X-ray photoelectron spectroscopy analysis of gold surfaces after removal of thiolated DNA oligomers by ultraviolet/ozone treatment

SERS for Detection of Proteinuria: A Comparison of Gold, Silver, Al Tape, and Silicon Substrates for Identification of Elevated Protein Concentration in Urine

Excessive protein excretion in human urine is an early and sensitive marker of diabetic nephropathy and primary and secondary renal disease. Kidney problems, particularly chronic kidney disease, remain among the few growing causes of mortality in the world. Therefore, it is important to develop an efficient, expressive, and low-cost method for protein determination. Surface enhanced Raman spectroscopy (SERS) methods are potential candidates to achieve these criteria. In this paper, a SERS method was developed to distinguish patients with proteinuria from the healthy group. Commercial gold nanoparticles (AuNPs) with diameters of 60 nm and 100 nm, and silver nanoparticles (AgNPs) with a diameter of 100 nm were tested on the surface of four different substrates including silver and gold films, silicon, and aluminum tape. SERS spectra were acquired from 111 unique human urine samples prepared and measured for each of the seven different nanoparticle plus substrate combinations. Data analysis by the PCA-LDA algorithm and the ROC curves gave results for the diagnostic figures of merits. The best sensitivity, specificity, accuracy, and AUC were 0.91, 0.84, 0.88, and 0.94 for the set with 100 nm Au NPs on the silver substrate, respectively. Among the three metal substrates, the substrate with AuNPs and Al tape performed slightly worse than the other three substrates, and 100 nm gold nanoparticles on average produced better results than 60 nm gold nanoparticles. The 60 nm diameter AuNPs and silicon, which is about one order of magnitude more cost-effective than AuNPs and gold film, showed a relative performance close to the performance of 60 nm AuNPs and Au film (average AUC 0.88 (Si) vs. 0.89 (Au)). This is likely the first reported application of unmodified silicon in SERS substrates applied for direct detection of proteins in any biofluid, particularly in urine. These results position silicon and AuNPs@Si in particular as a perspective SERS substrate for direct urine analysis, including clinical diagnostics of proteinuria.

Designing Sites in Heterogeneous Catalysis: Are We Reaching Selectivities Competitive With Those of Homogeneous Catalysts?

A critical review of different prominent nanotechnologies adapted to catalysis is provided, with focus on how they contribute to the improvement of selectivity in heterogeneous catalysis. Ways to modify catalytic sites range from the use of the reversible or irreversible adsorption of molecular modifiers to the immobilization or tethering of homogeneous catalysts and the development of well-defined catalytic sites on solid surfaces. The latter covers methods for the dispersion of single-atom sites within solid supports as well as the use of complex nanostructures, and it includes the post-modification of materials via processes such as silylation and atomic layer deposition. All these methodologies exhibit both advantages and limitations, but all offer new avenues for the design of catalysts for specific applications. Because of the high cost of most nanotechnologies and the fact that the resulting materials may exhibit limited thermal or chemical stability, they may be best aimed at improving the selective synthesis of high value-added chemicals, to be incorporated in organic synthesis schemes, but other applications are being explored as well to address problems in energy production, for instance, and to design greener chemical processes. The details of each of these approaches are discussed, and representative examples are provided. We conclude with some general remarks on the future of this field.

Control of Potential Response to Small Biomolecules with Electrochemically Grafted Aryl-Based Monolayer in Field-Effect Transistor-Based Sensors

In this paper, we demonstrate the use of a monolayer film electrografted via diazonium chemistry for controlling the potential response of a field-effect transistor (FET)-based sensor. 4-Nitrobenzenediazonium salt is electrografted on an extended-Au-gate FET (EG-Au-FET) with or without using a radical scavenger by cyclic voltammetry (CV), resulting in the formation of a monolayer or multilayer. In particular, the surface coverage of the aryl-derivative monolayer on the Au gate electrode gradually increases with increasing number of potential cycles in CV. Here, Au exhibits a strong catalytic action, resulting in the oxidation of organic compounds. Uric acid is used as a low-molecular-weight biomolecule for interference. The denser the surface coverage of the grafted monolayer, the smaller the potential response of the EG-Au-FET because the redox reaction of uric acid with the Au gate surface is suppressed. On the other hand, the effect of the aryl-derivative multilayer on the suppression of the potential response was smaller than that of the monolayer because the electrogenerated aryl radicals did not react with the Au surface but with the grafted species, resulting in an exposed part of the Au surface among the grafted aryl molecules. Thus, a platform based on such a monolayer film electrografted via diazonium chemistry is suitable for controlling the potential response based on the interference of low-molecular-weight biomolecules in biosamples.

Self-assembled monolayer-assisted negative lithography

Self-assembled monolayers (SAMs) have been widely employed as etching resists in wet lithography systems to form patterns in which the ordered molecular packing of the SAM regions significantly delays the etchant attack. A generally accepted recognition is that the SAMs ability to resist etching is positively correlated to the quality of the surface-assembled structures, and a more ordered molecular packing would correspond to a better etching resistance. Such a classical belief is debated in the present work by providing an alternative SAM-assisted negative lithography where ordered SAM regions are etched more quickly than their disordered counterparts. This method features a unique photoirradiation-imprinted patterning process that simply consists of two steps: (1) UV irradiation on an OH-terminated SAM-modified gold surface through a photomask and (2) the subsequent immersion of the exposed substrate in an aqueous etching solution of N-bromosuccinimide/pyridine to develop a wet lithographic pattern. The entire experimental process reveals a finding from previous work that the etching rate on the UV-exposed regions with disordered molecular packing could be modulated to be slower than that in the unexposed well-defined SAM regions. Longer irradiation times would also revert the patterns from negative to positive. Thus, by merely using one kind of SAM-modified surface to provide both positive and negative micropatterns on gold layers, one could obtain flexible opportunities for high-resolution micro/nanofabrication resembling photolithography.

Oxygen attachment on alkanethiolate SAMs induced by low-energy electron irradiation

Reactions of (18)O2 with self-assembled monolayer (SAM) films of 1-dodecanethiol, 1-octadecanethiol, 1-butanethiol, and benzyl mercaptan chemisorbed on gold were studied by the electron stimulated desorption (ESD) of anionic fragments over the incident electron energy range 2-20 eV. Dosing the SAMs with (18)O2 at 50 K results in the ESD of (18)O(-) and (18)OH(-). Electron irradiation of samples prior to (18)O2 deposition demonstrates that intensity of subsequent (18)O(-) and (18)OH(-) desorption signals increase with electron fluence and that in the absence of electron preirradiation, no (18)O(-) and (18)OH(-) ESD signals are observed, since oxygen is unable to bind to the SAMs. A minimum incident electron energy of 6-7 eV is required to initiate the binding of (18)O2 to the SAMs. O2 binding is proposed to proceed by the formation of CHx-1(•) radicals via resonant dissociative electron attachment and nonresonant C-H dissociation processes. The weaker signals of (18)O(-) and (18)OH(-) from short-chain SAMs are related to the latter's resistance to electron-induced damage, due to the charge-image dipole quenching and electron delocalization. Comparison between the present results and those for DNA oligonucleotides self-assembled on Au (Mirsaleh-Kohan, N. et al. J. Chem. Phys. 2012, 136, 235104) indicates that the oxygen binding mechanism is common to both systems.

Removal of molecular adsorbates on gold nanoparticles using sodium borohydride in water

The mechanism of sodium borohydride removal of organothiols from gold nanoparticles (AuNPs) was studied using an experimental investigation and computational modeling. Organothiols and other AuNP surface adsorbates such as thiophene, adenine, rhodamine, small anions (Br(-) and I(-)), and a polymer (PVP, poly(N-vinylpyrrolidone)) can all be rapidly and completely removed from the AuNP surfaces. A computational study showed that hydride derived from sodium borohydride has a higher binding affinity to AuNPs than organothiols. Thus, it can displace organothiols and all the other adsorbates tested from AuNPs. Sodium borohydride may be used as a hazard-free, general-purpose detergent that should find utility in a variety of AuNP applications including catalysis, biosensing, surface enhanced Raman spectroscopy, and AuNP recycle and reuse.

Low energy electron stimulated desorption from DNA films dosed with oxygen

Desorption of anions stimulated by 1-18 eV electron impact on self-assembled monolayer (SAM) films of single DNA strands is measured as a function of film temperature (50-250 K). The SAMs, composed of 10 nucleotides, are dosed with O(2). The OH(-) desorption yields increase markedly with exposure to O(2) at 50 K and are further enhanced upon heating. In contrast, the desorption yields of O(-), attributable to dissociative electron attachment to trapped O(2) molecules decrease with heating. Irradiation of the DNA films prior to the deposition of O(2) shows that this surprising increase in OH(-) desorption, at elevated temperatures, arises from the reaction of O(2) with damaged DNA sites. These results thus appear to be a manifestation of the so-called "oxygen fixation" effect, well known in radiobiology.

Effect of morphology of thin DNA films on the electron stimulated desorption of anions

We present a comparison between the electron stimulated desorption (ESD) of anions from DNA samples prepared by lyophilization (an example of poorly organized or nonuniform films) and molecular self-assembly (well-ordered films). The lyophilization (or freeze- drying) method is perhaps the most frequently employed technique for forming DNA films for studies of low-energy electron (LEE) interactions leading to DNA damage; however, this technique usually produces nonuniform films with considerable clustering which may affect DNA configuration and enhance sample charging when the film is irradiated. Our results confirm the general validity of ESD measurements obtained with lyophilized samples, but also reveal limitations of lyophilization for LEE studies on DNA films. Specifically we observe some modulation of structures, associated with dissociative electron attachment, in the anion yield functions from different types of DNA film, confirming that conformational factors play a role in the LEE induced damage to DNA.