Singlet oxygen generation on porous superhydrophobic surfaces: effect of gas flow and sensitizer wetting on trapping efficiency

Singlet oxygen generation on a superhydrophobic surface: Effect of photosensitizer coating and incident wavelength on 1O2 yields

Photochemical generation of singlet oxygen (1O2) often relies on homogenous systems; however, a dissolved photosensitizer (PS) may be unsuitable for some applications because it is difficult to recover, expensive to replenish, and hazardous to the environment. Isolation of the PS onto a solid support can overcome these limitations, but implementation faces other challenges, including agglomeration of the solid PS, physical quenching of 1O2 by the support, photooxidation of the PS, and hypoxic environments. Here, we explore a superhydrophobic polydimethylsiloxane (SH-PDMS) support coated with the photosensitizer 5,10,15,20-tetrakis(pentafluorophenyl)-21H,23H-porphyrin (TFPP). This approach seeks to address the challenges of a heterogeneous system by using a support that exhibits low 1O2 physical quenching rates, a fluorinated PS that is chemically resistant to photooxidation, and a superhydrophobic surface that entraps a layer of air, thus preventing hypoxia. Absorbance and fluorescence spectroscopy reveal the monomeric arrangement of TFPP on SH-PDMS surfaces, a surprising but favorable characteristic for a solid-phase PS on 1O2 yields. We also investigated the effect of incident wavelength on 1O2 yields for TFPP in aqueous solution and immobilized on SH-PDMS and found overall yields to be dependent on the absorption coefficient, while the yield per absorbed photon exhibited wavelength independence, in accordance with Kasha-Vavilov's rule.

Superhydrophobic Tipped Antimicrobial Photodynamic Therapy Device for the In Vivo Treatment of Periodontitis Using a Wistar Rat Model

Limited options exist for treatment of periodontitis; scaling and root planing (SRP) are not sufficient to eradicate P. gingivalis and the resulting inflammatory disease. Chlorhexidine (CHX), used as an adjuvant to SRP, may reduce bacterial loads but leads to pain and staining, while evidence for its efficacy is lacking. Antibiotics are effective but can lead to drug-resistance. The rising concern of antibiotic resistance limits the future use of this treatment approach. This study evaluates the efficacy of a novel superhydrophobic (SH) antimicrobial photodynamic therapy (aPDT) device as an adjuvant to SRP for the treatment of periodontitis induced in a Wistar rat in vivo model relative to CHX. The SH-aPDT device comprises an SH silicone rubber strip coated with verteporfin photosensitizer (PS), sterilized, and secured onto a tapered plastic optical fiber tip connected to a red diode laser. The superhydrophobic polydimethylsiloxane (PDMS) strips were fabricated by using a novel soluble template method that creates a medical-grade elastomer with hierarchical surface roughness without the use of nanoparticles. Superhydrophobicity minimizes direct contact of the PS-coated surface with bacterial biofilms. Upon insertion of the device tip into the pocket and energizing the laser, the device generates singlet oxygen that effectively targets and eliminates bacteria within the periodontal pocket. SH-aPDT treatment using 125 J/cm2 of red light on three consecutive days reduced P. gingivalis significantly more than SRP-CHX controls (p < 0.05). Clinical parameters significantly improved (p < 0.05), and histology and stereometry results demonstrated SH-aPDT to be the most effective treatment for improving healing and reducing inflammation, with an increase in fibroblast cells and extracellular matrix and a reduction in vascularization, inflammatory cells, and COX-2 expression. The SH-aPDT approach resulted in complete disease clearance assessed 30 days after treatment initiation with significant reduction of the periodontal pocket and re-formation of the junctional epithelium at the enamel-cementum junction. PS isolation on a SH strip minimizes the potential for bacteria to develop resistance, where the treatment may be aided by the oxygen supply retained within the SH surface.

Evaluation of photosensitizer-containing superhydrophobic surfaces for the antibacterial treatment of periodontal biofilms

Antimicrobial photodynamic therapy (aPDT) is a promising approach to control biofilms involved in periodontal diseases. However, certain challenges, such as staining of teeth, preferential interaction of photosensitizer (PS) with Gram-positive versus Gram-negative bacteria, and insufficient oxygen in hypoxic periodontal pockets have presented barriers to its use in the clinic. To overcome these challenges, a novel superhydrophobic (SH) film that generates airborne singlet oxygen has been developed. The SH-aPDT approach isolates the PS onto a topologically rough solid SH film on which channels allow air to diffuse to the PS surface, thus ensuring sufficient oxygen supply. Upon illumination, gas phase singlet oxygen (¹O₂) is produced and diffuses from the SH surface to the underlying biofilm. The killing efficacy was assessed as a function of transmitted fluence (17.9-89.5 J/cm²) and chorin e6 loading (96-1110 nmol/cm²) by counting of colony forming units, biofilm metabolism by XTT and confocal microscopy. The decrease in viability of both Gram-positive and Gram-negative bacteria in a multi-species biofilm was found to be linearly dependent on the fluence as well as the loading of the PS up to 71.6 J/cm² when 1110 nmols/cm² of chlorin e6 was used. A > 4.6 log bacterial reduction was observed under these conditions (p < 0.05). This novel SH-aPDT approach shows promise as an effective method to disinfect multi-species bacterial biofilms associated with periodontal disease and will be evaluated in animal models in future studies.

Antimicrobial Photodynamic Inactivation Using Topical and Superhydrophobic Sensitizer Techniques: A Perspective from Diffusion in Biofilms†

This review describes nanoparticle and dye diffusion in bacterial biofilms in the context of antimicrobial photodynamic inactivation (aPDI). aPDI requires the diffusion of a photosensitizer (Sens) into the biofilm and subsequent photoactivation of oxygen for the generation of reactive oxygen species (ROS) that inactivate microbes. Molecular diffusion in biofilms has been long investigated, whereas this review is intended to draw a logical link between diffusion in biofilms and ROS, a combination that leads to the current state of aPDI and superhydrophobic aPDI (SH-aPDI). This review should be of interest to photochemists, photobiologists and researchers in material and antimicrobial sciences as is ties together conventional aPDI with the emerging subject of SH-aPDI.

A simple, inexpensive method for gas-phase singlet oxygen generation from sensitizer-impregnated filters: Potential application to bacteria/virus inactivation and pollutant degradation

Airborne infectious diseases such as the new Coronavirus 2019 (COVID-19) pose serious threat to human health. Indoor air pollution is a problem of global environmental concern as well. Singlet oxygen (¹O₂) is a reactive oxygen species that plays important role in bacteria/virus inactivation and pollutant degradation. In this study, we found that commercially available filters typically deployed in air purifier and air conditioning units, when impregnated with Rose Bengal (RB) as a ¹O₂ sensitizer, can be used for heterogeneous gas-phase generation of ¹O₂. It was confirmed that irradiation of the RB filter under oxygen gas stream produced ¹O₂, which was measured using furfuryl alcohol trapping method followed by HPLC analysis. It was also observed that the amount of ¹O₂ generated increases as the light intensity increased. Similarly, the sensitizer loading also positively influenced the ¹O₂ generation. The heterogeneous gas-phase generation of ¹O₂ can find potential applications in air purifier and air conditioning units for the purpose of bacteria/virus inactivation and/or pollutant degradation thereby improving indoor air quality.

Superwettability-Based Interfacial Chemical Reactions

Superwetting interfaces arising from the cooperation of surface energy and multiscale micro/nanostructures are extensively studied in biological systems. Fundamental understandings gained from biological interfaces boost the control of wettability under different dimensionalities, such as 2D surfaces, 1D fibers and channels, and 3D architectures, thus permitting manipulation of the transport physics of liquids, gases, and ions, which profoundly impacts chemical reactions and material fabrication. In this context, the progress of new chemistry based on superwetting interfaces is highlighted, beginning with mass transport dynamics, including liquid, gas, and ion transport. In the following sections, the impacts of the superwettability-mediated transport dynamics on chemical reactions and material fabrication is discussed. Superwettability science has greatly enhanced the efficiency of chemical reactions, including photocatalytic, bioelectronic, electrochemical, and organic catalytic reactions, by realizing efficient mass transport. For material fabrication, superwetting interfaces are pivotal in the manipulation of the transport and microfluidic dynamics of liquids on solid surfaces, leading to the spatially regulated growth of low-dimensional single-crystalline arrays and high-quality polymer films. Finally, a perspective on future directions is presented.

An enhanced enzymatic reaction using a triphase system based on superhydrophobic mesoporous nanowire arrays

Gaseous reactants play a key role in a wide range of biocatalytic reactions, however reaction kinetics are generally limited by the slow mass transport of gases (typically oxygen) in or through aqueous solutions. Inspired by the morphologies of natural non-wetting surfaces, herein we address this limitation by developing a triphase reaction system possessing a triphase gas-solid-liquid interface. As a proof of concept, we study the kinetics of glucose oxidase (GOx) catalyzed reactions using a triphase system fabricated by layering GOx upon superhydrophobic mesoporous ZnO nanowire arrays through which oxygen, needed for the enzymatic reaction, is supplied directly from the atmosphere to the liquid-solid interface. We find that the enzymatic reaction rate is enhanced by a factor of 30 over that obtained from a conventional diphase system where oxygen is supplied through and from the liquid. The triphase system offers the opportunity to develop high performance bioassay systems, serving as an enabling platform for addressing challenges posed by gas-deficit kinetics.

Superhydrophobic Photosensitizers: Airborne 1O2 Killing of an in Vitro Oral Biofilm at the Plastron Interface

Singlet oxygen is a potent agent for the selective killing of a wide range of harmful cells; however, current delivery methods pose significant obstacles to its widespread use as a treatment agent. Limitations include the need for photosensitizer proximity to tissue because of the short (3.5 μs) lifetime of singlet oxygen in contact with water; the strong optical absorption of the photosensitizer, which limits the penetration depth; and hypoxic environments that restrict the concentration of available oxygen. In this article, we describe a novel superhydrophobic singlet oxygen delivery device for the selective inactivation of bacterial biofilms. The device addresses the current limitations by: immobilizing photosensitizer molecules onto inert silica particles; embedding the photosensitizer-containing particles into the plastron (i.e. the fluid-free space within a superhydrophobic surface between the solid substrate and fluid layer); distributing the particles along an optically transparent substrate such that they can be uniformly illuminated; enabling the penetration of oxygen via the contiguous vapor space defined by the plastron; and stabilizing the superhydrophobic state while avoiding the direct contact of the sensitizer to biomaterials. In this way, singlet oxygen generated on the sensitizer-containing particles can diffuse across the plastron and kill bacteria even deep within the hypoxic periodontal pockets. For the first time, we demonstrate complete biofilm inactivation (>5 log killing) of Porphyromonas gingivalis, a bacterium implicated in periodontal disease using the superhydrophobic singlet oxygen delivery device. The biofilms were cultured on hydroxyapatite disks and exposed to active and control surfaces to assess the killing efficiency as monitored by colony counting and confocal microscopy. Two sensitizer particle types, a silicon phthalocyanine sol-gel and a chlorin e6 derivative covalently bound to fluorinated silica, were evaluated; the biofilm killing efficiency was found to correlate with the amount of singlet oxygen detected in separate trapping studies. Finally, we discuss the applications of such devices in the treatment of periodontitis.

Catalytic, self-cleaning surface with stable superhydrophobic properties: printed polydimethylsiloxane (PDMS) arrays embedded with TiO2 nanoparticles

Maintaining the long-term stability of superhydrophobic surfaces is challenging because of contamination from organic molecules and proteins that render the surface hydrophilic. Reactive oxygen species generated on a photocatalyst, such as TiO2, could mitigate this effect by oxidizing these contaminants. However, incorporation of such catalyst particles into a superhydrophobic surface is challenging because the particles become hydrophilic under UV exposure, causing the surface to transition to the Wenzel state. Here we show that a high concentration of hydrophilic TiO2 catalytic nanoparticles can be incorporated into a superhydrophobic surface by partially embedding the particles into a printed array of high aspect ratio polydimethylsiloxane posts. A stable Cassie state was maintained on these surfaces, even under UV irradiation, because of the significant degree of hierarchical roughness. By printing the surface on a porous support, oxygen could be flowed through the plastron, resulting in higher photooxidation rates relative to a static ambient. Rhodamine B and bovine serum albumin were photooxidized both in solution and after drying onto these TiO2-containing surfaces, and the effects of particle location and plastron gas composition were studied in static and flowing gas environments. This approach may prove useful for water purification, medical devices, and other applications where Cassie stability is required in the presence of organic compounds.