Correlation between the Cation Disorders of Fe3+ and Li+ in P3-Type Na0.67[Li0.1(Fe0.5Mn0.5)0.9]O2 for Sodium Ion Batteries

Various Fe-based layered oxide materials have received attention as promising cathode materials for sodium ion batteries because of their low cost and high specific capacity. Only a few P3-type Fe-based oxide materials, however, have been examined as cathodes because the synthesis of highly crystalline P3-type Fe-based oxides is not facile. For this reason, the structural merits of the P3 structure are not yet fully understood. Herein, highly crystalline P3-type Na0.67[Li0.1(Fe0.5Mn0.5)0.9]O2 heated at 900 °C is introduced to improve the electrochemical performance of Fe-based layered oxides. The structures, reaction mechanisms, and electrochemical performances of P3 Na0.67[Li0.1(Fe0.5Mn0.5)0.9]O2, P2 Na0.57[Li0.1(Fe0.5Mn0.5)0.9]O2, and P2 Na0.67[Fe0.5Mn0.5]O2 are compared to demonstrate the roles of Li+ doping in the improved electrochemical performance of P3 Na0.67[Li0.1(Fe0.5Mn0.5)0.9]O2, such as stable capacity retention over 100 cycles. P3 Na0.67[Li0.1(Fe0.5Mn0.5)0.9]O2 significantly suppresses the migration of Fe3+ ions to tetrahedral sites in the Na layer during cycling because the cation disorder of Li+ is more favorable than that of Fe3+. As a result, P3 Na0.67[Li0.1(Fe0.5Mn0.5)0.9]O2 shows better cycle performance than P2 Na0.67[Fe0.5Mn0.5]O2. P3 Na0.67[Li0.1(Fe0.5Mn0.5)0.9]O2 also exhibits an improved rate performance compared to P2 Na0.67[Fe0.5Mn0.5]O2. This finding provides fundamental insights to improve the electrochemical performance of layered oxide cathode materials for sodium ion batteries.

A laboratory-based hard x-ray monochromator for high-resolution x-ray emission spectroscopy and x-ray absorption near edge structure measurements

We report the development of a laboratory-based Rowland-circle monochromator that incorporates a low power x-ray (bremsstrahlung) tube source, a spherically bent crystal analyzer, and an energy-resolving solid-state detector. This relatively inexpensive, introductory level instrument achieves 1-eV energy resolution for photon energies of ∼5 keV to ∼10 keV while also demonstrating a net efficiency previously seen only in laboratory monochromators having much coarser energy resolution. Despite the use of only a compact, air-cooled 10 W x-ray tube, we find count rates for nonresonant x-ray emission spectroscopy comparable to those achieved at monochromatized spectroscopy beamlines at synchrotron light sources. For x-ray absorption near edge structure, the monochromatized flux is small (due to the use of a low-powered x-ray generator) but still useful for routine transmission-mode studies of concentrated samples. These results indicate that upgrading to a standard commercial high-power line-focused x-ray tube or rotating anode x-ray generator would result in monochromatized fluxes of order 10(6)-10(7) photons/s with no loss in energy resolution. This work establishes core technical capabilities for a rejuvenation of laboratory-based hard x-ray spectroscopies that could have special relevance for contemporary research on catalytic or electrical energy storage systems using transition-metal, lanthanide, or noble-metal active species.