Single-photon detection using high-temperature superconductors

Single-photon detection using large-scale high-temperature MgB2 sensors at 20 K

Ultra-fast single-photon detectors with high current density and operating temperature can benefit space and ground applications, including quantum optical communication systems, lightweight cryogenics for space crafts, and medical use. Here we demonstrate magnesium diboride (MgB2) thin-film superconducting microwires capable of single-photon detection at 1.55  μm optical wavelength. We used helium ions to alter the properties of MgB2, resulting in microwire-based detectors exhibiting single-photon sensitivity across a broad temperature range of up to 20 K, and detection efficiency saturation for 1  μm wide microwires at 3.7 K. Linearity of detection rate vs incident power was preserved up to at least 100 Mcps. Despite the large active area of up to 400 × 400 μm2, the reset time was found to be as low as ~ 1 ns. Our research provides possibilities for breaking the operating temperature limit and maximum single-pixel count rate, expanding the detector area, and raises inquiries about the fundamental mechanisms of single-photon detection in high-critical-temperature superconductors.

Optically Probing Unconventional Superconductivity in Atomically Thin Bi2Sr2Ca0.92Y0.08Cu2O8+δ

Atomically thin cuprates exhibiting a superconducting phase transition temperature similar to that of the bulk have recently been realized, although the device fabrication remains a challenge and limits the potential for many novel studies and applications. Here, we use an optical pump-probe approach to noninvasively study the unconventional superconductivity in atomically thin Bi2Sr2Ca0.92Y0.08Cu2O8+δ (Y-Bi2212). Apart from finding an optical response due to the superconducting phase transition that is similar to that of bulk Y-Bi2212, we observe that the sign and amplitude of the pump-probe signal in atomically thin flakes vary significantly in different dielectric environments depending on the nature of the optical excitation. By exploiting the spatial resolution of the optical probe, we uncover the exceptional sensitivity of monolayer Y-Bi2212 to the environment. Our results provide the first optical evidence for the intralayer nature of the superconducting condensate in Bi2212 and highlight the role of double-sided encapsulation in preserving superconductivity in atomically thin cuprates.

Fundamental Limits of Few-Layer NbSe2 Microbolometers at Terahertz Frequencies

The rapid development of infrared spectroscopy, observational astronomy, and scanning near-field microscopy has been enabled by the emergence of sensitive mid- and far-infrared photodetectors. Superconducting hot-electron bolometers (HEBs), known for their exceptional signal-to-noise ratio and fast photoresponse, play a crucial role in these applications. While superconducting HEBs are traditionally crafted from sputtered thin films such as NbN, the potential of layered van der Waals (vdW) superconductors is untapped at THz frequencies. Here, we introduce superconducting HEBs made from few-layer NbSe2 microwires. By improving the interface between NbSe2 and metal leads, we overcome impedance mismatch with RF readout, enabling large responsivity THz detection (0.13 to 2.5 THz) with a minimal noise equivalent power of 7 pW/ H z and nanosecond-range response time. Our work highlights NbSe2 as a promising platform for HEB technology and presents a reliable vdW assembly protocol for custom bolometer production.

Multilayer Bolometric Structures for Efficient Wideband Communication Signal Reception

It is known that the dielectric layer (resonator) located behind the conducting plate of the bolometer system can significantly increase its sensitivity near the resonance frequencies. In this paper, the possibility of receiving broadband electromagnetic signals in a multilayer bolometric meta-material made of alternating conducting (e.g., silicon semiconductor) and dielectric layers is demonstrated both experimentally and numerically. It is shown that such a multilayer structure acts as a lattice of resonators and can significantly increase the width of the frequency band of efficient electromagnetic energy absorption. The parameters of the dielectric and semiconductor layers determine the frequency bands. Numerical modeling of the effect has been carried out under the conditions of our experiment. The numerical results show acceptable qualitative agreement with the experimental data. This study develops the previously proposed technique of resonant absorption of electromagnetic signals in bolometric structures.

2D High-Temperature Superconductor Integration in Contact Printed Circuit Boards

Inherent properties of superconducting Bi2Sr2CaCu2O8+x films, such as the high superconducting transition temperature Tc, efficient Josephson coupling between neighboring CuO layers, and fast quasiparticle relaxation dynamics, make them a promising platform for advances in quantum computing and communication technologies. However, preserving two-dimensional superconductivity during device fabrication is an outstanding experimental challenge because of the fast degradation of the superconducting properties of two-dimensional flakes when they are exposed to moisture, organic solvents, and heat. Herein, to realize superconducting devices utilizing two-dimensional (2D) superconducting films, we develop a novel fabrication technique relying on the cryogenic dry transfer of printable circuits embedded into a silicon nitride membrane. This approach separates the circuit fabrication stage requiring chemically reactive substances and ionizing physical processes from the creation of the thin superconducting structures. Apart from providing electrical contacts in a single transfer step, the membrane encapsulates the surface of the crystal, shielding it from the environment. The fabricated atomically thin Bi2Sr2CaCu2O8+x-based devices show a high superconducting transition temperature of Tc ≃ 91 K close to that of the bulk crystal and demonstrate stable superconducting properties.

Mobile superconducting strip photon detection system with efficiency over 70% at a 1550 nm wavelength

We developed a mobile superconducting strip photon detector (SSPD) system operated in a liquid-helium Dewar. By adopting highly disordered NbTiN thin films, we successfully enhanced the detection performance of superconducting strips at higher operation temperatures and realized SSPDs with nearly saturated detection efficiency at 4.2 K. Then we customized a compact liquid-helium Dewar and a battery-based electronic module to minimize the SSPD system. A mobile SSPD system was integrated, which showed a system detection efficiency of 72% for a 1550 nm wavelength with a dark count rate of 200 cps and a timing jitter of 67.2 ps. The system has a weight of 40 kg and a power consumption of 500 mW, which can work continuously for 20 hours. The metrics can be further optimized in accordance with the various practical application platforms, such as aircraft, drones, etc.

Prominent Josephson tunneling between twisted single copper oxide planes of Bi2Sr2-xLaxCuO6+y

Josephson tunneling in twisted cuprate junctions provides a litmus test for the pairing symmetry, which is fundamental for understanding the microscopic mechanism of high temperature superconductivity. This issue is rekindled by experimental advances in van der Waals stacking and the proposal of an emergent d+id-wave. So far, all experiments have been carried out on Bi2Sr2CaCu2O8+x (Bi-2212) with double CuO2 planes but show controversial results. Here, we investigate junctions made of Bi2Sr2-xLaxCuO6+y (Bi-2201) with single CuO2 planes. Our on-site cold stacking technique ensures uncompromised crystalline quality and stoichiometry at the interface. Junctions with carefully calibrated twist angles around 45° show strong Josephson tunneling and conventional temperature dependence. Furthermore, we observe standard Fraunhofer diffraction patterns and integer Fiske steps in a junction with a twist angle of 45.0±0.2°. Together, these results pose strong constraints on the d or d+id-wave pairing and suggest an indispensable isotropic pairing component.