) is demonstrated for surfaces of nanochannels in track-etched polymer membranes and in mesoporous silica (SBA-15). Suitable process conditions for conformal ALD coating of polymer membranes and SBA-15 with inorganic oxides (SiO2, TiO2, Al2O3) were developed. On the basis of the oxide-coated layers, nanochannels were further structured by a molecular-templated ALD approach, where calixarene macromolecules are covalently attached to the surface and then embedded into an Al2O3 layer. The removal of calixarene by ozone treatment results in 1–2 nm wide surface nanocavities. Surfaces exposed to different process steps are analyzed by small angle X-ray scattering (SAXS) as well as by X-ray photoelectron and infrared spectroscopy. The proposed nanostructuring process increases the overall surface area, allows controlling the hydrophilicity of the channel surface, and is of interest for studying water and ion transport in confinement.

Textural and morphology changes of mesoporous SBA-15 silica due to introduction of guest phase

The research focuses on study of guest phase effect on the surface area and pore volume of SBA-15 with the emphasis on elucidation of reasons for these changes. The changes of surface area and pore volume are evident from evaluated N2 adsorption isotherms of VOx-SBA-15 even for samples with relative low content of supported guest phase, which is “atomically” spread on the surface in the form of anchored monomeric vanadyl species. These species cannot block the pore with diameter of 10 nm, nevertheless the presence of such phase causes decrease in adsorbed nitrogen during physisorption. Comparison of guest phase amount with differences in adsorbed amount of nitrogen led to conclusion that each vanadyl complex prevents adsorption of about one or two N2 molecules in the layer and influences two adsorption layers. Significant pore blocking occurs in the VOx-SBA-15 materials only in the case of presence bulk oxide-like nanospecies. Re-structuralization of silica mimicking phase separation phenomena relying on spinodal decomposition of a system was observed by SEM/TEM analysis and adsorption isotherms inspection for materials with high vanadium content.

V2O5/SBA-15 nanocatalysts for the selective synthesis of 2,3,5-trimethyl-1,4-benzoquinone at room temperature

The molecular designed dispersion method yielded monodispersed nanoscale (4–7.5 nm sized) V₂O₅ dimeric species on SBA-15, which oxidized TMP into TMBQ with H₂O₂ under green conditions.

Raft localization of type I Fcε receptor and degranulation of RBL-2H3 cells exposed to decavanadate, a structural model for V2O5

Vanadium oxides (VOs) have been identified as low molecular weight sensitizing agents associated with occupational asthma and compromised pulmonary immunocompetence. Symptoms of adult onset asthma result, in part, from increased signal transduction by Type I Fcε receptors (FcεRI) leading to release of vasoactive compounds including histamine from mast cells. Exposure to (VOs) typically occurs in the form of particles which are insoluble. Upon contact with water or biological fluids, (VOs) form a series of soluble oxoanions, one of which is decavanadate, V10O28(6-) abbreviated V10, which is structurally related to a common vanadium oxide, that is vanadium pentoxide, V2O5. Here we investigate whether V10 may be initiating plasma membrane events associated with activation of FcεRI signal transduction. We show that exposure of RBL-2H3 cells to V10 causes a concentration-dependent increase in degranulation of RBL-2H3 and, in addition, an increase in plasma membrane lipid packing as measured by the fluorescent probe, di-4-ANEPPDHQ. V10 also increases FcεRI accumulation in low-density membrane fragments, i.e., lipid rafts, which may facilitate FcεRI signaling. To determine whether V10 effects on plasma membrane lipid packing were similarly observed in Langmuir monolayers formed from dipalmitoylphosphatidylcholine (DPPC), the extent of lipid packing in the presence and absence of V10 and vanadate was compared. V10 increased the surface area of DPPC Langmuir monolayers by 6% and vanadate decreased the surface area by 4%. These results are consistent with V10 interacting with this class of membrane lipids and altering DPPC packing.

Structural characterization of vanadium oxide catalysts supported on nanostructured silica SBA-15 using X-ray absorption spectroscopy

The local structure of vanadium oxide supported on nanostructured SiO2 (VxOy/SBA-15) was investigated by in situ X-ray absorption spectroscopy (XAS). Because the number of potential parameters in XAS data analysis often exceeds the number of "independent" parameters, evaluating the reliability and significance of a particular fitting procedure is mandatory. The number of independent parameters (Nyquist) may not be sufficient. Hence, in addition to the number of independent parameters, a novel approach to evaluate the significance of structural fitting parameters in XAS data analysis is introduced. Three samples with different V loadings (i.e. 2.7 wt %, 5.4 wt %, and 10.8 wt %) were employed. Thermal treatment in air at 623 K resulted in characteristic structural changes of the V oxide species. Independent of the V loading, the local structure around V centers in dehydrated VxOy/SBA-15 corresponded to an ordered arrangement of adjacent V2O7 units. Moreover, the V2O7 units were found to persist under selective oxidation reaction conditions.

Redox properties of vanadium ions in SBA-15-supported vanadium oxide: an FTIR spectroscopic study

The state of vanadium ions in VxOy/SBA-15 (2.7 wt % V) was studied with FTIR spectroscopy using CO and NO as probe molecules. Neither CO (at 85 K) nor NO (at RT) adsorb on the oxidized sample because of the coordinative saturation of V5+ ions and the covalent character of the V5+=O bond. After treatment of the sample in 50 kPa H2 at 673 K, the V5+ ions are reduced to two different types of V3+ sites, as manifested by carbonyl bands at 2189 and 2177 cm-1. In the presence of O2 at 85 K, thus formed V3+ ions are partly oxidized to V4+ sites showing carbonylic bands at 2202 and 2190 cm-1. When the reduced sample is exposed to O2 at room temperature, the V3+ ions are fully oxidized to V5+. The adsorption of NO on the reduced VxOy/SBA-15 shows that the V3+ and V4+ ions possess two effective coordinative vacancies and as a result can adsorb two NO molecules forming the respective V3+(NO)2 and V4+(NO)2 dinitrosyls. The introduction of O2 to the VxOy/SBA-15-NO system leads to reoxidation of the V3+ and V4+ ions to V5+ and formation of bridged (1639 cm-1) and bidentate (1573 cm-1) surface nitrates. After coadsorption of CO and NO on the reduced sample the formation of surface mixed carbonyl-nitrosyls (2108 and 1723 cm-1) was observed for the first time.