Comparison of LV mass and volume measurements derived from electron beam tomography using cine imaging and angiographic imaging

Left ventricular volume: an optimal parameter to detect systolic dysfunction on prospectively triggered 64-multidetector row computed tomography: another step towards reducing radiation exposure

In this study, we define the correlation between LV volumes (both LV end-diastolic volume [LVEDV] and LV end-systolic volume [LVESV]) and ejection fraction (EF) on 64 slice multi-detector computed tomography (MDCT). We also determine the accuracy of all the LV volume (LVV) parameters to detect LV systolic dysfunction (LVSD) and investigate the feasibility of using LVV as a surrogate of LVSD on prospectively gated imaging to prevent the radiation exposure of retrospective imaging. 568 patients undergoing 64-detector MDCT were divided into 2 groups: Group 1—subjects without any heart disease and LVEF ≥ 50%; and Group 2—patients with coronary artery disease and LVEF < 50% (defined as LVSD). The LVV (LV cavity only) and Total LV volume (cavity + LV mass) at end-systole and end-diastole (LVESV, Total LVESV, LVEDV and Total LVEDV) were measured. The upper limit values (mean + 2 SD) of all LVV parameters in Group 1 were used as the reference criterion to diagnose LVSD in Group 2. An exponential correlation was found between LVEF and all the LVV parameters. The specificity to detect LVSD in Group 2 was >90% and the sensitivity was 88.9, 83.3, 61.3 and 74.9% by using LVESV, Total LVESV, LVEDV and Total LVEDV, respectively. Systolic and diastolic LV volumes had a high correlation with LVEF and a high accuracy to detect LVSD. Thus, on prospectively triggered imaging, ventricular volumes can predict patients with reduced LVEF, and appropriate referrals can be made.

Simple area-based measurement for multidetector computed tomography to predict left ventricular size

OBJECTIVE

Measures of left ventricular (LV) mass and dimensions are independent predictors of morbidity and mortality. We determined whether an axial area-based method by computed tomography (CT) provides an accurate estimate of LV mass and volume.

METHOD

A total of 45 subjects (49% female, 56.0 +/- 12 years) with a wide range of LV geometry underwent contrast-enhanced 64-slice CT. LV mass and volume were derived from 3D data. 2D images were analysed to determine LV area, the direct transverse cardiac diameter (dTCD) and the cardiothoracic ratio (CTR). Furthermore, feasibility was confirmed in 100 Framingham Offspring Cohort subjects.

RESULTS

2D measures of LV area, dTCD and CTR were 47.3 +/- 8 cm(2), 14.7 +/- 1.5 cm and 0.54 +/- 0.05, respectively. 3D-derived LV volume (end-diastolic) and mass were 148.9 +/- 45 cm(3) and 124.2 +/- 34 g, respectively. Excellent inter- and intra-observer agreement were shown for 2D LV area measurements (both intraclass correlation coefficients (ICC) = 0.99, p < 0.0001) and could be confirmed on non-contrast CT. The measured 2D LV area was highly correlated to LV volume, mass and size (r = 0.68; r = 0.73; r = 0.82; all p < 0.0001, respectively). On the other hand, CTR was not correlated to LV volume, mass, size or 2D LV area (all p > 0.27).

CONCLUSION

Compared with traditionally used CTR, LV size can be accurately predicted based on a simple and highly reproducible axial LV area-based measurement.

Determination of left ventricular mass on cardiac computed tomographic angiography

RATIONALE AND OBJECTIVES

Left ventricular hypertrophy (LVH) is associated with an increased risk of cardiac death. The present study evaluates whether using computed tomographic (CT)-derived criteria for normal myocardial mass can improve detection of LVH on CT angiography (CTA).

MATERIALS AND METHODS

A total of 2238 subjects (63 +/- 9 years, 27% female) who underwent CTA were studied. To identify normal limits for CT-derived myocardial mass, we studied normal subjects (those without diabetes, hypertension, congestive heart failure, or coronary artery disease). Left ventricular mass (LVM) was measured manually using two different workstations. The CT criteria of LVH was defined as LVM above the 97th percentile per gender and compared to echocardiographic criteria (110 g/m(2) in women; 124 g/m(2) in men), and specificity and sensitivity of both models to detect LVH were calculated.

RESULTS

The LVM was higher in men than women in normal cohorts (75.5 +/- 14.0 vs. 63.1 +/- 12.8 g/m(2), P = .001 with electron beam CTA and 78.5 +/- 11.9 vs. 65.0 +/- 9.2 g/m(2), P = .001 with 64 multidetector [MD] CT, respectively). The coefficient of variation between electron beam CTA and 64 MDCT for measuring LVM was 3.1%. Comparing the new CTA/64 MDCT criteria of LVH (103.0 g/m(2) in men; 89.0 g/m(2) in women) to the previous echocardiographic criteria of LVH, the specificity in women and men decreased from 100% in both genders by echocardiography to 91.8% and 92.6%, respectively, but the sensitivity increased from 42.0% to 100% and from 41.1% to 100%.

CONCLUSION

This study suggests that CT-measured LVM has low variability and normal values based on CT criteria will potentially increase the early detection of LVH.

Comparison of MRI, 64-slice MDCT and DSCT in assessing functional cardiac parameters of a moving heart phantom

To compare magnetic resonance imaging (MRI), 64-slice multi-detector computed tomography (MDCT) and dual-source computed tomography (DSCT) in assessing global function parameters using a moving heart phantom. A moving heart phantom with known volumes (215–258 ml) moving at 50–100 beats per minute was examined by three different imaging modalities using clinically implemented scanning protocols. End-diastolic and end-systolic volumes were calculated by two experienced observers using dedicated post-processing tools. Ejection fraction (EF) and cardiac output (CO) were calculated and mutually compared using Bland-Altman plots. MRI underestimated the ejection EF by 16.1% with a Bland-Altman interval (B-A) of [-4.35 (-2.48) -0.60]. Sixty-four-slice MDCT overestimated the EF by 2.6% with a relatively wide B-A interval of [-3.40 (0.40) 4.20]. DSCT deviated the least from the known phantom volumes, underestimating the volumes by 0.8% with a B-A interval of [-1.17 (-0.13) 0.91]. CO analysis showed similar results. Furthermore, a good correlation was found between DSCT and MRI for EF and CO results. MRI systematically underestimates functional cardiac parameters, ejection fraction and cardiac output of a moving heart phantom. Sixty-four-slice MDCT underestimates or overestimates these functional parameters depending on the heart rate because of limited spatial resolution. DSCT deviates the least from these functional parameters compared to MRI, EBT and 64-slice MDCT.

Effects of steady state free precession parameters on cardiac mass, function, and volumes

PURPOSE

We aimed to investigate comparability of LV volumes, function, and mass acquired with three steady-state free precession (SSFP) pulse sequences, simulating typical vendor and protocol specific differences in data acquisition.

METHODS

Twenty-one healthy subjects (11 male and 10 female; age range 23-49) underwent cardiac magnetic resonance (CMR) imaging at 1.5 Tesla (T). A complete stack of short-axis views covering the entire left ventricle (LV) were acquired for each of the three SSFP sequences, differing in the interslice gap and slice thickness (7 mm with no gap (7/0 mm); 7 mm with a 3 mm gap (7/3 mm) and 6 mm with a 4 mm gap (6/4 mm)) with slight variations in acquisition parameters. For each sequence, the LV volumes, function, and mass were determined. Intra- and inter-observer variability and inter-study reproducibility were assessed for all protocols.

RESULTS

All LV volumes, function and mass parameters were similar for the three SSFP sequences (P > 0.05 for all). The LV ejection fraction for the 7/3 mm sequence was 67.2 +/- 6.0, 67.4 +/- 5.3 for the 7/0 mm sequence, and the 6/4 mm sequence was 69.2 +/- 5.7. The LV mass ranged from 119.8 +/- 32.4 for the 7/3 mm sequence to 122.2 +/- 34.0 for the 7/0 mm sequence. Variabilities were low with no difference in variability between the sequences.

CONCLUSION

The three SSFP pulse sequence techniques resulted in similar LV volume, function, and mass measurements with no difference in observer and interstudy variabilities. This may allow application and transfer of LV volume studies and databases based on different imaging parameters, at different CMR sites, with a given post-processing method. Future multi-centre studies may now be in a position to consider multi-vendor study designs for LV volume studies.

Multiphase contrast medium injection for optimization of computed tomographic coronary angiography

RATIONALE AND OBJECTIVES

Electron beam angiography is a minimally invasive imaging technique. Adequate vascular opacification throughout the study remains a critical issue for image quality. We hypothesized that vascular image opacification and uniformity of vascular enhancement between slices can be improved using multiphase contrast medium injection protocols.

MATERIALS AND METHODS

We enrolled 244 consecutive patients who were randomized to three different injection protocols: single-phase contrast medium injection (Group 1), dual-phase contrast medium injection with each phase at a different injection rate (Group 2), and a three-phase injection with two phases of contrast medium injection followed by a saline injection phase (Group 3). Parameters measured were aortic opacification based on Hounsfield units and uniformity of aortic enhancement at predetermined slices (locations from top [level 1] to base [level 60]).

RESULTS

In Group 1, contrast opacification differed across seven predetermined locations (scan levels: 1st versus 60th, P < .05), demonstrating significant nonuniformity. In Group 2, there was more uniform vascular enhancement, with no significant differences between the first 50 slices (P > .05). In Group 3, there was greater uniformity of vascular enhancement and higher mean Hounsfield units value across all 60 images, from the aortic root to the base of the heart (P < .05).

CONCLUSIONS

The three-phase injection protocol improved vascular opacification at the base of the heart, as well as uniformity of arterial enhancement throughout the study.

Coronary venous imaging with electron beam computed tomographic angiography: three-dimensional mapping and relationship with coronary arteries

BACKGROUND

The coronary venous system can provide vascular access for diagnostic and therapeutic procedures. Visualization of the coronary veins and their relationship to other cardiac structures may play an important role in facilitating these procedures. We sought to assess the ability of electron beam computed tomographic angiography (EBCTA) to characterize 3-dimensional (3-D) coronary venous anatomy.

METHODS

Two hundred thirty-one consecutive EBCTA coronary studies were analyzed. The coronary venous system was mapped and analyzed using 2- and 3-D images with definition of diameter and angulations of branch vessels and distance from CS os.

RESULTS

The coronary sinus (CS), great cardiac, middle cardiac, left ventricular (LV) anterior interventricular, LV marginal, LV posterior, left atrial, and right atrial veins were visualized in 100%, 100%, 100%, 100%, 78%, 81%, 6%, and 8% of the studies, respectively, with definition of diameter and angulations of branch vessels and distance from CS os. There was a significant linear correlation between CS diameter and right atrial end systolic volume (R = 0.244, n = 81, P < .05). No significant correlation existed between CS os diameter and other cardiac size or function parameters. The 3-D spatial arrangements between the coronary veins and the coronary arteries in relation to the epicardium were able to be defined, on the basis of the vessel closer to the epicardium in overlapping segments.

CONCLUSIONS

EBCTA can provide 3-D visualization of most components of the coronary venous system and definition of the spatial relationships with coronary arteries. EBCTA may potentially serve as a useful noninvasive tool for coronary venous imaging for procedures involving coronary veins, such as resynchronization therapy.

Detection of small vessels with electron beam computed tomographic angiography using 1.5 and 3 mm collimator protocols

OBJECTIVES

To evaluate the effect of scanner collimation on the ability to detect small cardiac vessels using electron beam CT coronary angiography (EBA).

MATERIALS AND METHODS

EBA scans from 40 patients who underwent study on two separate occasions with 3 mm (initial scan) and 1.5 mm (follow-up scan) collimation protocols were analyzed. Vessels of <2 mm in diameter were identified.

RESULTS

The 1.5 mm collimation allowed 3-D visualization of 129 vessels<2 mm in diameter, while 3 mm collimation only allowed visualization of 89 vessels (p<0.001). The right coronary artery branches and distal LAD segments though were not displayed satisfactorily in almost half of the 3-D studies with either protocol.

CONCLUSIONS

There was significant improvement in detection of small cardiac vessels with a 1.5 mm collimation EBA protocol compared to a 3 mm protocol. Both protocols though were insufficient for reliable visualization of the right coronary artery branches and distal LAD segments.