Subduction-related oxidation of the sublithospheric mantle evidenced by ferropericlase and magnesiowüstite diamond inclusions

Ferropericlase (Mg,Fe)O is the second most abundant mineral in Earth's lower mantle and a common inclusion found in subcratonic diamonds. Pyrolitic mantle has Mg# (100 × Mg/(Mg+Fe)) ~89. However, ferropericlase inclusions in diamonds show a broad range of Mg# between 12 and 93. Here we use Synchrotron Mössbauer Source (SMS) spectroscopy and single-crystal X-ray diffraction to determine the iron oxidation state and structure of two magnesiowüstite and three ferropericlase inclusions in diamonds from São Luiz, Brazil. Inclusion Mg#s vary between 16.1 and 84.5. Ferropericlase inclusions contain no ferric iron within the detection limit of SMS, while both magnesiowüstite inclusions show the presence of monocrystalline magnesioferrite ((Mg,Fe)Fe³⁺₂O₄) with an estimated 47-53 wt% Fe₂O₃. We argue that the wide range of Fe concentrations observed in (Mg,Fe)O inclusions in diamonds and the appearance of magnesioferrite result from oxidation of ferropericlase triggered by the introduction of subducted material into sublithospheric mantle.

Spin and valence dependence of iron partitioning in Earth's deep mantle

We performed laser-heated diamond anvil cell experiments combined with state-of-the-art electron microanalysis (focused ion beam and aberration-corrected transmission electron microscopy) to study the distribution and valence of iron in Earth's lower mantle as a function of depth and composition. Our data reconcile the apparently discrepant existing dataset, by clarifying the effects of spin (high/low) and valence (ferrous/ferric) states on iron partitioning in the deep mantle. In aluminum-bearing compositions relevant to Earth's mantle, iron concentration in silicates drops above 70 GPa before increasing up to 110 GPa with a minimum at 85 GPa; it then dramatically drops in the postperovskite stability field above 116 GPa. This compositional variation should strengthen the lowermost mantle between 1,800 km depth and 2,000 km depth, and weaken it between 2,000 km depth and the D" layer. The succession of layers could dynamically decouple the mantle above 2,000 km from the lowermost mantle, and provide a rheological basis for the stabilization and nonentrainment of large low-shear-velocity provinces below that depth.

Stability of Fe,Al-bearing bridgmanite in the lower mantle and synthesis of pure Fe-bridgmanite

The physical and chemical properties of Earth's mantle, as well as its dynamics and evolution, heavily depend on the phase composition of the region. On the basis of experiments in laser-heated diamond anvil cells, we demonstrate that Fe,Al-bearing bridgmanite (magnesium silicate perovskite) is stable to pressures over 120 GPa and temperatures above 3000 K. Ferric iron stabilizes Fe-rich bridgmanite such that we were able to synthesize pure iron bridgmanite at pressures between ~45 and 110 GPa. The compressibility of ferric iron-bearing bridgmanite is significantly different from any known bridgmanite, which has direct implications for the interpretation of seismic tomography data.

Natural dissociation of olivine to (Mg,Fe)SiO3 perovskite and magnesiowustite in a shocked Martian meteorite

We report evidence for the natural dissociation of olivine in a shergottite at high-pressure and high-temperature conditions induced by a dynamic event on Mars. Olivine (Fa(34-41)) adjacent to or entrained in the shock melt vein and melt pockets of Martian meteorite olivine-phyric shergottite Dar al Gani 735 dissociated into (Mg,Fe)SiO(3) perovskite (Pv)+magnesiowüstite (Mw), whereby perovskite partially vitrified during decompression. Transmission electron microscopy observations reveal that microtexture of olivine dissociation products evolves from lamellar to equigranular with increasing temperature at the same pressure condition. This is in accord with the observations of synthetic samples recovered from high-pressure and high-temperature experiments. Equigranular (Mg,Fe)SiO(3) Pv and Mw have 50-100 nm in diameter, and lamellar (Mg,Fe)SiO(3) Pv and Mw have approximately 20 and approximately 10 nm in thickness, respectively. Partitioning coefficient, K(Pv/Mw) = [FeO/MgO]/[FeO/MgO](Mw), between (Mg,Fe)SiO(3) Pv and Mw in equigranular and lamellar textures are approximately 0.15 and approximately 0.78, respectively. The dissociation of olivine implies that the pressure and temperature conditions recorded in the shock melt vein and melt pockets during the dynamic event were approximately 25 GPa but 700 °C at least.

Ab initio thermodynamics of MgSiO3 perovskite at high pressures and temperatures

Using quantum-mechanical simulations based on density-functional perturbation theory, we address the problem of stability of MgSiO3 perovskite to decomposition into MgO and SiO2 at pressures and temperatures of the Earth's lower mantle. We show that MgSiO3 perovskite (and its post-perovskite phase) is more stable than the mixture of oxides throughout the pressure-temperature regime of the Earth's mantle. Structural stability and lattice dynamics of phases in the system MgO-SiO2 are discussed.

Iron spin transition in Earth's mantle

High-pressure Mössbauer spectroscopy on several compositions across the (Mg,Fe)O magnesiowüstite solid solution confirms that ferrous iron (Fe(2+)) undergoes a high-spin to low-spin transition at pressures and for compositions relevant to the bulk of the Earth's mantle. High-resolution x-ray diffraction measurements document a volume change of 4-5% across the pressure-induced spin transition, which is thus expected to cause seismological anomalies in the lower mantle. The spin transition can lead to dissociation of Fe-bearing phases such as magnesiowüstite, and it reveals an unexpected richness in mineral properties and phase equilibria for the Earth's deep interior.

Spin transition of iron in magnesiowüstite in the Earth's lower mantle

Iron is the most abundant transition-metal element in the mantle and therefore plays an important role in the geochemistry and geodynamics of the Earth's interior. Pressure-induced electronic spin transitions of iron occur in magnesiowüstite, silicate perovskite and post-perovskite. Here we have studied the spin states of iron in magnesiowüstite and the isolated effects of the electronic transitions on the elasticity of magnesiowüstite with in situ X-ray emission spectroscopy and X-ray diffraction to pressures of the lowermost mantle. An observed high-spin to low-spin transition of iron in magnesiowüstite results in an abnormal compressional behaviour between the high-spin and the low-spin states. The high-pressure, low-spin state exhibits a much higher bulk modulus and bulk sound velocity than the low-pressure, high-spin state; the bulk modulus jumps by approximately 35 percent and bulk sound velocity increases by approximately 15 percent across the transition in (Mg0.83,Fe0.17)O. Although no significant density change is observed across the electronic transition, the jump in the sound velocities and the bulk modulus across the transition provides an additional explanation for the seismic wave heterogeneity in the lowermost mantle. The transition also affects current interpretations of the geophysical and geochemical models using extrapolated or calculated thermal equation-of-state data without considering the effects of the electronic transition.

The elasticity of the MgSiO3 post-perovskite phase in the Earth's lowermost mantle

MgSiO3 perovskite has been assumed to be the dominant component of the Earth's lower mantle, although this phase alone cannot explain the discontinuity in seismic velocities observed 200-300 km above the core-mantle boundary (the D" discontinuity) or the polarization anisotropy observed in the lowermost mantle. Experimental and theoretical studies that have attempted to attribute these phenomena to a phase transition in the perovskite phase have tended to simply confirm the stability of the perovskite phase. However, recent in situ X-ray diffraction measurements have revealed a transition to a 'post-perovskite' phase above 125 GPa and 2,500 K--conditions close to those at the D" discontinuity. Here we show the results of first-principles calculations of the structure, stability and elasticity of both phases at zero temperature. We find that the post-perovskite phase becomes the stable phase above 98 GPa, and may be responsible for the observed seismic discontinuity and anisotropy in the lowermost mantle. Although our ground-state calculations of the unit cell do not include the effects of temperature and minor elements, they do provide a consistent explanation for a number of properties of the D" layer.

Iron partitioning in Earth's mantle: toward a deep lower mantle discontinuity

We measured the spin state of iron in ferropericlase (Mg0.83Fe0.17)O at high pressure and found a high-spin to low-spin transition occurring in the 60- to 70-gigapascal pressure range, corresponding to depths of 2000 kilometers in Earth's lower mantle. This transition implies that the partition coefficient of iron between ferropericlase and magnesium silicate perovskite, the two main constituents of the lower mantle, may increase by several orders of magnitude, depleting the perovskite phase of its iron. The lower mantle may then be composed of two different layers. The upper layer would consist of a phase mixture with about equal partitioning of iron between magnesium silicate perovskite and ferropericlase, whereas the lower layer would consist of almost iron-free perovskite and iron-rich ferropericlase. This stratification is likely to have profound implications for the transport properties of Earth's lowermost mantle.

Stability of magnesiowustite in Earth's lower mantle

Magnesiowüstite [(Mg,Fe)O] is the second most abundant mineral of Earth's lower mantle. Understanding its stability under lower mantle conditions is crucial for interpreting the physical and chemical properties of the whole Earth. Previous studies in an externally heated diamond anvil cell suggested that magnesiowüstites decompose into two components, Fe-rich and Mg-rich magnesiowüstites at 86 GPa and 1,000 K. Here we report an in situ study of two magnesiowüstites [(Mg(0.39),Fe(0.61))O and (Mg(0.25),Fe(0.75))O] at pressures and temperatures that overlap with mantle conditions, using a laser-heated diamond anvil cell combined with synchrotron x-ray diffraction. Our results show that addition of Mg in wüstite (FeO) can stabilize the rock-salt structure to much higher pressures and temperatures. In contrast to the previous studies, our results indicate that Mg-rich magnesiowüstite is stable in the rock-salt structure in the lower mantle. The physical and chemical properties of magnesiowüstite should change gradually and continuously in the lower mantle, suggesting that it does not make a significant contribution to seismic-wave heterogeneity of the lower mantle. Stable Mg-rich magnesiowüstite in lowermost mantle can destabilize FeO in the core-mantle boundary region and remove FeO from the outer core.

Stability and structure of MgSiO3 perovskite to 2300-kilometer depth in Earth's mantle

Unexplained features have been observed seismically near the middle (approximately 1700-kilometer depth) and bottom of the Earth's lower mantle, and these could have important implications for the dynamics and evolution of the planet. (Mg,Fe)SiO3 perovskite is expected to be the dominant mineral in the deep mantle, but experimental results are discrepant regarding its stability and structure. Here we report in situ x-ray diffraction observations of (Mg,Fe)SiO3 perovskite at conditions (50 to 106 gigapascals, 1600 to 2400 kelvin) close to a mantle geotherm from three different starting materials, (Mg0.9Fe0.1)SiO enstatite, MgSiO3 glass, and an MgO+SiO2 mixture. Our results confirm the stability of (Mg,Fe)SiO3 perovskite to at least 2300-kilometer depth in the mantle. However, diffraction patterns above 83 gigapascals and 1700 kelvin (1900-kilometer depth) cannot presently rule out a possible transformation from Pbnm perovskite to one of three other possible perovskite structures with space group P2(1)/m, Pmmn, or P4(2)/nmc.