Reduced graphene oxide on silicon-based structure as novel broadband photodetector

Recent Progress of 2D Materials-Based Photodetectors from UV to THz Waves: Principles, Materials, and Applications

Photodetectors are one of the most critical components for future optoelectronic systems and it undergoes significant advancements to meet the growing demands of diverse applications spanning the spectrum from ultraviolet (UV) to terahertz (THz). 2D materials are very attractive for photodetector applications because of their distinct optical and electrical properties. The atomic-thin structure, high carrier mobility, low van der Waals (vdWs) interaction between layers, relatively narrower bandgap engineered through engineering, and significant absorption coefficient significantly benefit the chip-scale production and integration of 2D materials-based photodetectors. The extremely sensitive detection at ambient temperature with ultra-fast capabilities is made possible with the adaptability of 2D materials. Here, the recent progress of photodetectors based on 2D materials, covering the spectrum from UV to THz is reported. In this report, the interaction of light with 2D materials is first deliberated on in terms of optical physics. Then, various mechanisms on which detectors work, important performance parameters, important and fruitful fabrication methods, fundamental optical properties of 2D materials, various types of 2D materials-based detectors, different strategies to improve performance, and important applications of photodetectors are discussed.

Development and characterization of self-powered, highly sensitive optoelectronic device based on PVA-rGO nanofibers/n-Si

This study provided a promising way to fabricate low-cost and high-performance Poly (vinyl alcohol)-reduced graphene oxide (PVA-RGO) nanofibers/n-Si heterojunction photodetector. For this purpose, the hybrid heterojunction with a very-high rectification ratio (2.4 × 106) was achieved by successfully coating PVA-RGO nanofibers on n-Si wafer by electrospinning method. When the electro-optical analysis of the fabricated heterojunction photodetector under visible light depending on the light intensity, ultraviolet (UV) and infrared (IR) lights was examined in detail, it was observed that the photodetector exhibited both self-powered behavior and very high photo-response under each light sources. However, the highest optical performance was obtained under UV (365 nm) originated from PVA-RGO layer and IR (850 nm) light from both interfacial states between PVA-RGO nanofibers and Si and from Si layer. Under 365 nm UV light, the maximum performance values of R, D, ON/OFF ratio, normalized photo-dark-current ratio and external quantum efficiency (%) were obtained as 688 mA W-1, 1.15 × 1015Jones, 2.49 × 106, 8.28 × 1010W-1and 234%, respectively.

Role of oxygen functional groups and attachment of Au nanoparticles on graphene oxide sheets for improved photodetection performance

Integrating low-dimensional graphene oxide (GO) with conventional Si technology offers innovative strategies for developing ultrafast wideband photodetectors. In this study, we synthesized GO and explored its potential application in broadband photodetection alongside silicon heterostructures. The as-synthesized GO contains various oxygen functional groups, as evidenced by X-ray photoelectron and Fourier transform infrared spectroscopy. These functional groups contribute to increased photo absorption, enhancing photodetection performance. The systematic reduction of these functional groups from the GO surface via thermal annealing decreases photo absorption and consequently lowers the photocurrent. This reduction diminishes photo absorption and amplifies the dark current by approximately 25 times, from 20 nA to 496 nA. This dark current increase is attributed to the electron mobility following the reduction of functional groups. However, attaching plasmonic gold nanoparticles (Au NPs) to the GO surface enhances UV-Vis absorption in the visible region, enabling broadband detection. The even distribution of attached Au NPs on the GO surface is confirmed through field emission transmission electron microscopy. While thermal annealing of GO diminishes the responsivity from 4.6 A W-1 to 3.0 A W-1, the attachment of Au NPs augments the responsivity by more than two-fold, reaching 10.0 A W-1. Thus, it highlights the importance of rich oxygen functional groups in GO and the attachment of Au NPs to achieve more efficient photo-sensing properties.

Sunlight-driven photocatalytic degradation of ciprofloxacin and organic dyes by biosynthesized rGO-ZrO2 nanocomposites

Aquatic ecology has been greatly threatened by the discharge of effluents of textile and antibiotic industries into natural waters. Herein, an efficient and easily recycled reduced graphene oxide/zirconium oxide nanocomposite has been synthesized using banana peel extract (abbreviated as rGO-ZrO₂ in this work). The X-ray diffraction (XRD), field emission scanning electronic microscopy (FESEM), high-resolution transmission electron microscopy (HRTEM), Brunauer-Emmett-Teller (BET), UV-visible diffuse reflectance spectroscopy (DRS), X-ray photoelectron spectroscopy (XPS), and Fourier transform infrared (FTIR) spectroscopy were used to analyze the synthesized material. The as-prepared rGO-ZrO₂ nanocomposite was employed as a photocatalyst for the decomposition of rhodamine blue (RhB) and crystal violet (CV) dyes, and ciprofloxacin (CIP) antibiotic by illumination with direct sunlight. The RhB and CV were degraded to maximum extent of around 86 and 90%, respectively, over the rGO-ZrO₂ nanocomposite after exposure to direct sunlight for 120 min. On the other hand, the degradation of CIP was approximately 93.1% over the rGO-ZrO₂ nanocomposite in 240 min under same experimental conditions. Further studies were performed regarding the role of parameters like pH, catalyst dose, and scavengers, in order to understand the superiority of rGO-ZrO₂ nanocomposite in degrading organic pollutants. Moreover, the intermediate products and plausible CIP degradation mechanisms were examined using liquid chromatography-mass spectrometry (LC-MS). Moreover, the catalyst was easily separated from the solution and demonstrated good stability and reusability. The RhB, CV, and CIP removal efficiency were 80%, 83%, and 88%, respectively, after five cycles.

Temperature dependence of electrical conductivity and variable hopping range mechanism on graphene oxide films

The rapid development of optoelectronic applications for optical-to-electrical conversion has increased the interest in graphene oxide material. Here, graphene oxide films (GOF) were used as source material in an infrared photodetector configuration and the temperature dependence of the electrical conductivity was studied. GOF were prepared by the double-thermal decomposition (DTD) method at 973 K, with a fixed carbonization temperature, in a pyrolysis system, under a controlled nitrogen atmosphere, over quartz substrates. Graphene oxide films were mechanically supported in a photodetector configuration on Bakelite substrates and electrically contacted with copper wires and high-purity silver paint. Morphological images from the GOF's surface were taken employing a scanning electron microscope and observed a homogeneous surface which favored the electrical contacts deposition. Vibrational characteristics were studied employing Raman spectroscopy and determined the typical graphene oxide bands. GOF were used to discuss the effect of temperature on the film's electrical conductivity. Current-voltage (I-V) curves were taken for several temperatures varying from 20 to 300 K and the electrical resistance values were obtained from 142.86 to 2.14 kΩ. The GOF electrical conductivity and bandgap energy (E_g) were calculated, and it was found that when increasing temperature, the electrical conductivity increased from 30.33 to 2023.97 S/m, similar to a semiconductor material, and E_g shows a nonlinear change from 0.33 to 0.12 eV, with the increasing temperature. Conduction mechanism was described mainly by three-dimensional variable range hopping (3D VRH). Additionally, measurements of voltage and electrical resistance, as a function of wavelength were considered, for a spectral range between 1300 and 3000 nm. It was evidenced that as the wavelength becomes longer, a greater number of free electrons are generated, which contributes to the electrical current. The external quantum efficiency (EQE) was determined for this proposed photodetector prototype, obtaining a value of 40%, similar to those reported for commercial semiconductor photodetectors. This study provides a groundwork for further development of graphene oxide films with high conductivity in large-scale preparation.

Mechanisms of NO2 Detection in Hybrid Structures Containing Reduced Graphene Oxide: A Review

The sensitive detection of harmful gases, in particular nitrogen dioxide, is very important for our health and environment protection. Therefore, many papers on sensor materials used for NO₂ detection have been published in recent years. Materials based on graphene and reduced graphene oxide deserve special attention, as they exhibit excellent sensor properties compared to the other materials. In this paper, we present the most recent advances in rGO hybrid materials developed for NO₂ detection. We discuss their properties and, in particular, the mechanism of their interaction with NO₂. We also present current problems occuring in this field.

Plasmon-enhanced reduced graphene oxide photodetector with monometallic of Au and Ag nanoparticles at VIS-NIR region

Hybrids plasmonic nanoparticles (NPs) and unique 2D graphene significantly enhanced the photoresponse of the photodetectors. The metallic NPs that exhibit localized surface plasmon resonance (LSPR) improves strong light absorption, scattering and localized electromagnetic field by the incident photons depending on the optimum condition of NPs. We report high-performance photodetectors based on reduced graphene oxide (rGO) integrated with monometallic of Au and Ag nanoparticles via a familiar fabrication technique using an electron beam evaporation machine. Under 680 nm illumination of light, our rGO photodetector exhibited the highest performance for Au-rGO with the highest responsivity of 67.46 AW^-1 and the highest specific detectivity (2.39 × 10¹³ Jones). Meanwhile, Ag-rGO achieved the highest responsivity of 17.23 AW^-1, specific detectivity (7.17 × 10¹¹ Jones) at 785 nm. The response time are 0.146 µs and 0.135 µs for Au-rGO and Ag-rGO respectively for both wavelengths. The proposed photodetector with combining monometallic and graphene provide a new strategy to construct reliable and next-generation optoelectronic devices at VIS-NIR region.